Concept explainers
Assume the circuit shown in Figure 17-2 has a power factor of 78%, an apparent power of 374.817 VA, and a frequency of 400 Hz. The inductor has an inductance of 0.0382 H.
Want to see the full answer?
Check out a sample textbook solutionChapter 17 Solutions
Delmar's Standard Textbook Of Electricity
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?arrow_forwardAn inductor is attached to an AC voltage source. Which change will result in a halving of the current?A. Halving the voltage and doubling the frequencyB. Doubling the frequencyC. Halving the frequencyD. Doubling the voltage and halving the frequencyarrow_forwardassume that the circuit shown in figure 17-2 is connected to a 480 v 60 hz line. the inductor has an inductance of 0.053 H and the resistor has a resistance of 12 ohmasarrow_forward
- When a capacitor is discharged through a resistor, the discharge curve is exponential Sinusoidal Step Squarearrow_forwardassume the circuit shown in figure 17-2 has a power factor of 78% an apparent power of 374.817 VA and a frequency of 400 Hz. the inductor has an inductance of 0.0382 H.arrow_forwardFor the resistor shown above what best describes its behavior at 1 MHz? It responds primarily as a resistor It responds primarily as a capacitor O It responds primarily as a inductor It responds primarily as a transformerarrow_forward
- An rms voltage of 22.2 V with a frequencyof 1.00 kHz is applied to a 0.290-mH inductor. (a) What is the rmscurrent in this circuit? (b) By what factor does the current changeif the frequency of the voltage is doubled? (c) Calculate the current for a frequency of 2.00 kHzarrow_forwardIdentify which measurement this oscilloscope time difference reading is useful for. Oscilloscope-XSC1 Channel_B Channel_A 169.064 V 113.590 V -55.474 V Time T1 Reverse 250.000 us 89.282 V 122.375 V 33.093 V T2 382.576 us T2-T1 132.576 us Save Ext. trigger Timebase Scale: 200 us/Div X pos. (Div): 0 Channel A Scale: 100 V/Div Y pos. (Div): 0 Channel B Trigger Scale: 100 V/Div Y pos. (Div): 0 Edge: f 2 AB Ext Level: Y/T Add B/A A/B AC0 DC AC0 DC Single Normal Auto None O none of the above O phase shift O periodarrow_forwardPls. write solution neatlyarrow_forward
- A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?arrow_forwardA four stage Marx multistage impulse generator has 0.1 micro Farad capacitors in each stage. The wave front and wave tail resistances are 20 Ohm and 800 Ohm respectively. If the load capacitance is 1 micro Farad, What will be the values of following quantities? Wave tail time Generator capacitance Wave front timearrow_forwardWhat is the maximum recommended limit of RMS voltage (in percent) for continuous operation of shunt capacitors under contingency condition? 110 120 O 130 135 0000arrow_forward
- Delmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningElectricity for Refrigeration, Heating, and Air C...Mechanical EngineeringISBN:9781337399128Author:Russell E. SmithPublisher:Cengage LearningPower System Analysis and Design (MindTap Course ...Electrical EngineeringISBN:9781305632134Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. SarmaPublisher:Cengage Learning