•Given the following information for wastewater plant, the plant is an activated sludge system with an aeration tank that has a volume of 7500m3. efficiency of aeration tank 85% ,SVI is 88ml/gm., volume of settled solids after 30min, is 220ml, Q=60000 m3/d, effluent BOD from aeration tank = 20mg/l. Calculate the values of BOD load, F/M, and efficiency of plant.

•Given the following information for wastewater plant, the plant is an activated sludge system with an aeration tank that has a volume of 7500m3. efficiency of aeration tank 85% ,SVI is 88ml/gm., volume of settled solids after 30min, is 220ml, Q=60000 m3/d, effluent BOD from aeration tank = 20mg/l. Calculate the values of BOD load, F/M, and efficiency of plant.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A continuous stirred tank reactor (CSTR) Activated Sludge Process is used to treat municipal wastewater after primary sedimentation. The following data is available: Primary Effluent Flow Rate (Q) Primary Effluent BOD Concentration (So) Secondary Effluent Biomass Concentration (Xe) Mixed Liquor Biomass Concentration (X) Solids Retention Time (SRT) Waste Sludge Flow Rate (Qw) Value 450 200 O 0 3,000 5 8 Biomass Concentration in RAS (XR) 8,000 O 250 million gallons, 0.28 gBOD/gVSS.d, 13.3 hours 107 million gallons, 0.28 gBOD/gVSS.d, 5.7 hours O 107 million gallons, 0.42 gBOD/gVSS.d, 5.7 hours 107 million gallons, 0.28 gBOD/gVSS.d, 12.2 hour Unit mgd mg/l mg/1 mg/l days mgd The bioreactor volume (V), F/M ratio, and HRT are respectively: mg/l
An activated sludge tank is 30 m long and 10 m wide and has an SWD of 4 m. The wastewater flow is 4.0 ML/day and Compute: a) the BOD concentration which will be applied to the aeration tank b) the food-to-microorganism ratio for the system. O a) 105 mg/L b) F/M=0.35 O a) 195 mg/L b) F/M=0.65 O a) 105 mg/L b) F/M=0.22 O a) 195 mg/L b) F/M=0.35 the raw 5-day BOD is 300 mg/L. Assuming that 35 percent of the raw BOD is removed in the primary clarifier, and the MLSS concentration is 1000 mg/L.
A factory is discharging its wastewater into a slowly moving stream that has a mean velocity of 3 cm/s. The flow rate of the stream is 4 times as that of the wastewater. The ultimate BOD of stream and wastewater are 5 mg/L and 105 mg/L, respectively. And DO of the stream and wastewater are 6 mg/L and 1 mg/L, respectively. The temperatures of the stream and wastewater are 15oC. The deoxygenation rate at 15oC is 0.48 day-1, and the re-aeration rate at 15oC is 0.72 day-1. Draw a DO sag curve to show your clients using Microsoft Excel. Please insert your DO sag curve into your project report (30 points); Based on your DO sag curve, find the location of and travel time to the critical point, and determine the minimum D A type of local fish requires the minimum DO in the river above 2 mg/L. Please evaluate whether the actual minimum DO is acceptable. If not, please qualitatively and quantitatively select appropriate management strategies to allow water quality to reach…
The concentration of the mixed liquor suspended solids, MLSS, in the basin of a step aeration system is 2300 mg/L, and the volume of settled sludge after 30 minutes in a 1 L graduated cylinder is 200 mL. Calculate the SVI in mL/g.
An activated sludge wastewater treatment system was designed and operated in a steadystate under the following conditions:• Reactor volume of 10,000 m3in total;• Sludge concentration (MLSS) of 3200 mg/L in the reactor;• Return sludge concentration at 8000 mg/L (the underflow of the secondary clarifier)• Each day, 400 m3 of underflow sludge (return sludge) was wasted as excesssludge;What is the average Sludge Residence Time (SRT)?
Please give me both a and b solutions A settling tank with (L=6m, W=4 m , H= 4 m) treats a waste stream (60,000 l/min) and removes suspended solids with 200 micrometer diameter that have a settling velocity of 0.04 m/s. a. What is the removal efficiency of his tank? b. If a 100% removal efficiency is to be achieved, How long should the settling tank be?
Q-The MLSS concentration in an aeration tank is 2000 mg/l and the sludge volume after 30 minutes of setting in a 1000 ml graduated cylinder is 175 ml. Find the value of sludge density index (SDI).
In a BOD test, 5 ml of wastewater (with no dissolved oxygen) is diluted with 295 ml of water containing 8.5 mg/1 of dissolved oxygen. After 5 days incubation at 25°C, the dissolved oxygen content of the mixture is 5 mg/1. Temperature coefficient can be taken as 1.047 and BOD rate constant is 0.23 per day (base e) at 20°C. The ultimate biochemical oxygen demand of the wastewater is
Please Solve this question.
The following data for activated sludge process, discharge%=D10 m/min, recycle and wasted solid concentration=15000mg/L , sludge waste from the aeration tank =81.1m³/d, influent BOD concentration=160mg/L, effluent BOD concentration=4 mg/L , Oxygen transfer efficiency=8%, Qactual=........?
Homework - A sample of wastewater was incubated for 7-days at 20°C and showed a BOD of 208 mg/L.. Assuming k=0.15 day', calculate: (i) Its 5-days BOD( ii) Its 10-days BOD (iii) Its ultimate BOD