A spool has an inner radius p = 1.85 m and an outer radius R = 2.35 m. The mass of the spool is 250 kg and its radius of gyration KG is 2.1 m. A cable wound around the spool is attached at the top of an incline of angle 0 = 32° and the spool is being lowered down the incline as shown in the figure below. The coefficients of static and kinetic friction between the spool and the incline are μs = 0.45 and µ = 0.40. a) Find the acceleration of the center G of the spool b) Find the angular acceleration of the spool c) Find the tension in the cable G

A spool has an inner radius p = 1.85 m and an outer radius R = 2.35 m. The mass of the spool is 250 kg and its radius of gyration KG is 2.1 m. A cable wound around the spool is attached at the top of an incline of angle 0 = 32° and the spool is being lowered down the incline as shown in the figure below. The coefficients of static and kinetic friction between the spool and the incline are μs = 0.45 and µ = 0.40. a) Find the acceleration of the center G of the spool b) Find the angular acceleration of the spool c) Find the tension in the cable G

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Vertical Stress Increase In Soil

Section: Chapter Questions

Problem 8.6P: Two line loads q1 and q2 of infinite lengths are acting on top of an elastic medium, as shown in...

See similar textbooks

Similar questions

Refer to Figure P6.4. A strip load of q = 900 lb/ft2 is applied over a width B = 36 ft. Determine the increase in vertical stress at point A located z = 15 ft below the surface. Given: x = 27 ft. Figure P6.4
EB and FG are two planes inside a soil element ABCD as shown in Figure 10.50. Stress conditions on the two planes are Plane EB: EB = 25 kN/m2; EB = +10 kN/m2 Plane FG: FG = 10 kN/m2; FG = 5 kN/m2 (Note: Mohrs circle sign conventions for stresses are used above) Given ; = 25, determine: a. The maximum and minimum principal stresses b. The angle between the planes EB and FG c. The external stresses on planes AB and BC that would cause the above internal stresses on planes EB and FG
A 9 ft wide and infinitely long flexible strip load of 800 lb/ft2 is placed on an elastic medium as shown in Figure P8.7. Find the vertical stress increase at points A, B, and C located 3 ft below the surface.
The soil profile at a site is shown Figure P16.3. Find the total horizontal normal stresses at A and B, assuming at-rest conditions.
A free-headed drilled shaft is shown in Figure P13.10. Let Qg = 260 kN, Mg = 0, = 17.5 kN/m3, = 35, c' = 0, and Ep = 22 106 kN/m2. Determine a. The ground line deflection, xo b. The maximum bending moment in the drilled shaft c. The maximum tensile stress in the shaft d. The minimum penetration of the shaft needed for this analysis