do fast The force P is applied to the 60-kg block when it is at rest. Determine the magnitude and direction of the friction force exerted by thesurface on the block if (a) P=0, (b) P = 177 N, and (c) P=261 N. (d) What value of P is required to initiate motion up the incline? Thestatic and kinetic coefficients of friction between the block and the incline are μs = 0.18 and μk = 0.12, respectively. The friction force ispositive if up the incline, negative if down the incline.Answers:60 kg15°11°ருP, 0.18P=0.12(a) F =69.3(b) F=i-63.8PNN

Answered: Image /qna-images/answer/8a77d8ac-fa17-46f1-bb45-e4603ff7df5d.jpg

Answered: The force P is applied to the 60-kg…

Practical Management Science

6th Edition

ISBN:9781337406659

Author:WINSTON, Wayne L.

Publisher:WINSTON, Wayne L.

Chapter10: Introduction To Simulation Modeling

Section: Chapter Questions

Problem 41P: At the beginning of each week, a machine is in one of four conditions: 1 = excellent; 2 = good; 3 =...

See similar textbooks

Similar questions

1m radius disk is moving on the inclined surface under no slip condition. the center of the disk has 3m/s velocity and according to the figure, bar BC is pinned to the disk at point C and point B always stays on the ground. 1) find angular velocity of BC. 2) find angular acceleration of BC
do fast
Water entering the curved pipe at A is discharged at D. The pipe is rotating about A at the constant angular velocity omega=7 rad/s, and the water has a constant speed of v=19 m/s relative to the pipe. Now fill in the blanks below with correct numbers. Αγω သ B 0.54 m r = 0.18 m The magnitude of acceleration of the water just before it is discharged at D= m/s^2 0.30 m
do fast
T = -25°C A 0.5 m × 1 m double paned window is made of two silica glass panes 1 cm thick, with air in between. Under steady conditions, linear (constant gradient) Outdoors temperature profiles are found in both silica panes, as well as the air. If the room (and the inner surface of h=18Wm²K the inner glass pane) is at a temperature of 25°C, while outdoors it is -25°C with a convection coefficient of 18 W m² K-1, what is the rate of heat loss through the window? What is the rate of heat loss if the room temperature is decreased to 20°C? Finally, what is the rate of heat loss for a room temperature of 25°C, but with one of the panes (and the air) removed? 1 cm 1 cm Room Temperature, 25° C or 20º C 0.5 mm Air, k=0.024 W m¹ K¹ Silica glass, k = 0.90 W m³ K
The 180-mm disk is at rest when it is placed in contact with a belt moving at a constant speed. Neglecting the weight of the link AB and knowing that the coefficient of kinetic friction between the disk and the belt is 0.44, determine the angular acceleration of the disk while slipping occurs. 180 mm K 60° B The angular acceleration of the disk is 63.1019 ✪ rad/s² 0.
Water flows at 2 m/s through a 2.5 m length of a 25 mm inside diameter tube. The inlet temperature of water is 293 K and its outlet temperature is 295 K. Assume that the inside surface temperature of the tube is at 320 K. Determine the overall heat transfer coefficient (based on the inside surface area) in kW/m^2·deg C. A. 1.61 B. 2.55 C. 1.09 D. 7.85 do fast i will 6 upvotes.
typing
do fast.
Calculate the biaxial stresses σ₁ and σ₂ for the biaxial stress case, where ε₁= 0.002 and ε₂ = - 0.001 are determined experimentally on an aluminum member of elastic constants, E = 71 GPa and v = 0.35 . Also, determine the value for the maximum shear stress.
do fast no use Ai answer plz
do fast

SEE MORE QUESTIONS

Recommended textbooks for you

Practical Management Science

Operations Management

ISBN:

9781337406659

Author:

WINSTON, Wayne L.

Publisher:

Cengage,

Practical Management Science

Operations Management

ISBN:

9781337406659

Author:

WINSTON, Wayne L.

Publisher:

Cengage,

SEE MORE TEXTBOOKS