Whether the shape of the proeutectic phase affects the strength of eutectic alloys or not should be explained. Concept Introduction: When the melting and solidifying of same or homogeneous substances occur at a single temperature, then the system is known as the Eutectic system. The melting temperature of any single substance is greater than the eutectic temperature. Eutectoids transformation occurs when a solution above the transformation point is available in the solid state instead of the liquid state. The eutectic reaction is formed at the thermal equilibrium. Hence, it is also called Invariant reaction. By using Gibbs Energy is equal to zero equation, we can determine the temperature Proeutectoid alloy: In addition of the solid and liquid regions, before reachingthe eutectic temperature; the alloys which are on the left side (known as hypoeutectic) and on the right side (known as hypereutectic) form a new phase which is called as Proeutectoid Phase.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 11.45P

Interpretation Introduction

Interpretation:

Whether the shape of the proeutectic phase affects the strength of eutectic alloys or not should be explained.

Concept Introduction:

When the melting and solidifying of same or homogeneous substances occur at a single temperature, then the system is known as the Eutectic system. The melting temperature of any single substance is greater than the eutectic temperature.

Eutectoids transformation occurs when a solution above the transformation point is available in the solid state instead of the liquid state.

The eutectic reaction is formed at the thermal equilibrium. Hence, it is also called Invariant reaction. By using Gibbs Energy is equal to zero equation, we can determine the temperature

Proeutectoid alloy:

In addition of the solid and liquid regions, before reachingthe eutectic temperature; the alloys which are on the left side (known as hypoeutectic) and on the right side (known as hypereutectic) form a new phase which is called as Proeutectoid Phase.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

OK i need help. Please help me work thorought this with autocad. I am not sure where to begin but i need to draw this. Well if you read the question we did it in class and I got suepr confsued.

Write a C program using embedded assembler with a function to convert a digit (0 – 15) to the corresponding ASCII character representing the value in hexadecimal. For numbers 0 – 9, the output will be the characters '0' – '9', for numbers 10 – 15 the characters 'A' – 'F'. The entire core of the program must be written in symbolic instruction language; arrays may not be used. You may only use C to print the result. Tip: This piece of C program will do the same thing: character = number < 10 ? number + '0' : number + 55; As a basis, you can use this program again , which increments a variable. Just replace the INC instruction with ADD and add a test (CMP) with some conditional jump.

A square column foundation has to carry a gross allowable load of 2005 kN (FS = 3). Given: D₤ = 1.7 m, y = 15.9 kN/m³, 0' = 34°, and c' = 0. Use Terzaghi's equation to determine the size of the foundation (B). Assume general shear failure. For o' = 34°, N₁ 36.5 and Ny = 38.04. (Enter your answer to three significant figures.) B=2.16 m