Problem 1 The cantilevered rectangular bar is subjected to a force of 9 kips. a. Determine the major principal stress at point B. b. Determine the Orientation angle of the microscopic element at point B. 2.0 in 1.5 in 1.5 in. 2.0 in [1 in. 3 in. 1 in. 29 in 3 in. 9 kips

Q: A rigid beam is supported by bar DE. If the vertical displacement of point D is to be less than 0.1…

A: Let FDE be the force on the bar DE.Vertical displacement at point D will be equal to the change in…

Q: mning Goal: use the superposition principle to find the state -tress on a beam under multiple…

A: d1= 2.15 md2 = 0.5 md3= 0.95 md4=285 mmr= 150 mmP= 4.5 kNTo find:Part A: Determine the support…

Q: 200 mm If the beam is subjected to a bending moment of M=50KN, determine the maximum bending stress…

A: Using formula to find bending stress

Q: (c) A thin, triangular plate ABC is uniformly deformed into a shape ABC', as shown by the dashed…

A:

Q: Determine the shear stress at points A and B on the beam if it is subjected to a shear force of V =…

A: Calculating the moment of inertia : I=112bd3+112bd3  =1120.1(0.3)3+1120.2(0.1)3   =0.2417×10-3 m4

Q: 8. The 500-kN force is assumed to act through the centroid of the cross-section. Determine the…

A: Given: The load is 500 kN. Consider the below figure,

Q: 3. b) The state of stress at a point is shown on the element. Using Mohr's cicle, determine The…

A:

Q: Problem#1 A cantilever beam along with its cross-section is shown in the figure below. 1) Determine…

A:

Q: A rectangular block of a material with a modulus of rigidity G = 90 ksi is bonded to two rigid…

A: Given G=90ksi Assume dimensions of block Depth=2 inch Width=2.5inch Length=8inch

Q: Question 2 The stress acting on two planes at a point is indicated in Fig. 2. Determine using the…

A:

Q: 80 50 50 80

A: Note: Hi! Thank you for the question, As per the honour code, we are allowed to answer three…

Q: Determine the maximum axial force that each object can carry if the maximum stress of object 2 is 50…

A: This question is related to the Stresses and Strain from Strength of Material. In this question we…

Q: The triangular plate is fixed at its base, and its apex A is given a horizontal displacement of 5…

A: The triangular plate with dimensions as shown in the figure below,Horizontal displacement,

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.