Suppose an AC source with an rms voltage of 480 V and a frequency of 61.5 Hz is connected to a 23.5 μF capacitor. Part (a) What rms current, in amps, flows through this circuit? Part (b) What would the rms current be, in amps, if we changed the source frequency to 0.225 kHz? Irms 2 = ||

Suppose an AC source with an rms voltage of 480 V and a frequency of 61.5 Hz is connected to a 23.5 μF capacitor. Part (a) What rms current, in amps, flows through this circuit? Part (b) What would the rms current be, in amps, if we changed the source frequency to 0.225 kHz? Irms 2 = ||

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 56AP: An ac source of voltage amplitude 100 V and frequency 1.0 kHz drives an PLC series circuit with...

See similar textbooks

Related questions

Q: 18.0 V. Capacitor C₁ is first charged by closing switch S₁. Switch S₁ is = Consider the circuit…

A: Step 1: Step 2: Step 3: Step 4:

Q: None

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: Don't use chat gpt

A: Part A: Switch OpenWhen the switch is open, the 6.0 Ω resistor on the right is not part of the…

Q: 2) During an experiment, a student set up a system shown below. She used an ideal light string and a…

Q: Part (d) Which of the following statements could be true? Select all that apply. This potential was…

A: ANS: To determine which statements could be true, we need to analyze each statement based on the…

Q: In a demo for showing how a jet works, Mateo would like to use an inflated balloon. The mass of the…

A: First, we need to identify the forces acting on the balloon. The balloon is subjected to two forces:…

Q: (5) A rectangular loop is released from rest and falls into a region where there is a uniform…

Q: Answer all the questions

A: 1) 2) 3)The minimum power required to drive this heat pump W=2.021KW 4) 5)I hope this is helpful.

Q: A nucleus with 30 protons travels at a velocity of 1.43 x 10^6 m/s through a region of uniform…

Q: A battery with an emf of 9.30 V is connected to a 71.5 Ω resistor. The current through the battery…

A: The problem involves a battery with an electromotive force (emf) and an internal resistance. The…

Q: 8. 9. A speedboat moving at 30 m/s approaches a no-wake buoy marker 100 m ahead. The pilot slows the…

A: First, we need to find the time it takes for the boat to reach the buoy. We can use the equation of…

Q: Problem 7 1.5 m 30 kN 20 kN B D C E -2 m 2 m 2 m- 2 m Determine the force in members DF and DE of…

Q: The fraction of ice which is submerged in water only depends on the density of the ice and the…

A: The fraction of an object submerged in a fluid is equal to the ratio of its density to the density…

Q: What are (a) the x coordinate and (b) the y coordinate of the center of mass for the uniform plate…

A: use Varignon's theorem

Q: Part A A carbon resistor is to be used as a thermometer. On a winter day when the temperature is…

A: Part A: (conductivity of copper at room temperature:…

Q: A beam of light fell on a polished plane of mica where it made an angle of (31.25° ) with the…

Q: (a) Figure (a) shows a nonconducting rod of length L = 8.00 cm and uniform linear charge density λ =…

A: Step 1:Step 2: Step 3: Step 4:

Q: Joan sees a stationary long-board 8.0 m in front of her. She decided to run to the long-board as…

A: if doubt arises please mention in the comments.

Q: What mass of steam initially at 130 \deg C is needed to warm 200 g of water in a 100 - g glass…

A: if doubt arises please mention in the comments.

Q: In the children's book Nuts to You, a young squirrel named Jed is snatched up by a hawk. While in…

A: In this problem, we are asked to find the y-component of Jed's velocity one second after being…

Q: mh

A: The problem is asking us to find the values of the scalars alpha and beta that will make the given…

Q: Consider the gravitational acceleration on the surface of the Moon and of Mars. 1. What is the…

Q: Part A Blocks with masses of 3.0 kg, 5.0 kg, and 7.0 kg are lined up in a row on a frictionless…

Q: A model for the control arm ABCD for the suspension of one of the wheels of an automobile is shown.…

Q: A metal wire has a length of 55.0 m and a diameter of 0.750 mm. The entire length of wire has a…

A: In this problem, we are given the length (L) of the wire as 55.0 m, the diameter (d) of the wire as…

Q: A loudspeaker of mass 19.0 kg is suspended a distance of h = 1.40 m below the ceiling by two cables…

A: Step 1:

Q: Question 2-8

A: Step 1:Answer 2-8: To represent the velocity vectors at four different times, we can use the arrows,…

Q: Please don't use Chatgpt will upvote and give handwritten solution

A: Heisenberg's Uncertainty Principle states that it is impossible to simultaneously measure the exact…

Q: I need help with this problem and an explanation for the solution described below. (University…

Q: The potential difference across a resistor in a particular electric circuit is 240 V. The current…

A: The problem is asking us to find the resistance of a resistor in an electric circuit. We are given…

Q: Please use rotational kinematics concepts to solve the problem.

Q: The figure below shows two vertical, parallel wires separated by a distance d = 11.0 cm. The left…

Q: A hoist for lifting objects onto and off a truck is shown. All cables lie in the xy plane, cable…

A: Step 1:Step 2:Step 3:

Q: Blocks A and B each have a mass m = 10 kg . The coefficient of static friction between A and B is us…

A: There are three forces acting on block A: the weight of the block (W), the normal force exerted by…

Q: Two ladybugs are riding on a turntable as it rotates at 15 rpm as shown in (Figure 1). Part A What…

A: if doubt arises please mention in the comments.

Q: Two ladybugs are riding on a turntable as it rotates at 15 rpm as shown in (Figure 1). Part A What…

Q: 1) A 70.0-kg astronaut pushes to the left on a spacecraft with a force in "gravity-free" space. The…

Q: 4. A copper block with a mass of 8000 g and an initial temperature of T=20°C is supplied with 20…

A: if doubt arises please mention in the comments.

Q: The resistances in Figure (a) and Figure (b) are all 7.1Q, and the batteries are ideal 28 V…

A: if doubt arises please mention in the comments.

Q: Please don't use Chatgpt will upvote and give handwritten solution

A: Step 1: Calculate Linear Charge Density (λ)The linear charge density, denoted as λ, is the charge…

Q: Part A In order to prevent muscle contraction from misaligning bones during healing (which can cause…

A: Step 1:Given:The weight of the leg: w=41.0 NUnknown:The weight required to support the leg: W=?The…

Q: A steel I beam is supported by a pin at point A and a rocker at B, and a cable applies a 2500 lb…

A: Step 1: Step 2: Step 3: Step 4: Step 5: Step 6: Step 7:

Q: A parallel-plate vacuum capacitor has 6.06 J of energy stored in it. The separation between the…

Q: Four charges are placed at the corners of a square of side “a”, as shown in the figure. If q=2.0 μC…

Q: Don't use chat gpt

Q: A loudspeaker of mass 16.0 kg is suspended a distance of h = 1.60 m below the ceiling by two cables…

Q: I need help with this problem and an explanation for the solution described below. (University…

Q: Plot a vs. M2 and using LINEST in excel, Calculate the slope, s, the intercept, b, and the…

A: Step 1: Here we have to plot a vs M2 where M2 will be in the x-axis, while a will be in the y-axis.…

Q: Don't use chat gpt It Chatgpt means downvote

Q: Newton's Second Law for Rotation A 0.70-kg disk with a rotational inertia given by MR…

A: Given:Mass of the disk (M): 0.70 kgRotational inertia (I) of the disk: I = (1/2)MR^2Mass hanging…

Question

Please don't use Chatgpt will upvote and give handwritten solution

Suppose an AC source with an rms voltage of 480 V and a frequency of 61.5 Hz is connected to a 23.5 μF capacitor.
Part (a)
What rms current, in amps, flows through this circuit?
Part (b)
What would the rms current be, in amps, if we changed the source frequency to 0.225 kHz?
Irms 2
= ||

AI-Generated Solution

AI-generated content may present inaccurate or offensive content that does not represent bartleby’s views.

Unlock instant AI solutions

Tap the button
to generate a solution

Click the button to generate
a solution

SEE SOLUTION

Similar questions

A 700-pF capacitor is connected across an ac source with a voltage amplitude of 160 V and a frequency of 20 kHz. (a) Determine the capacitive reactance of the capacitor and the amplitude of the output current of the source. (b) If the frequency is changed to 60 Hz while keeping the voltage amplitude at 160 V, what are the capacitive reactance and the current amplitude?
An PLC series circuit with R=600 , L = 30 mH. and c=0.050F is driven by an ac source whose frequency and voltage amplitude are 500 Hz and 50 V, respectively, (a) What is the impedance of the circuit? (b) What is the amplitude of the current in the circuit? (c) What is the phase angle between the emf of the source and the current?
An ac source of voltage amplitude 100 V and frequency 1.0 kHz drives an PLC series circuit with R=20, L = 4.0 mH, and C=50F . (a) Determine the rms current through the circuit, (b) What are the rms voltages across the three elements? (c) What is the phase angle between the emf and the current? (d) What is the power output of the source? (e) What is the power dissipated in the resistor?
In the AC circuit shown in Figure P32.3, R = 70.0 and the output voltage of the AC source is Vmax sin t. (a) If VR = 0.250 Vmax for the first time at t = 0.0100 s, what is the angular frequency of the source? (b) What is the next value of t for which VR = 0.250 Vmax? Figure P32.6 Problem 3 and 5.
A 30F capacitor is connected across a 60-Hz ac source whose voltage amplitude is 50 V. (a) What is the maximum charge on the capacitor? (b) What is the maximum current into the capacitor? (c) What is the phase relationship between the capacitor charge and the current in the circuit?
An ac source of voltage amplitude 10 V delivers electric energy at a rate of 0.80 W when its current output is 2.5 A. What is the phase angle between the emf and the current?
A 20-mH inductor is connected across an AC source with a variable frequency and a constant-voltage amplitude of 9.0 V. (a) Determine the reactance of the circuit and the maximum current through the inductor when the frequency Is set at 20 kHz. (b) Do the same calculations for a frequency of 60 Hz.
Calculate the rms currents for an ac source is given by v(t)=v0sint , where V0=100V and =200rad/s when connected across (a) a 20F capacitor, (b) a 20-mH inductor, and (c) a 50 resistor.
A step-down transformer has 65 turns in its primary coil and 10 turns in its secondary coil. The primary coil is connected to standard household voltage (Erms= 120.0 V, 60.0 Hz), a. What is the rms voltage in the secondary coil? b. If, instead, the transformer is connected to a 6-V DC battery, what is the rms voltage in the secondary coil after the first few milliseconds?
An AC source operating at 60. Hz with a maximum voltage of 170 V is connected in series with a resistor (R = 1.2 k) and a capacitor (C = 2.5 F). (a) What is the maximum value of the current in the circuit? (b) What are the maximum values of the potential difference across the resistor and the capacitor? (c) When the current is zero, what are the magnitudes of the potential difference across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant? (d) When the current is at a maximum, what are the magnitudes of the potential differences across the resistor, the capacitor, and the AC source? How much charge is on the capacitor at this instant?
A transmission line that has a resistance per unit length of 4.50 104 /m is to be used to transmit 5.00 MW over 400 miles (6.44 105 m). The output voltage of the generator is 4.50 kV (rms). (a) What is the line loss if a transformer is used to step up the voltage to 500. kV (rms)? (b) What fraction of the input power is lost to the line under these Circumstances? (c) What difficulties would he encountered on attempting to transmit the 5.00 MW at the generator voltage of 4.50 kV (rms)?
An AC generator with an rms emf of 15.0 V is connected in series with a 0.54-H inductor. The frequency of the source emf is 70.0 Hz. Draw a phasor diagram for this circuit, including the current, the potential difference across the inductor, and the source emf. Draw your diagram with the current phasor pointing toward the right along the horizontal axis.