A mixture of three compounds was chromatographed using a silica gel column with diethyl ether/hexanes (10:90) as the eluting solvent. Fractions were collected and TLC analysis of each fraction was performed, with the results shown here: A C 1 2 3 4 5 6 7 8 Mixture before separation Which fractions should be combined to give pure samples ofA, B and C?

A mixture of three compounds was chromatographed using a silica gel column with diethyl ether/hexanes (10:90) as the eluting solvent. Fractions were collected and TLC analysis of each fraction was performed, with the results shown here: A C 1 2 3 4 5 6 7 8 Mixture before separation Which fractions should be combined to give pure samples ofA, B and C?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

13. Electrospray time-of-flight mass spectrometry was used to analyze the eluate from a high-performance liquid chromatography separation. The mass spectrum of one chromatographic peak, containing a protein of unknown molecular mass, displays MH peaks at m/z = 5 654.208, 5 277.326, 4 947.590, 4 656.613, 4 397.990, and 4 166.576. Find the average molecular mass (M) of the neutral protein and its standard deviation.
Given the mass chromatography, identify the peaks of 200, 144, and 115 for 2-Naphthyl-Butylether.
In a reverse phase chromatography setup, which of the following compounds will have the HIGHEST retention time? ethanol water toluene isopropanol
A solution containing 3.47 mM of copper and 1.73 mM of a standard gave peak areas of 3473 and 10 222, respectively in a chromatographic separation. Calculate the response factor.
A student used thin layer chromatography to confirm whether he could successfully separate two compounds. Here is the TLC plate he obtained after 30 min. Stationary phase was silica gel and mobile phase was 95 % ethyl acetate and 5 % Hexane mixture.
5
a. Separation of Peaks Below are two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used? HPLC: 15% H₂O, 85% CHCN, CIS Revane Phase, 100 mm long, 5pm particles (1) Area (1)-14750 Arta (2)-53538 MIN HPLC: 59% 10,49% CHCN, CIS Reverse Phase, 100 m long, 5 pm particles (2) Mes (1)-2256 A(2)-9536 A(3)-25638 13H
If retention times found on a chromatogram are 0.60 min for CH4 (=tm), 7.0 min for pentane, 8.0 min for an unknown species, and 10.0 min for hexane, find the Kovat's retention index for the unknown.
An unknown compound was analyzed by GC with octane (C3H18) and decane (C10H22). The adjusted retention times were 14.6 min for octane, and 31.6 min for decane. Calculate the retention index for the unknown if its adjusted retention time was 21.2 min.
In an experiment of Reverse Phase chromatography using C-18 stationary phase and a mixture of methanol/ethyl acetate/acetic acid, a researcher tried to separate the 3 compounds shown below. Which compound would have the lowest Rf and which the highest Rf in this experiment? Explain your answer and show any relevant structures.
Give answer all questions with explanation
A standard sample of compound A was placed on a silica TLC plate. After elution in 30/70 ethyl acetate/hexane, the sample showed a single spot at 3.4 cm (relative to the initial point) after the solvent had risen to 7.1 cm (relative to the initial point). A sample which was thought to contain this compound was analyzed by TLC and showed two spots after elution in the same solvent system. The solvent height for this plate was 6.5 cm (relative to the initial point) and the spots were located at 3.6 cm and 5.2 cm (relative to the initial point). Can either of these spots possibly be compound A? Explain. Include a discussion of the R, for each spot.