Which of the following statements is .14 ?incorrect Number of theoretical plates decreases .with increasing plate height Retention factor (k) directly proportional .to distribution coefficient (K) Large distribution coefficients of an analyte indicates that it will be retained .longer in the column .Selectivity factor always equal 1 The longer the time of separation, the .broader the zone (band) will be

Which of the following statements is .14 ?incorrect Number of theoretical plates decreases .with increasing plate height Retention factor (k) directly proportional .to distribution coefficient (K) Large distribution coefficients of an analyte indicates that it will be retained .longer in the column .Selectivity factor always equal 1 The longer the time of separation, the .broader the zone (band) will be

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

In the table below, record the color that you observe for each spot or component of each spot after the run is completed. For the retention factor, R₁, write in the numerator (top) the number of mm that the spot has moved and in the denominator (bottom) the number of mm that the solvent has moved from the point where the samples were 'spotted. Calculate the Rf vale for each spot or component of each spot. Im having a difficult time finding the Retention Factor for M&Ms by using Salt water and seeing how much each color moves Instructions Coffee filters usually are round, but it's easier to compare your results if the paper is rectangular. So, your first task is to cut the coffee filter into a rectangle. Measure and cut a 2-3/4" by 7" strip from the middle of a coffee filter. This is easily done by folding the filter in half (to make a half-circle) and then folding the half-circle into thirds. Cut along the 13-fold lines and trim the ends to make a rectangle. 2. Using a pencil (ink from…
The figure below shows a typical separation of several fat-soluble vitamins by HPLC. The x-axis is retention time in minutes. From the graph try to estimate retention times for peaks 2 and 3. Retention time peak 2 = Retention time peak 3 = Assume that w1/2 is 0.15 minutes for peak 2 and 0.16 minutes for peak 3. Assume that tm is 2.00 minutes. How much time does gamma-tocopherol spend in the stationary phase? From tr and w1/2 find N for the peak that elutes first. From tr and w1/2 find the resolution of peaks 2 and 3 Calculate α for these peaks. If the flow rate for the column is 1.2 mL/minute what is the retention volume for peak 4?
The following statements are true for any chromatographic analysis except: The analyte component interacting most strongly with the stationary phase elute faster than those with weaker interactions. On the other hand, those with least interaction with the mobile phase elute the slowest. Interactions between mobile phase-analyte - stationary phase can be both chemical and physical in nature. Chromatography is a separation technique. Electromagnetic radiation source for XPS. Gamma ray X-ray UV-Visible Infra red Radiowave The part of SEM that is responsible for the production of electrons. * Electron guns Condenser lens Secondary detector Electron beam
which of the folowing(s) is/are true ? 1 split ratio in GC is a ratio of sample passed to column to amount of mobile phashe 2 column resolution decreases with increasing column lenght 3 decreasing the tube diameter ,increases the resolution
I'm working on a pre-lab report for chemistry regarding retention factors. The question asks what is the maximum distance the indicator band will travel? Is the indicator band sometimes referred to as the indictor spot?
A 20-cm long packed column was used to perform the separation of A and B by LC. TRA=16.28 min, TR,B=17.50 min, WA=1.11 min, WB=1.19 min, tм=1.30 min. (a) Calculate the retention factor (k') for A and B. (b) Calculate the average number of theoretical plates and plate height.
Consider the following chromatographic data for the separation of methylparaben from ethylparaben in a sunscreen sample. Compound Methylparaben Retention time, tr (min). Width at base of peak, Wb (min) 3.2 4.2 0.55 0.60 Ethylparaben A compound not retained by the column in this analysis had a tm of 0.75 minutes. The column used was a C18 column with a mobile phase mixture of 75% methanol and 25% water. Calculate the number of theoretical plates for ethylparaben.
What is the underlying principle used in chiral chromatography to separate components of an analyte?