Physics for Scientists and Engineers with Modern Physics
10th Edition
ISBN: 9781337553292
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 31, Problem 44AP
To determine
The reason for which the given situation is impossible for the experiment.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
A battery of emf E is connected in series with a resistor, an inductor L, and a switch S. A capacitor C is connected in parallel to the inductor. When the switch is left in the closed position for a long time, the potential difference across the
capacitor is zero. The switch is opened and the maximum potential difference across the capacitor is measured to be 140 V. Determine the capacitance of the capacitor if E = 60 V, R = 125 N, and L = 54.0 mH.
ww
R
A fully-charged capacitor with
C = 113nF is connected in series with a
resistor (w/ R = 867N) and an inductor
(w/ L = 158mH). What is the frequency
(in kHz) of the underdamped oscillation?
A 2.2 Henry inductor and a 177Ω resistor are connected in series with a 24V battery. A long time later the battery is removed from the circuit and replaced with a conducting wire so the inductor is in series with the resistor. After 10.716 ms have gone by what is the magnitude of the current through the resistor in mA?
Chapter 31 Solutions
Physics for Scientists and Engineers with Modern Physics
Ch. 31.1 - A coil with zero resistance has its ends labeled a...Ch. 31.2 - Prob. 31.2QQCh. 31.3 - Prob. 31.3QQCh. 31.4 - Prob. 31.4QQCh. 31.5 - (i) At an instant of time during the oscillations...Ch. 31 - Prob. 1PCh. 31 - Prob. 2PCh. 31 - Prob. 3PCh. 31 - Prob. 4PCh. 31 - Prob. 5P
Ch. 31 - A toroid has a major radius R and a minor radius r...Ch. 31 - Prob. 7PCh. 31 - Prob. 8PCh. 31 - Prob. 9PCh. 31 - Prob. 10PCh. 31 - Prob. 11PCh. 31 - Prob. 12PCh. 31 - Prob. 13PCh. 31 - You are working as a demonstration assistant for a...Ch. 31 - Prob. 15PCh. 31 - Prob. 16PCh. 31 - Prob. 17PCh. 31 - Prob. 18PCh. 31 - Prob. 19PCh. 31 - Prob. 20PCh. 31 - Prob. 21PCh. 31 - Prob. 22PCh. 31 - Prob. 23PCh. 31 - Prob. 24PCh. 31 - Prob. 25PCh. 31 - Prob. 26PCh. 31 - Prob. 27PCh. 31 - Prob. 28PCh. 31 - In the circuit of Figure P31.29, the battery emf...Ch. 31 - Prob. 30PCh. 31 - Prob. 31PCh. 31 - Prob. 32PCh. 31 - In Figure 31.15, let R = 7.60 , L = 2.20 mH, and C...Ch. 31 - Prob. 34PCh. 31 - Electrical oscillations are initiated in a series...Ch. 31 - Prob. 36APCh. 31 - A capacitor in a series LC circuit has an initial...Ch. 31 - Prob. 38APCh. 31 - Prob. 39APCh. 31 - At the moment t = 0, a 24.0-V battery is connected...Ch. 31 - Prob. 41APCh. 31 - Prob. 42APCh. 31 - Prob. 43APCh. 31 - Prob. 44APCh. 31 - Prob. 45APCh. 31 - At t = 0, the open switch in Figure P31.46 is...Ch. 31 - Prob. 47APCh. 31 - Prob. 48APCh. 31 - Prob. 49APCh. 31 - Prob. 50CPCh. 31 - Prob. 51CPCh. 31 - Prob. 52CPCh. 31 - Prob. 53CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- An RLC circuit consists of a 1.34 2 resistor, a 8.44 nF capacitor, and a 5.55 mH inductor. Initially, the voltage across the capacitor is 1.46 V, and no current is flowing in the circuit. How many oscillations occur as the charge amplitude on the capacitor decays to 67.4% of its initial value? It is acceptable to let w' = w. i oscillations (include decimals if needed to keep the appropriate number of significant digits in your answer)arrow_forwardAn RLC circuit consists of a 46.3 2 resistor, a 2.47 µF capacitor, and a 4.16 mH inductor. Initially, the voltage across the capacitor is 3.08 V, and no current is flowing in the circuit. How many oscillations occur as the charge amplitude on the capacitor decays to 10.3 × 106 of its initial value? It is not acceptable to let w' = @. i oscillations (include decimals if needed to keep the appropriate number of significant digits)arrow_forwardA 6.54 H inductor and a 85.4 ohm resistor are connected in series and the circuit is connected to a 14.8 V battery. What is the magnitude of the voltage across the inductor 2.65 ms after being connected to the battery?arrow_forward
- After you disconnect the DC power supply from an RLC circuit, it oscillates at a frequency of f. Then you remake the circuit with the same inductor and capacitor but now with 2 resistors in series instead of just one, so that the new circuit has twice the resistance. Despite the resistance having doubled, the circuit can still be said to be underdamped. What is the new oscillation frequency that you observe when you power the new circuit from the DC power supply and disconnect it? O less than f impossible to say without knowing whether the inductance is bigger or smaller than the resistance exactly equal to f greater than farrow_forwardA battery is used to charge a capacitor. When the stored energy in the capacitor is 1 µj, it is disconnected from the battery in the circuit and connected in series with an inductor which has inductance of 6 µH. What is the current in the inductor when the capacitor charge is half of its initial maximum value? (Resistance is negligible.) O 0.2 A O 0.5 A O v2 A O 2 A O 20 Aarrow_forwardA circuit consists of a 0.8 H inductor and a 3.5 ohm resistor. At t = 0 the current through the inductor is 1.2 A. How much energy is stored in the inductor at this instant?arrow_forward
- a 12.0 V ideal battery, a 20.0 resistor, and an inductor are connected by a switch at time t = 0. At what rate is the battery transferring energy to the inductor’s field at t = 1.61tL?arrow_forwardcharge and the current (i) is zero, then P= 0. If q =0 at time t =0, then =±n/2. Example: A 300-V dc power supply is used to charge a 25-µF capacitor. After the capacitor is fully charged, it is disconnected from the power supply and connected across a 10-mH inductor. The resistance in the circuit is negligible. (a) Find the frequency and period of oscillation of the circuit. (b) Find the capacitor charge and the circuit current 1.2 ms after the inductor and capacitor are connected. Then find for the magnetic and electric energies (c) at and (d) at t = 1.2 ms. Given: C = 25 x 106 F L = 10 x 103 H t = 1.2 x 103 s (c) Solving for magnetic (UB) and electric (UE) energies at time t =0. Solution: (7.5 x 10-3 C)? (a) Solving for angular frequency (w)and period (T) Ug =Li? = 0 Ug = 2C - 1.1 J 2(25 x 10-6 F) 1 = 2.03 x 10° rad/s (10 x 10-3H)(25 x 10¬°F) (d) Solving for magnetic (UB) and electric (UE) energies at time t =1.2 ms. 2. 03 х 103 Рad Ug = }Li² = }(10 × 10-3 H)(-10 A)² = 0.5 J f = 320…arrow_forwardA charged capacitor and an inductor are connected in series. At time t = 0 the current is zero, but the capacitor is charged. If T is the period of the resulting oscillations, the next time after t = 0 that the current is a maximum is ?arrow_forward
- A resistor of resistance R = 10 Ω is connected in series with an inductor of L = 15 mH. The RL combination is connected to a variable voltage power supply (V = 4.5 V) by a switch as shown. a. What is the time constant (τ) of the combination in seconds? b. The power supply is set to maintain a constant voltage of V = 4.5 V and the switch is closed. Calculate the current, in amperes, through the circuit at t = 0.29 ms after the switch is closed. c. Calculate the current through the circuit, in amperes, after the switch has been closed for a long time.arrow_forwardA circuit consists of a 0.80 H inductor and a 3.5 ohm resistor. At t = 0 the current through the inductor is 1.2 A. At what time is the current through the inductor equal to 0.40 A?arrow_forwardYour latest invention is an alarm that produces sound at a particularly annoying frequency of 3493 H z. To do this, the alarm circuitry must produce an alternating electric current of the same frequency. That's why your design includes an inductor and a capacitor in series. The maximum voltage across the capacitor is to be 4V. To produce a sufficiently loud sound, the capacitor must store 0.016J of energy. What value of inductance (in µH) should you choose for your alarm circuit?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning