Q5. Determine the maximum normal stress in the rectangular bar with a shoulder of circular fillet shown. 480 N·m 100 mm 10 mm 80 mm 480 N-m 30 mm-

Q: In the figure below, the slope angle theta = 20 degrees and the block weight equals 100 N. which of…

A: OPTION B -- Up Slope ( Parallel to the slope surface and upwards. )

Q: Determine the distance y to the centroid of the beam's cross-sectional area. Set a = 70 mm , b = 240…

A:

Q: Sec. 7.1-7.3 7-1. Determine the equation of the elastic curve using the coordinate x, and specify…

A: EI = ConstantDetermine the elastic curve equation, slope at point A and deflection at point C.

Q: Problem 1 The horizontal rigid beam holds the distributed load indicated in the picture. Determine…

A: Area of each bar, Modulus of elasticity,

Q: Question 5. For the triangle shown, determine the third side c and the and if b = 8 ft, h = 6 ft. 8…

A: GUVEN- A right angle triangle where  b =8 ft and h= 6ft…

Q: Replace the loading system at point 0. 0.2 m -1.5 m- 30° 450 N 2m 200 Nm Counterclockwis

A:

Q: For the beam laded as shown in the figure below, determine the following unknowns using any…

A: This problem is related to solid mechnics or structure analysis . In this problem given cantilver…

Q: 250 kN C. 6 m -3 m 3 m El constant E = 200 GPa = 462 (10) mm %3D

A:

Q: ØD VP The figure (not drawn to scale) shows a metallic cylindrical column submitted to a combined…

A:

Q: Use the force method to find the value of the redundant force RCx. All bar areas are the same. (Ans:…

A: To determine the reaction force at C, Rcx Using unit load method (force method)

Q: Replace the two forces acting on the bent pipe by a single equivalent force R. Specify the distance…

A:

Q: 2-23. The triangular plate is fixed at its base, and its apex A is given a horizontal displacement…

A: The triangular plate with dimensions as shown in the figure below,Horizontal displacement,…

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.