Explanation Figure-(1) shows temperature-entropy diagram of Rankine cycle and Brayton cycle. Figure-(1) The Rankine and Brayton cycle consists of two isentropic processes and two constant pressure processes. But the Rankine cycle uses water (steam) as the working fluid while Brayton cycle uses air as the working fluid. In Rankine cycle during the process 1-2, steam is subjected to the isentropic compression in a water pump which pumps water to the boiler. When steam is subjected to the isentropic compression, steam changes its state to water and enters into the saturated liquid region...

8th Edition

ISBN: 9781119391630

Author: MORAN

Publisher: WILEY

See similar textbooks

Videos

Question

Chapter 9.14, Problem 5CU

To determine

The difference between the Rankine cycle and Brayton cycle each composed of two constant pressure processes.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Chapter 9.14, Problem 4CU

Chapter 9.14, Problem 6CU

Students have asked these similar questions

First monthly exam Gas dynamics Third stage Q1/Water at 15° C flow through a 300 mm diameter riveted steel pipe, E-3 mm with a head loss of 6 m in 300 m length. Determine the flow rate in pipe. Use moody chart. Q2/ Assume a car's exhaust system can be approximated as 14 ft long and 0.125 ft-diameter cast-iron pipe ( = 0.00085 ft) with the equivalent of (6) regular 90° flanged elbows (KL = 0.3) and a muffler. The muffler acts as a resistor with a loss coefficient of KL= 8.5. Determine the pressure at the beginning of the exhaust system (pl) if the flowrate is 0.10 cfs, and the exhaust has the same properties as air.(p = 1.74 × 10-3 slug/ft³, u= 4.7 x 10-7 lb.s/ft²) Use moody chart (1) MIDAS Kel=0.3 Q3/Liquid ammonia at -20°C is flowing through a 30 m long section of a 5 mm diameter copper tube(e = 1.5 × 10-6 m) at a rate of 0.15 kg/s. Determine the pressure drop and the head losses. .μ= 2.36 × 10-4 kg/m.s)p = 665.1 kg/m³

2/Y Y+1 2Cp Q1/ Show that Cda Az x P1 mactual Cdf Af R/T₁ 2pf(P1-P2-zxgxpf) Q2/ A simple jet carburetor has to supply 5 Kg of air per minute. The air is at a pressure of 1.013 bar and a temperature of 27 °C. Calculate the throat diameter of the choke for air flow velocity of 90 m/sec. Take velocity coefficient to be 0.8. Assume isentropic flow and the flow to be compressible. Quiz/ Determine the air-fuel ratio supplied at 5000 m altitude by a carburetor which is adjusted to give an air-fuel ratio of 14:1 at sea level where air temperature is 27 °C and pressure is 1.013 bar. The temperature of air decreases with altitude as given by the expression The air pressure decreases with altitude as per relation h = 19200 log10 (1.013), where P is in bar. State any assumptions made. t = ts P 0.0065h

36 2) Use the method of MEMBERS to determine the true magnitude and direction of the forces in members1 and 2 of the frame shown below in Fig 3.2. 300lbs/ft member-1 member-2 30° Fig 3.2. https://brightspace.cuny.edu/d21/le/content/433117/viewContent/29873977/View

Chapter 9 Solutions

FUND OF ENGINEERING THERMO W/WILEY PLU

Ch. 9.14 - Prob. 1E Ch. 9.14 - Prob. 2E Ch. 9.14 - Prob. 3E Ch. 9.14 - Prob. 4E Ch. 9.14 - Prob. 5E Ch. 9.14 - 6. What is the purpose of a rear diffuser on a...Ch. 9.14 - 7. What is the meaning of the octane rating that...Ch. 9.14 - Prob. 8E Ch. 9.14 - Prob. 9E Ch. 9.14 - 10. What is the purpose of the gas turbine–powered...

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.