How to determine the needed surface area of the secondary clarifier tank given that the flow is 40,000 m3 per day and the recycling ratio is 0.5 . The necessary solids concentration in the underflow is 13,000 mg/L, while the Mixed liquor suspended solids concentration in the activated sludge is 4,500 mg/L. The table below shows the settling properties of sludge: Mixed liquor suspended solids Mg/l Settling velocity m/hr 2000 6 4000 3 6000 1 8000 0.2 10000 0.1 13000 0.1

Q: Please solve all points

A: 1.1 Proper F/M (Food to Microorganism) ratio in a conventional activated sludge process typically…

Q: 1:) A circular coagulation basin has a diameter of 2.5 m and it's depth equal to 1.60 m. If me…

A: diameter = 2.5 mdepth = 1.6 mGt = 27000t = 30 s = 1.00310-3 kg /m.salum = 50 mg/LFind: (a) The…

Q: Estimate the maximum flow of leachate from the bottom of a landfill lined with a 0.2 m thick clay…

A: To estimate the maximum flow of leachate from the bottom of a landfill, we can use Darcy's law.…

Q: 3. The concentration of total solids in water can be considered as a conservative chemical property.…

A: Given, Q1 = 10 MGD  Q2 = 4 MGD Q3 = 0.5 MGD

Q: Using the following primary settling tank data, determine the daily sludge production. Operating…

A: As math type is not available, Providing Hand written solution to you,

Q: A sample of 1 litre is drawn from the aeration tank and is then allowed to settle for 30 min. The…

A:

Q: slurry of sediment dredged from a reservoir consists of 14% solids by mass. The slurry also has a…

A: Slurry: A slurry is a mixture of suspended solids in water in the reservoir. The amount of slurry in…

Q: The following data were reported on the operation of primary settling tank and activated sludge…

A:

Q: 21.The waste water treatment plant has dissolved oxygen concentration of 2.8 mg/l and a discharge…

A:

Q: A settling tank has a surface area of 200 m? and inflow rate of 30 m/day. What is the percentage of…

A: Given Surface area of setting tank, As=200m2 Inflow rate, Q ; Q=30 m3/d=3024×60×60m3/sQ=3.47×10-4…

Q: The MLSS concentration in an serration tank is 2000 mg/l and the sludge volume after 30 minutes of…

A: Given- MLSS concentration=2000 mg/L, Sludge volume after 30 min of settling in a 1000 mL…

Q: Hydraulic conductivity K= 100 ft/day, Aquifer thickness B = 50ft, Hydraulic gradient J = 0.001 Plume…

A: Co-efficient of Permeability , K=100ft/d Aquifer Thickness , B=50 ft Hydraulic Gradient , j=0.001

Q: Using Rihet equation, estimate aeration tank Volume (V) based on the following conditions:…

A: GIVEN- Saturation constant (Ks) = 80 mg/L microbial decay coefficient (kd) =0.15/d maximum specific…

Q: 0.02 mm silt particles are completely destabilized by adding alum and are passes through completely…

A: size of particle d= 0.02 mm  lenght= width =depth = 3.0 m Discharge Q= 0.09 m3/s specific gravity of…

Q: Alum at a rate of 20 mg/l is added to an incoming discharge of 0.5 m3/s which carries 250 mg/1 of…

A: 1. Alum added at a rate of 20 mg/l.2. Incoming discharge: 0.5 m³/s3. Incoming discharge carries 250…

Q: Sedimentation tank is used for a flow rate of 0.2 m3/s and has dimensions 32m x8m x4m. The density…

A: Given: Flow rate, Q = 0.2 m3/s Length, L = 32 m Width, B = 8 m Depth, H = 4 m Density of particles =…

Q: A WWTP with activated sludge secondary treatment receives 0.290 m / s of flow from the primary…

A: Answer  We are given flow rate Qo = 0.290 m3/s  microbes concentration the aeration basin X = 2500…

Q: Based on the Sieve Analysis results for filter media given below: Size of Opening (mm) Cumulative…

A: Given the results of Sieve analysis test results for filter media. The effective size = d10 : It is…

Q: There is sedimentation tank that is used to remove suspended solid particles from an incoming…

A: Given Discharge= 150m3/hr surface area= 15m2

Q: Course: Environmental Engg2

A: 1)Important contaminants a) Heavy metals b) Organic particles such as hairs, feces, food waste,…

Q: 1. Calculate the volume and weight of sludge generated per day in circular primary settling tam…

A: The given data is: Flow=10000 m3/d The inlet concentration=1100 mg/l The total suspended…

Q: A complete mixed activated sludge process (CMAS) is to be designed to treat 5MGD of primary effluent…

A: To determine the minimum MCRT, we can use the following equation: MCRTmin = 1 / kd MCRTmin = 1 /…

Q: 10. A 15,000 ft" conventional activated sludge system has a recycle ratio of 0.38, an influent flow…

A:

Q: Determine the Aeration Basin Dimensions for a town of 200,000 population. Mixed Liquor Suspended…

A: Following is the given information: Population = 200,000. Mixed Liquor Suspended Solids  =  3500…

Q: A complete-mixed activated sludge process is to be designed to treat 5.0 MGD of primary effluent…

A: Flow rate= 5 MGD  Primary effluent BOD5 = 180 mg/ L

Q: 1. The lab placed a sample in an evaporation dish and evaporated it at 105°C finding that the dish…

A: Given, Design flow, Q = 20 mgd or 20 x 106 gallons Volume of sample, V = 90 ml or 0.09 Liter   NOTE…

Q: Q2: A column analysis for an activated sludge su MLSS Conc (mg/l) Settling velocity m/h 1000 2.8…

A:

Q: T Settled sludge and filter wash water from water treatment are thickened in Problems 703…

A: Daily Quantity of Thickened SludgeWe can calculate the daily quantity of thickened sludge using the…

Q: Water quality and characteristics discuss: 1. Organoleptic parameters 2. Nitrate 3. Solids

A: 1) Organoleptic Parameters- These are defined as the parameters in which results are obtained after…

Q: Determine the solid loading rate on a secondary circular clarifier (diameter = 20 m) if the plant…

A:

Q: Alum at a rate of 20 mg/l is added to an incoming discharge of 0.5 m3/s which carries 250 mg/1 of…

A: 1. Alum added at a rate of 20 mg/l.2. Incoming discharge: 0.5 m³/s3. Incoming discharge carries 250…

Q: Water treatment plant : SOR = 0.35 mm/sec; The analysis of this water found that there are 6…

A:

Q: 3. Using the data about the active sludge treatment stage below, determine the sludge age. Suspended…

A: Dear student,  Please find the answer in the below attachments  Thank you

Q: The influent suspended solids concentration to a primary settling (clarifier) tank is 300 mg/L. The…

A:

Q: An analysis for determination of solids in the return sludge of activated sludge process was done as…

A: An analysis for determination of solids in the return sludge of activated sludge process was…

Q: A waste sludge flow of 40 m³/day is gravity thickened in a circular tank with a diameter of 6.8 m.…

A: Based on the image you sent and the information provided, it appears to be a word problem related to…

Q: The following data on the substrate removal rate and the substrate concentration is available for…

A: We are using Michaelis-Menten equation

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.