Given the following octanol water partition coefficients (Kow), indicate for which compounds is soil vaporextraction (SVE) a candidate process for removing the compound from the vadose zone of acontaminated soil. Assume that low values of Kow are <10. Provide a relative ranking of contaminants interms of potential efficiency for SVE treatment.CompoundLog KowTrichloroethene2.384.886.011.383.151.463.96.190.26PyrenePCBsVinyl chlorideEthyl benzenePhenolLindaneDDT2-Butanone (methyl ethyl ketone)

Solution- Higher the worth of segment coefficient more noteworthy is the effectiveness in SVE…

Answered: . Assume that low values of Kow are…

Engineering

Civil Engineering

. Assume that low values of Kow are <10. Provide a relativ efficiency for SVE treatment. Log Kow

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 1. A commercial laundry is consdiering constucing an ion exchange process to remove hardness from…

A: Its a multiple parts problem having more than 3 subparts. So i am allowed to solve 3 subparts in…

Q: 9. A core sample is saturated with Oil, Gas and Water , the initial weight of the saturated sample…

A: Given data - bulk volume of sample = 100 cc Initial weight of saturated sample is 220 gm Increased…

Q: Circular clarifiers are used to remove solid materials from water. They allow continuous treatment…

Q: (i) Calculate the Molarity, and mg/l as CACO3 for 200 mg/I H3PO4

Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…

A: "A given sludge with 98% moisture content is X times more bulky than with 95% moisture content."The…

Q: 1. The solids content of a stream water sample is to be determned. The total solids content is…

A: Mass of empty dish = W1 = 50.326 gm Mass of dish + sample = W2 = 118.400 gm Mass of dish and dried…

Q: Y-Y 2) Dr = (x100%) Y -Y, max

A: Solution Relative density for cohesionless soil Dr=emax-eemax-eminWheree→emin ( Densest state)…

Q: A Laboratory scale treatability study was done to determine kinetic constants with results shown in…

A: The maximum specific growth rate (µm) is a measure of the growth potential of microorganisms under…

Q: Problems arise if the contaminant concen- tration in the influent to the manufacturing step rises…

Q: The water hardness in an area is reported as 700 ppm total dissolved solids. This is the same…

A: Hardness = 700 ppmWe need to convert the hardness from ppm to %

Q: Determine the pH of a solution that contains 2*(10^-4) mg/L of OH- (at 25 degrees)

Q: Some waste has a five-day BOD at 20 °C equal to 210 mg/L and an ultimate OD of 350 mg/L. Find the…

A: Given data :BOD at 20oC is (L) = 210mg/LUltimate BOD at 20oC is (L) = 350mg/L

Q: Plot Xa and S/Sº vs Theta for So= 2000, 200, 20, and 2.

A: Given that :-Required that :-

Q: 6 Ydu will obtain 2.0 L of tap water for you water hardness test. The water hardness test uses a…

A: We will solve this question in step no. 2

Q: 2. Given: Process tank shown below Find: (1) total surface area and (2) volume 3m3 m- 6m 4 m

A: Consider the given tank which has two shape i.e. cube and cone a=side of square =6 mh=height of…

Q: For fc' above 28MPa, Beta1 shall be reduced linearly at a rate of 0.05 for each. a) 7 psi b) 1000…

Concept explainers

Dimensional homogeneity

The term dimensional homogeneity means that in an equation, the dimensions of each term on both sides are equal, which means the dimensions of the left-hand side (LHS) of an equation are similar to the dimensions of the right-hand side (RHS). For a dimensionally homogeneous equation, the powers of fundamental dimensions will be identical on both sides of the equation.

Question

Given the following octanol water partition coefficients (Kow), indicate for which compounds is soil vapor
extraction (SVE) a candidate process for removing the compound from the vadose zone of a
contaminated soil. Assume that low values of Kow are <10. Provide a relative ranking of contaminants in
terms of potential efficiency for SVE treatment.
Compound
Log Kow
Trichloroethene
2.38
4.88
6.01
1.38
3.15
1.46
3.9
6.19
0.26
Pyrene
PCBs
Vinyl chloride
Ethyl benzene
Phenol
Lindane
DDT
2-Butanone (methyl ethyl ketone)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please solve this with explanation of steps
2. At what point in a treatment system is ion exchange normally used?
Due to aging of a pipe line, its carrying capacity has decreased by 25%. The corresponding increase in the Darcy weisbach friction factor f is %
Enter T next to the following true statements and F next to the false statements. The theoretical yield coefficient can be estimated from the observed yield coefficient if the specified growth rate constant is known. Air flotation would likely be more efficient for thickening waste activated sludge than primary sludge, while the opposite would be true for gravity thickening. The net mass of cells produced in the activated sludge process equals the total cell mass synthesized minus the cell mass wasted as waste activated sludge. Although the main purpose of an equalization basin is to give a relatively constant flow rate to downstream treatment operations and processes, a secondary benefit is the removal of some of the total suspended solids.
The ratio of volume of air voids to the volume of total voids, is known as O(A) Air content O(B) Percentage air voids OCC) Percentage voids O(D) Porosity
Estimate the concentration of SOz in the urban air above city, if tthe mixing height above the city is 800m, the width of the box perpendicular to the wind is 12,000 m, the average annual wind speed is 8500 m/h, and the amount of SO2 discharged is 1200x10 pound per year. Pair =1.29 kg/m3,. Pso? = 0.89 kg/m2. Express the concentration in ppm, show a diagram.
3.1 In order to soften 6 MGD of water contains Ca²= 120 mg/L and Mg²+ = 95 mg/L, to the practical solubility limit using split treatment and with desired magnesium concentration of 40 mg/L as CaCO3. we need to treat only: a) 5.5 MGD b) 4.5 MGD c) 3.2 MGD d) 4.9 MGD Continue in the back 3.2 If an ion exchange water softener has 0.2 m' of ion-exchange resin with an exchange capacity of 75 kg/m³. The occupants use 2500 gallon/day of water. If the water contains 250 mg/L of hardness as CaCO, and it is desired to soften it to 90 mg/L as CaCO), what is the time between regeneration? a) 15 days b) 14 days c) 12 days d) 10 days 3.3 You are about to design a sand filter that has sand with a particle diameter of 0.02 inch. During filtration, the depth of the filter is 0.75 ft and the porosity is 0.25. During backwash, the porosity is expected to be 0.60. If gravel and underdrain layer is 1.6 ft and free board is 2 ft, the total depth of the filter will be: a) 3.5 ft b) 5.0 ft c) 8.5 ft d) 9.5 ft…
A bio-tower composed of a modular plastic medium of 6 m is used as secondary treatment component in a municipal wastewater treatment plant. Flow from the primary clarifier is 25000 m³/day with 200 mg/1 BOD. The treatability constant is 0.06 per min. To produce an effluent with a soluble BOD of 20 mg/1, the surface area as per Eckenfelder (coefficient related to medium is 0.5) is approximately:
With solution
An aluminum alloy pipe with an outside diameter of 4.9 in. and a wall thickness of 2/16 in. cantilevers upward a distance of L = 21 ft. The pipe is subjected to a wind loading that increases from WA = 12 lb/ft at its base to we = 18 lb/ft at its tip. (a) Compute the maximum value of Q for the pipe. (b) What is the maximum vertical shear stress in the pipe? WB WA B L
Mohr's circle is shown for a point in a physical object that is subjected to plane stress. Each grid square is 520 psi in size. (a) Determine the stresses Ox, Oy, and the magnitude of Txy and show them on a stress element. (b) Determine the principal stresses and the magnitude of the maximum in-plane shear stress acting at the point and show these stresses on an appropriate sketch (e.g., see Figure 12.15 or Figure 12.16). X Ø C y b
A Granulated Activated Carbon (GAC) adsorption laboratory column 10cm in diameter and 3m deep, is found to produce good results in COD removal when operated at a flow of 50L/h. The porosity of the GAC is 0.5 Calculate the following: The application rate in m/h. The residence time, t, in the column. The volumetric flow rate, Vb, in bed volumes per hour, for this residence time. You need to design a GAC system consisting of two columns in series for treating the same water at a rate of 0.5 ML/d. Practical considerations limit the diameter of the columns to 3m. Calculate the minimum required height of the columns.