A small electronic package with a surface area of 820 cm2 is placed in a room where the airtemperature is 28 o C. The heat transfer coefficient is 7.3 W/m2 - o C. You are asked to determine if it isjustified to neglect heat loss from the package by radiation. Assume a uniform surface temperature of78 o C and surface emissivity of 0.65 Assume further that room’s walls and ceiling are at a uniformtemperature of 16 o C.

A small electronic package with a surface area of 820 cm2 is placed in a room where the airtemperature is 28 o C. The heat transfer coefficient is 7.3 W/m2 - o C. You are asked to determine if it isjustified to neglect heat loss from the package by radiation. Assume a uniform surface temperature of78 o C and surface emissivity of 0.65 Assume further that room’s walls and ceiling are at a uniformtemperature of 16 o C.

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.29P: 1.29 A spherical interplanetary probe with a 30-cm diameter contains electronic equipment that...

See similar textbooks

Similar questions

1.19 A cryogenic fluid is stored in a 0.3-m-diameter spherical container is still air. If the convection heat transfer coefficient between the outer surface of the container and the air is 6.8 , the temperature of the air is 27°C, and the temperature of the surface of the sphere is –183°C, determine the rate of heat transfer by convection.
A pipe carrying superheated steam in a basement at 10C has a surface temperature of 150C. Heat loss from the pipe occurs by radiation (=0.6) and natural convection (hc=25W/m2K). Determine the percentage of the total heat loss by these two mechanisms.
A spherical communications satellite, 2 m in diameter, is placed in orbit around the earth. The satellite generates 1000 W of internal power from a small nuclear generator. If the surface of the satellite has an emittance of 0.3, and is shaded from solar radiation by the earth, estimate its surface temperature.
The heat transfer rate from hot air by convection at 100C flowing over one side of a flat plate with dimensions 0.1m0.5m is determined to be 125 W when the surface of the plate is kept at 30C. What is the average convection heat transfer coefficient between the plate and the air?
A horizontal, 3-mm-thick flat-copper plate, 1-m long and 0.5-m wide, is exposed in air at 27C to radiation from the sun. If the total rate of solar radiation absorbed is 300 W and the combined radiation and convection heat transfer coefficients on the upper and lower surfaces are 20 and 15W/m2K, respectively, determine the equilibrium temperature of the plate.
Using Table 1.4 as a guide, prepare a similar table showing the orders of magnitude of the thermal resistances of a unit area for convection between a surface and various fluids.
1. A 1000-W iron is left on the iron board with its base exposed to the air at 20°C. The convection heat transfer coefficient between the base surface and the surrounding air is 35 W/m². °C. If the base has an emissivity of 0.6 and a surface area of 0.02 m², determine the temperature of the base of the iron. 2. The inner and outer surfaces of a 5-m x 6-m brick wall of thickness 30 cm and thermal conductivity 0.69 W/m °C are maintained at temperatures of 20°C and 5°C, respectively. Determine the rate of heat transfer through the wall, in W.
A mercury-in-glass thermometer having a diameter of 6 mm is placed in a verti- cal position to measure the air temperature in a metal warehouse in the summer. The walls of the warehouse are at 50°C. The convection coefficient is 7 W/m² - °C, and the emissivity of the thermometer may be taken as € = 0.9. Calculate the temperature indicated by the thermometer if the air temperature is 32°C.
Please help
Hello Sir,Good Afternoon. I have a question in my homework related Heat Transfer lesson. The following below is my question. Please Advice. Thank You
Consider a 150 W incandescent lamp in a room at 25 °C. The filament of the lamp is 5 cm long and has a diameter of 0.5 mm. The emissivity of the filament is 0.90. The diameter of the glass bulb of the lamp is 8 cm. The inside surface temperature of the glass bulb is 150 °C. Determine: (a) the heat flux, in W∙m-2, on the surface of the filament, (b) the heat flux, in W∙m-2, on the surface of the glass bulb, and (c) the surface temperature of the filament. The surface area of a sphere is ? = 4??2, and the volume of a sphere is ? = (4?/3)?3.
The outside temperature on a particular winter's day is 0°C. Consider two identical houses, each of external surface area 200 m² and internal temperature 20°C. The walls of the first are constructed of a single layer of brick, of thermal conductivity 1 W m-1 °C-1 and thickness 20 cm. What is the heat flux Q out of this house? What is its rate of heat loss in Watts? The walls of the second house are constructed of two layers of brick, each 10 cm thick, and a layer of insulation, also 10 cm thick. The insulation is made mostly out of air, thermal conductivity 0.01 W m of heat loss from this house? How different would your answer be if you neglected the layers of brick in this calculation? -1 °C-1. what are the heat flux and the rate