0 09a jo2536 kW078 ptlagging24 kWV DV ms085 ptlaggingFor the three phase circuit shown, if V= 209, the power factor of the loadsis:O A 0209 laggingOB.0.808 laggingOC0718 laggingO D.0.923 laggingO E0.064 laggingOF. None

For the 3- phase circuit , to find the power factor of the load

ww- 24 kW 085 pt lagging 36 kW VEVms 078 pt lagging For the three phase cireuit shown, if F- 209, the power factor of the loads is; O A0209 lagging OB0a08 lagging OCO718 agging O D.0923 lagging O EOB64 lagging OF. None

ww- 24 kW 085 pt lagging 36 kW VEVms 078 pt lagging For the three phase cireuit shown, if F- 209, the power factor of the loads is; O A0209 lagging OB0a08 lagging OCO718 agging O D.0923 lagging O EOB64 lagging OF. None

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A load has a power factor of 0.82 pf lag. Which of the following must be true for this load? I. it…

Q: Suppose you have a three-phase generator that provides 120 V per phase and works at a frequency of…

A: Here we discuss the concept of power & power factor.

Q: A given load takes 40 KVA at 50% lagging power factor, while another load connected in parallel…

A: In this question we need to find the apparent power of the combined load.

Q: For the circuit shown. If the peak voltage V, -120 L 20 V, X = 4.Y=2, and Z = 4. Answer the…

Q: 8. Two impedances, Z, = 0.8 + j5.6 Q and Zz = 8 - j16 Q, and a single-phase mot are connected in…

A: In this question we will find complex power for each impedance and total current and total power…

Q: A. 87.45% B. 80.69% C. 89.49% D. 94.76% 39. Three impedances Za 6 20°0, Z, 8. 40°Q and Z. 10. 0°n…

A: In this question balanced star connected system is given...We have to find out current in line b...

Q: in the following circuit the complex power by each phase is 0.1+ j0.22 + (),1+ j0.22 480V rms b B…

A: Complex power/Apparent Power: The product of Voltage(v) and current(I) in the circuit is called as…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 300, through a…

A: Given load impedance, ZL=40-j30° On comparing with ZL=R-jXC

Q: Two single-phase loads are connected in parallel. The first load is SOMVA with 0.8 lagging power…

A: The solution is given below

Q: ll Iş Vs 20020°V_ L, rms

A: Statement- Energy can neither be created nor be destroyed, it can be only transformed from one form…

Q: A 250V rms system is supplying three parallel loads. One draws 20 kW at unity power factor, a second…

Q: all V R sine sine Let the voltage source be 202135, the current source be 10245 and the impedance of…

A: In this question, We need to determine the value of resistance R if angle of current flow in this…

Q: a ZA ZA bo ZA The circuit shown is excited by a balance three phase source. 357 V and 55 phase…

A: convert star connection in to ∆ connection;Zy in ∆=3Zy in starZy∆=3×4+j6Ω=12+j18ΩZ∆ is parallel with…

Q: A load absorbs 20 kVA at a lagging power factor of 0.6. The complex power is: Select one: O a. 20000…

Q: ) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total complex power…

A: In the circuit a) Find the ICA load current. b) Give the line voltage Vab. c) Calculate the total…

Q: A Z load draws 12kVA from a 120 V-rms sinusoidal source with a back power factor of 0.85. Find the…

Q: Find the rms value of I0 in the unbalanced three-phase circuit shown.

A: Applying KCL at node n

Q: Question No. 9 The average power delivered to an impedance (4-j3) by a current 5 cos(100nt + 100) A…

A: Given- Impedance, Z=4-j3 Ω. Current, I=5 cos100πt+100 A. To find- The average power delivered.

Q: In the circuit in the figure; L1 load draws 15 kVA with lagging power factor 0.6. The L2 load draws…

Q: A symmetrical three-phase, 440 V supply fed a mesh connected load as follows: Load AB: 20 KW at 0.69…

A: The Given is, 440V supply; Load AB: 20KW at power factor of 0.69 lag; Load BC: 25KVA at power factor…

Q: A Z load draws 10kVA from a 120 V-rms sinusoidal source with a back power factor of 0.8. Find the…

A: Given that Although fromula of real power or average power is given by

Q: Two balanced loads are connected to the a 240kVrms 60Hz line as shown in the figure below. Load 1…

Q: j 20 ll a b 100/20° V -j 5 2 Figure 04 Q4. (a) Find the Thevenin equivalent circuit looking from the…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: A balanced Delta-connected system consists of a phase voltage of 320V RMS and a load of 10068'.…

Q: An equation for the fault current when a line-to-line fault occurs ,…

Q: A load of 40 -j 30 is connected to a source of 100 V with a phase angle of 30°, through a…

A: Given data : Load impedance ZL=40-30j Source Voltage Vs=100∠30° inductive reactance XL=60Ω

Q: ell Iş V. 20020°V L L rms +

Q: Calculate the currents I1, I2 and I0, as well as the active power supplied to the load secondary sid

A: Considering vueltas as turns N1 = 200 turns N2 = 80 turns

Q: Find the load current IAB b) Find the line voltage Vbc c) Calculate the total complex power on the…

A: ) Find the load current IAB b) Find the line voltage Vbc c) Calculate the total complex power on the…

Q: Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of…

A: In delta connection line voltage is equal to phase voltage.

Q: If a Load absorbs 20 kVA at a leading power factor of 0.6. Then the complex power is: Select one: a.…

Q: Efficiency Calcuate the load power out in MW. POUT = MW Calcuate the input power to the generator in…

A: In this question we need to find the following Load power Power input to generator Efficiency of…

Q: A 15-kv, 35-kVA 076PF laggny 50H2 four Pole y-connected Steaw- turbine genevuty has a Synchronons…

Q: Answer the following 1-)What is the resistance and tolerance of a resistor with…

A: According to the question, 1-)What is the resistance and tolerance of a resistor with a…

Q: The following loads are served by a balanced three-phase source: Load 1: 18 kVA at 0.8 pf lagging…

A: load 3

Q: A single phase circuit is supplying the two loads, Load1 draws a real power of 450 kW at a power…

A: From power triangle KVA S=Active power (P)power factor(cosθ). and KVA S =…

Q: The apparent power in a three-phase balanced circuit is 150 VA, and the active power is 100 W. What…

A: Given, Apparent power, S=150 VA Active power, P=100 W

Q: + 120/45° V rms B

Q: in three phase it has been found that a negative sequence and zero sequence are absent what do you…

A: In a three phase power system , when A single line to ground fault occurs,there is no negative or…

Q: Sum of scattering angles in Laboratory coordinate system is always equal to * О 2п O None of them Ο…

A: sum of scattering angles in laboratory coordinate system

Q: suministrada a la carga. 11020° Vrms | 9-j6 140L-120° Vrms 9-562 110 420° Vims 9-J6R

Question

0 09a jo25
36 kW
078 pt
lagging
24 kW
V DV ms
085 pt
lagging
For the three phase circuit shown, if V= 209, the power factor of the loads
is:
O A 0209 lagging
OB.0.808 lagging
OC0718 lagging
O D.0.923 lagging
O E0.064 lagging
OF. None

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Single Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A load of 240 +j 120 is connected to a source of 240 V with a phase angle of 300, through a transmission line with an inductive reactance of 60 ohms. A Capacitor bank of a capacitive reactance of 120 ohms is connected in parallel to the load. The power factor at the load is: O A. 0.447 lagging O B. 0.707 leading O C. 0.447 leading O D. 0.707 lagging O E. None of choices are correct
QUESTION 6 Find the total real power dissipation in a balanced wye-delta system. Load impedance is 5kN270° and phase voltage is 320V RMS O 63W 99W 150W 36W
a) Find the load current IABb) Find the line voltage Vbcc) Calculate the total complex power on the loads.
A 415 V, 58 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of resistance 17 ohm and impedance 81 ohm. Find the value of inductance in each phase. O 8.00 79.20 O 40.50 O 0.22
Calculate the current phasor I0 and the phase voltage Van at the load Thank you
QUESTION 4 a) The single-line diagram of a three-phase system is shown in figure below. The manufacturer's nominal ratings are given as in table below. Using the common base S, = 60 MVA, draw the impedance diagram in per unit including the load impedance. Voltage base for buses 1, 2, and 3 is 120kV. Transmission lines 1, 2, and 3 have the reactance of 502, 40 2, and 302, respectively. Bus 0 Bus 2 Component S (VA) v (kV) Line 1 X G2 G1 48 MVA 20 kV 22% G2 30 MVA 15 kV 17% Line 2 Line 3 T1 50 MVA 20/110 kV 9% Bus 3 T2 35 MVA 15/110 kV 5% T3 50 MVA 11/110 KV 12% Bus Load
A Synchronous Motor taking 40kW is working in parallel with a load of 80kW having a power factor of 0.75 lagging. The power factor of the combined load os 0.9 lagging. Find the power factor and the reactive KVA of the motor
Given at the load: Vioond = 452-25° VRMS, 452-25° VRMS, Iload What are the real and reactive power and power factor at the load? Exclude the units. real power: reactive power: power factor: Iload-10-25 ARMS what type of impedance is seen at the load? R. L. or Ch
A single phase circuit is supplying the two loads, Load1 draws a real power of 350 kW at a unity power factor and Load 2 draws reactive power of 15 kvar at a power factor of 0.74 leading. Find the Apparent power of the Load 1 and Load2.Apparent power of Load1 kVA?Answer for part 1 Apparent power of the load 2 kVA ?
Suppose you have a three-phase generator that provides 120 Vac per phase and works at a frequency of 60 Hz, this generator can be connected in both delta and star. Also consider the following 6 load impedances, which will be connected at the same time to the generator as follows: ZA, ZB and Zc are connected in star, while Zp, Zg and Zp are connected in delta. j20 j3n Za j20 ZA j30 j3n -j20 j 30 -j20 Zo -j20 ZE j30 -j2n j 3n. ZF Assume the generator is star-connected with neutral, calculate total system power, total power factor, and current in neutral.
Solve it please fast
2. For the following system shown in the figure, calculate: a. The current through each phase of the load. b. The total real and reactive power of the three-phase load. c. The power factor at the load side. A 220 V 20° 220VL-120° U8 vol 152 I 220 VI20° 9. M.