Q.1) a. Calculate volume and weight of sludge generated in thickener by chemical coagulation.Data given as:Wastewater flow: 10000 m³/dFeCl3 added: 500 mg/LInlet concentration: 1100 mg/LCaO added: 400 mg/LOverall particle removal efficiency: 80%Sludge's moisture content: 95%Assume STANDARD chemical reactions and their product's behavior as:Sludge's specific gravity: 1.05FeCl3 + H2O –→ Fe(OH)3CaO + H2O –→ Ca(OH)2

Answered: Image /qna-images/answer/a7c6c965-5473-4993-a885-99cf3da36174.jpg

Q.1) a. Calculate volume and weight of sludge generated in thickener by chemical coagulation. Data given as: Wastewater flow: 10000 m³/d Inlet concentration: 1100 mg/L CaO added: 400 mg/L FeCl3 added: 500 mg/L Overall particle removal efficiency: 80% Sludge's moisture content: 95% Assume STANDARD chemical reactions and their product’s behavior as: Sludge's specific gravity: 1.05 FeCl3 + H2O –→ Fe(OH)3 CaO + H2O → Ca(OH)2

Q.1) a. Calculate volume and weight of sludge generated in thickener by chemical coagulation. Data given as: Wastewater flow: 10000 m³/d Inlet concentration: 1100 mg/L CaO added: 400 mg/L FeCl3 added: 500 mg/L Overall particle removal efficiency: 80% Sludge's moisture content: 95% Assume STANDARD chemical reactions and their product’s behavior as: Sludge's specific gravity: 1.05 FeCl3 + H2O –→ Fe(OH)3 CaO + H2O → Ca(OH)2

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Given the following octanol water partition coefficients (Kow), indicate for which compounds is soil vapor extraction (SVE) a candidate process for removing the compound from the vadose zone of a contaminated soil. Assume that low values of Kow are <10. Provide a relative ranking of contaminants in terms of potential efficiency for SVE treatment. Compound Log Kow Trichloroethene 2.38 4.88 6.01 1.38 3.15 1.46 3.9 6.19 0.26 Pyrene PCBs Vinyl chloride Ethyl benzene Phenol Lindane DDT 2-Butanone (methyl ethyl ketone)
Determine the suspended solids and the percent volatile matter in a solids sample based on the following data: Sample size 25 mL Tare mass of filter = 1.5325 g Tare mass of filter plus retained solids = 1.5415 g Tare mass of filter plus retained ash = 1.5378 g
A- An industrial wastewater stream flows at a rate of 13500 m³/d containing 100 mg/L. Suspended solids, ferric sulfate [Fe(SO4)] is used as a coagulant' at a dose of 50 mg/L. a) Assuming that there is very little in water, what is the daily lime dose? b) If the sedimentation tank removes 90% of the inlet solids, what is the daily solids production from the sedimentation tank?
Enter T next to the following true statements and F next to the false statements. Settling of suspended solids in secondary clarifiers is typical of Type II sedimentation. Thickening prior to digestion is common in many wastewater treatment plants because it reduces the size needed for the digester. Based on a temperature of 30°C, a design mean cell residenee time of about 20 days would be reasonable for a completely-mixed anaerobic digester without recycle. A volatile suspended solid is defined as an organic solid that can be oxidized to CO2 (g) at 250°C. The theoretical yield coefficient can be estimated from the observed yield coefficient if the specific growth rate constant is known. Air flotation would likely be more efficient for thickening waste activated sludge than primary sludge, while the opposite would be true for gravity thickening. The net mass of cells produced in the activated sludge process equals the total cell mass synthesized minus the cell mass wasted as waste…
1
Muni.waste.
Q2-) The waste flow 18000 m³/day is treated by activated sludge process to reduce 97.5% of influent BODS proce concentration of 250 mg/L. The ratio of formed cell mass and substrate utilized mass are 0.4 and 0.8, respectively, MLVSS = 3500 mg/L, return sludge (Xr) = 8000 mg/L, decay growth rate = 0.05, and 8c = 10 days. Find the following: 1. Reactor volume and hydraulic retention time. 3. The daily amount of wasted sludge. 5. Food to microorganisms' ratio. 2. The volumetric organic loading 4. The recycle ratio, and treatment efficiency.
Coagulation aided sedimentation produces 135m³ of sludge per day. The solid content of sludge is 1% by weight and specific gravity of sludge solid is 2.7. If 20 my of suspended solids are removed from the raw water by the Al(OH)3 precipitate formed, and flow through the treatment plant is 40 MLD, then the amount of alum required per day in kg is
Q2-) The waste flow 18000 m'/day is treated by activated sludge process to reduce 97.5% of influent BOD, concentration of 250 mg/L. The ratio of formed cell mass and substrate utilized mass are 0.4 and 0.8, respectively, MLVSS = 3500 mg/L, return sludge (Xr) = 8000 mg/L, decay growth rate= 0.05, and 0 = 10 days. Find the following: 1. Reactor volume and hydraulic retention time. 3. The daily amount of wasted sludge. 5. Food to microorganisms' ratio. 2. The volumetric organic loading 4. The recycle ratio, and treatment efficiency.
Only find the BOD of the mixture.
Draw and fill the table below for three types of settling of particles on your paper Two important characteristics or conditions Applicable to what wastewater treatment Туре Name unit(s) Туре I 1. 2. Туре II 1. 2. Туре II 1. 2.
The following data pertain to a sewage sample: Initial DO = 10 mg/L Final DO = 2 mg/L Dilution to 1%