A disk type centrifuge with disks at 450 angle is used to clarify a suspension of E.coli cells with sedimentation velocity of 5.5x10-5 cm/s. Determine the number of disks required to get the output flow of 200 liters/min if the speed is 6250 rpm and RO = 12.7 cm and R1 = 4 cm.

A disk type centrifuge with disks at 450 angle is used to clarify a suspension of E.coli cells with sedimentation velocity of 5.5x10-5 cm/s. Determine the number of disks required to get the output flow of 200 liters/min if the speed is 6250 rpm and RO = 12.7 cm and R1 = 4 cm.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: 1. Ion exchange resin is commonly used for purification of pharmaceutical products from a cell…

A: 1. The specific surface area (SSA) of a resin particle can be calculated using the following…

Q: Using the regression equation below, calculate the molar absorptivity with 1cm path length y=…

A: Given: Linear regression equation y = 0.1015x + 0.0327 path length = 1cm To calculate: Molar…

Q: Q2: Determine the size of a vertical separator to handle 600 bpd (barrel per day) of 55° API…

A: To determine the size of the vertical separator, we can use the sizing equation for horizontal…

Q: A) Continuing from a pre-deposition of dopants to a substrate with a bulk concentration of 1016/cm³,…

Q: Dosage (mg/L) 1 2 Residual Cl₂ (mg/L) 0.2 0.45 3 1.05 لله 4 2.75 5 4.5 6 5.15 7 6.03

A: In the given problem we need to determine the break point dose of chlorine.

Q: kindly prepare an assignment on Application of HPLC in Drug Analysis: one page show name of the…

A: In high-performance liquid chromatography (HPLC) we inject the sample, which is in solution form,…

Q: cadmium from downstream runoff was obtained using an adsorber. Determine the mass of Cd adsorbed if…

Q: A student recorded the following end-point volumes in a redox determination of ferrous iron against…

A: Here we are required to find standard deviation for the end point volume used during redox titration…

Q: Calculate the hardness of water in ppm CaCO3 if 25.00mL of the sample required 15.00mL of a 0.1000M…

A: Given: Concentration of EDTA solution = 0.1000 M Volume of EDTA solution required = 15.00 mL. And…

Q: Consider the plot of Ecell vs. pPb in the potentiometric analysis of Pb²+, the Nernstian slope is___…

Q: Using the regression equation below, calculate the molar absorptivity with 1cm path length y=…

A: Beer Lamberts law is: Beer lambert's law is:A=∈clwhere,∈= molar absorptivity…

Q: Using Beer's law, calculate the molar absorptivity (M-1 cm-1) of PNP from the absorbance. The path…

A: The amount of substance that resides in the given volume of solvent to furnish the solution can be…

Q: omega-3/g oil, respectively. Calculate the omega 3 extraction efficiency for each temperature based…

A: Weight of kernels crushed for extraction of omega-3 = 5 g (i) From the % yield, calculate the amount…

Q: Soil sampled down to 1.8 m was mixed together then analyzed, and found to have 3.0 g C/kg on…

Q: An enzyme with Km value of 15.75 M and Vm is 30 micromole/L.min is used in a batch reactor.…

A: Km = 15.75 M or mol/L Vmax= 30 μmol/L.min Conversion, X = 88 % Initial concentration of substrate =…

Q: Molar concentration of KMNO 0.02000 M 0.2189 3 7mL 0.3 mL 36.7mL Branhish Weight of complex iron…

Q: The van Deemter equation decribes how the column, stationary phase, and linear velocity influence…

A: We have van Deemmter equation as, H≈A + Bux + Cux We need to find the terms in this equation.

Q: What effect does decreasing the stationary phase film thickness have on the terms of the van Deemter…

Q: Which of the following is a correct expression describing a Lineweaver-Burke plot for substrate…

Q: Overpotential is due to __. Select all that apply. Mass transfer Charge transfer…

A: Mass transfer Charge transfer Is affects the overpotential.

Q: 4. Compare the copper 2+ ion concentration in the eluent after 15 and 30 minutes to the copper 2+…

A: IntroductionSingle Pass Recovery is a term used in computer science and data recovery to describe a…

Q: The function of the catalyst or catalyst is to prepare a surface on which the reactants are adsorbed…

A: We know that any substance that increases the rate of a reaction without itself being consumed is…

Q: The difference between wet and dry corrosion

A: It is a multipart question .According to Guidelaine in multipart question, we can solve only two…

Q: Discuss which of these materials would be suitable for use as a CPC glove material for toluene

A: The selection of suitable glove material include of several important parameters. Breakthrough time…

Q: 3- A sheet of steel 1.5 mm thick has nitrogen atmospheres on both sides at 1200 °C and is permitted…

A: CONCENTRATION PROFILE: A diagram which denotes the immensity of the concentration with respect to…

Q: FTUDICHE ITA heading Lake Monona is a freshwater drainage lake in Dane County, Wisconsin. The name…

A: Note: As you have asked more than three subparts. I have answered first three subparts as per the…

Q: x100 eyepiece graticule 0 10 20 30 40 50 60 70 80 90 100 40 հավիտենականի 70 60 stage micrometer…

A: First do the addition of all the numbers and then divide it by the total number of observations to…

Q: a) The relationship between permeate weight and time with fabrics. b) The characteristic of fabrics…

Q: 7. A constant-head permeameter has cross-sectional area of 156 cm². The sample is 18 centimeters…

A: Given values V=50cm^3 L=18cm A=156cm^3 t=193s h=5cm A) K=VL/Ath K=50cm^3 x 18cm / 156cm^3 x 193s x…

Q: Sedimentation and Decantation

A: These methods are used for separation of mixture in solution. In sedimentation , the insoluble…

Q: The pH of water samples taken from Iligan Bay was determined. Calculate the pooled estimate of the…

A: The formula of standard deviation is shown below: σ =∑n=1ixi-x-2n-1 where; x- = mean n = number of…

Q: For a sand filtration device, the flow rate of the influent is 30 m3/day with the sand filter area…

Q: Diluted skim milk with a protein concentration of 4.3 g/L is to undergoDEF microfiltration.…

Q: Data for undiluted bleach solution: [NaOCI] used in trial (after addition of dye) 25.0mL Which graph…

A: Chemical kinetics is the branch of chemistry which deals with study of the rate of reaction. Rate of…

Q: Using the regression equation below, calculate the molar absorptivity with 1cm path length v=…

A: Here we are required to find the molar absorptivity with the path length 1 cm

Q: The van Deemter equation decribes how the column, stationary phase, and linear velocity influence…

A: The objective is to determine what all the terms in Deemter equation represent and the term(s) that…

Q: 5. A sheet of BcC iron 1 mm thick was exposed to a carburizing gas atmosphere on one side and a…

Q: Procedure: analytically transfer between 0.4053g of iron(III) chloride hexahydrate, FeCl 3•6 H2O (M…

A: Answer 3: The starting material for the synthesized compound is iron(III) chloride hexahydrate,…

Q: prepare an assignment on Application of HPLC in Drug Analysis(Amiloride): one page show name of the…

A: We have to prepare an assignment on application of HPLC in Drug Analysis showing name, dosage form,…

Q: 7. In your own words, differentiate Intralaboratory Quality Control from Interlaboratory Quality…

A: Two questions based on tools in analytical chemistry that are to be accomplished.

Q: An amino acid moves randomly through water with steps of about 3 angstroms (3 x 10^-8 cm) in length…

Q: Using the regression equation below, calculate the molar absorptivity with 1cm path length y=…

A: Given that , The equation of the straight line is , y = 0.0539x + 0.0198

Question

Chemistry
A disk type centrifuge with disks at 450 angle is used to clarify a suspension of
E.coli cells with sedimentation velocity of 5.5x10-5 cm/s. Determine the number
of disks required to get the output flow of 200 liters/min if the speed is 6250 rpm
and RO = 12.7 cm and R1 = 4 cm.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Chemistry Am I suppose to have a straight line in a standard addition plot? Specifically, I am graphing my data obtained determining Mn in steel using spectrophotometry. I used the Method of Standard Addition to perform the lab. I preform the lab twice and my data goes up and down; however, I was under the impression it was supposed to be a straight line
Determine the concentration of Pb2+ in solution w/ 0.040 M NANO3 that's satured with PbCl2 . (Ksp, PbCl2 = 1.66 x 10-5 ). (Determine w/ activties)
A silica TLC plate is developed in a mixture of solvent system/mobile phase. The solvent travels 30 mm up the plate Analyte #1 travels 9 mm up the plate Analyte #2 travels 16 mm up the plate Which analyte is more polar, and what is its Rf? Analyte #1, Rf = 0.53 Analyte #2, Rf = 0.53 Analyte #2, Rf = 0.3 Analyte #1, Rf = 0.3
A small piece of Fe-0.4 wt%C alloy is held at 728 °C for 1 hour and then quenched. On microstructure analysis the microstructure had some level of martensite in it. Estimate the weight fraction of martensite to 2 d.p. Answer:
A plot of current (amperes) versus the square root of scan rate (volts/sec) for the ferricyanide/ferrocyanide (n=1) reaction give a slope value of 0.0001257. The electrode diameter is 1.5 mm. The concentration of ferricyanide is 10 mM. Calculate the diffusion coefficient in cm2/sec.
7.10 A simple cubic (a = 0.3 nm) substrate has been cut along the (100) at a 3° angle to create a stepped surface. If homoepitaxial growth is attempted at 600 °C, will the diffusion length be greater than the distance between steps? Use AG des = 1.0 eV/atom, AGS = 0.5 eV/atom, and vs = 1013/s.
What is the dimension of a chlorine contact chamber if the CT value is 150mg-min/L at the chlorine concentration 0f 5.0 mg/L. Give the width lengthand depth. Show all work.
Please don't provide handwritten solution ......
Effect of dose on adsorption percentage of cadmium onto magnetite (pH 7; adsorbent dose = 0.05, 0.1, 0.5, 0.10, 0.15 g; initial concentration 100 ppm, T = 25°C, 150 rpm, Contact Time = 2 h) performed with ASS instrument. What is the optimal dosage?
A gold disk microelectrode with 0.2 mm diameter was used to obtain voltammograms shown below 20.0 20.0 20.0 75 75 7.5 M -5.0 4.0 -50 175 47.5 300 t -30.0 -30.0 8000 600.0 200.0 0.0 0.0 0.0 400.0 600.0 8000 800.0 400.0 4000 Potential (mv) Potential (mv) Potential (mv) Which of the given options is an example of an irreversible reaction, A, B, or C? Current (A) 600.0 200.0 A Current (A) A 200.0 B Current (A) -17.5
I need the answer in Handwritten
v/mVs ip.a/μA Cyclic voltammetry of ferrocene monocarboxylic acid (FMCA) on 7x10³ um diameter glassy carbon disc working electrode at 25°C showed reversible electrochemistry at all the potential scan rates v, studied. The data for the peak anodic current, ipa are tabulated. If the sytem is a one-electron process with a diffusion coefficient, D, value of 5.2x10 cm's, determine the concentration of FMCA 10 5.00 50 15.00 100 22.75 200 34.50 500 58.25 1000 84.50