The principles of green chemistry that matches for new process compared to older process has to be given. Concept introduction: Green chemistry: The utilization of a set of principles that reduces or eliminates the use or generation of hazardous substances in the design, manufacture and the application of chemical products. The new procedure applies all of these principles either to a greater or lesser extent. It is better to prevent waste than to treat or clean up waste after it is formed. Synthetic methods should be designed to maximize the incorporation of all materials used in the final product. Synthetic method should be designed to use and generate substances that possess little or no toxicity to human health or the environment. Chemical products should be designed to function effectively while still reducing toxicity. Synthetic methods should be conducted at ambient temperature and pressure. Raw materials should be renewable whenever technically and economically practical. Chemical products should be designed so that at the end of their function, they do not persist in the environmental or break down into dangerous products. Substances used in a chemical process should be chosen to minimize the potential for chemical accidents, including releases, explosions, and fires.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1, Problem 6PS

Interpretation Introduction

Interpretation:

The principles of green chemistry that matches for new process compared to older process has to be given.

Concept introduction:

Green chemistry:

The utilization of a set of principles that reduces or eliminates the use or generation of hazardous substances in the design, manufacture and the application of chemical products.

The new procedure applies all of these principles either to a greater or lesser extent.

It is better to prevent waste than to treat or clean up waste after it is formed.

Synthetic methods should be designed to maximize the incorporation of all materials used in the final product.

Synthetic method should be designed to use and generate substances that possess little or no toxicity to human health or the environment.

Chemical products should be designed to function effectively while still reducing toxicity.

Synthetic methods should be conducted at ambient temperature and pressure.

Raw materials should be renewable whenever technically and economically practical.

Chemical products should be designed so that at the end of their function, they do not persist in the environmental or break down into dangerous products.

Substances used in a chemical process should be chosen to minimize the potential for chemical accidents, including releases, explosions, and fires.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Concrete is prepared by roasting the mineral calcium carbonate, CaCO3, to drive off CO2 and produce calcium oxide, CaO. The chemical equation for this reaction is: CaCO3 ==> CaO + CO2 The Grand Coulee Dam on the Columbia River in Washington State was built using a volume of concrete of approximately 1.0 x 107 m3. If concrete has a density of 2.4 x 103 kg/m3, and assuming concrete is 100% by volume CaO, how much CO2 was released producing the concrete used to build the dam?

Suppose you are hired by the Environmental Protection Agency as an engineer to measure sulfur dioxide (SO2) emissions in a small industrial power plant. And suppose you analyze a gas sample and get the following composition: 75.66% N2, 10.24% CO2, 8.27% H2O, 5.75% O2, and 0.0825% SO2. You show these figures to the factory clerk the next day, and he insists that this analysis is erroneous and states that the fuel is natural gas, contains methane and ethane and does not contain sulfur. You ask if another fuel is used, and sometimes they say they use fuel as fuel, but at the time of analysis they say that this fuel is not used. However, your measurements show that the enterprise is using fuel at the time of measurement, and the responsible person accepts this later and accepts that they have made mistakes.a) Calculate the molar ratio of carbon / hydrogen in the fuel and use the result to prove that the fuel cannot be natural gas.b) Assuming that C, H and S are the elements present in the…

ebixoiC 4 During the production of ammonia, hydrogen is produced from the steam reforming of methane. In the reformer methane gas is reacted with excess water and the resulting mixture is found to contain 12 kg of hydrogen and 15 kg water. Assuming all the methane is reacted calculate the amount of water used.