In a tensile test, a test piece of 25 mm diameter is tested over a gauge length of 125 mm. The elongation over this length is 0.0875 mm under a pull of 68,725 N. In a torsion test, a test piece was made of the same material and of same diameter and it twisted 0.025 rad. Over a length of 250 mm at a torque of 0.3068 kNm. Find Poisson's ratio and three elastic modulii of the test piece material.

In a tensile test, a test piece of 25 mm diameter is tested over a gauge length of 125 mm. The elongation over this length is 0.0875 mm under a pull of 68,725 N. In a torsion test, a test piece was made of the same material and of same diameter and it twisted 0.025 rad. Over a length of 250 mm at a torque of 0.3068 kNm. Find Poisson's ratio and three elastic modulii of the test piece material.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 13 mm diameter tensile specimen has 50 mm gauge length. If the load corresponding to the 0.2% offset is 6800 kg, the yield stress will be nearly 1. 31 kg/mm² 2. 43 kg/mm² 3. 51 kg/mm² 4. 63 kg/mm² X
A specimen is originally lft long, has a diameter of 0.5in, and is subjected to a force of 5001b. When the force is increased from 5001b to 1,8001b, the specimen elongates 0.009in. Determine the modulus of elasticity (2 decimal places in 103 ksi) for the material if it remains linear elastic.
Help me
A cylindrical tensile specimen has an undeformed diameter of 8.6 mm. It is subjected to a tensile load of 100 kN. The elastic modulus (E) is 10 GPa. Poisson's ratio is 0.25. Calculate the change in the diameter (in mm).
A steel rod, 10mm in diameter and 150mm long is subjected to a tensile load of 50,000N. After the test, the length increases to 150.50mm with no appreciable decrease in diameter. Determine the modulus of elasticity of the steel, assuming that the material remains within the linear elastic region.
Please solve this question and please mention the all the correct answer
Please solve fast!
A metal bar of 10 mm diameter when subjected to a pull of 23.5 kN gave an elongation of 0.3 mm on a gauge length of 200 mm. The Young's modulus of elasticity of the metal will nearly be
Part 2
During a tension test, measurements for the applied load and the corresponding elongation are taken at frequent intervals. These data points are then used to: a. calculate the stress caused by the applied load at each data point. b. calculate the strain in the specimen induced by the applied load at each data point. c. plot a stress-strain diagram. d. all of the above
A circular copper rod having length of 88 inches is to be twisted by torques 572 lb.in until the angle of rotation between the ends of the rod is 3.0°. If the allowable shear strain in the copper is 0.0006 radians, solve for the maximum permissible diameter of the rod?
A rod specimen of ductile cast iron was tested in a torsion-testing machine. The rod diameter was 22 mm, and the rod length was 240 mm. When the applied torque reached 300.0 N-m, a shear strain of 2370 microradians was measured in the specimen. What was the angle of twist in the specimen?