A- An industrial wastewater stream flows at a rate of 13500 m³/d containing 100 mg/L. Suspended solids, ferric sulfate [Fe(SO4)] is used as a coagulant' at a dose of 50 mg/L. a) Assuming that there is very little in water, what is the daily lime dose? b) If the sedimentation tank removes 90% of the inlet solids, what is the daily solids production from the sedimentation tank?

Q: Sanitary Engineering laboratory  "jar test "   4. Write the significance of pH in coagulation…

A:

Q: 3. A hard drive manufacturer uses Nickel to plate its disks and then polishes them, resulting in a…

A: Given data, Flow rate = 50,000 gallons /day Nickel concentration = 50 mg/l Industrial permit for…

Q: Which of the following statements is false regarding Primary Treatment? Removes solids by…

A: It is related to waste water treatment plant.

Q: A river with a flowrate (Q) of 850 cfs (cubic feet per second) has a total dissolved solids (TDS,…

A: Given, Flow rate of river, Q = 850 cfc= 850 ft3/sec TDS of river, say C =55 mg/L   TDS of discharge…

Q: A rectangular sedimentation tank following coagulation flocculation is to treat a flow of 3000 m3 /…

A:

Q: sludge to meet their NPDES permit of 15 mg/L BOD5.  The mixed liquor concentration is 1,000 mg/L…

A:

Q: During a rainstorm drainage from a construction site on campus flows into a sedimentation pond at a…

A:

Q: The chloride concentration in a brine waste flow of 6.3 L/s is 15000 mg/L. The river flow upstream…

A: step 1-

Q: A mine is planning to use a silty sand mixed with sodium enriched bentonite to line a wastewater…

A: Hydraulic conductivity is a measure of the ability of a porous material, such as soil or rock, to…

Q: A primary wastewater treatment uses centrifugation for dewatering of primary sedimentation sludge.…

A: Given :- Average daily flow to the treatment plant = 5000 m3/d Total suspended solids in raw waste…

Q: After initial mixing of a wastewater discharge in a 5-m-deep river, the DO concentration in the…

A: Please refer the attached image for complete solution. THANK YOU !

Fluid Materials

In general terms, anything that flows can be termed as a fluid. In other words, a fluid is any substance that cannot resist shear forces and deforms continuously under the application of external shear forces. Fluid materials differ completely from solid materials such as metals and alloys. For instance, if we consider two infinitesimally small cross-sectional areas of fluid materials and solid materials, and apply shear forces to these elements, both the elements will undergo deformation. Upon releasing the shear force, the element of the solid materials will regain its original orientation, but the element of the fluid materials will keep on deforming continuously under the action of the shear force.