8th Edition

ISBN: 9781307434316

Author: CENGEL

Publisher: INTER MCG

Concept explainers

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Videos

Textbook Question

100%

Chapter 8.8, Problem 14P

One method of meeting the extra electric power demand at peak periods is to pump some water from a large body of water (such as a lake) to a reservoir at a higher elevation at times of low demand and to generate electricity at times of high demand by letting this water run down and rotate a turbine (i.e., convert the electric energy to potential energy and then back to electric energy). For an energy storage capacity of 5 × 10⁶ kWh, determine the minimum amount of water that needs to be stored at an average elevation (relative to the ground level) of 75 m.

FIGURE P8–15

Chapter 8.8, Problem 14P, One method of meeting the extra electric power demand at peak periods is to pump some water from a

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Chapter 8.8, Problem 13P

Chapter 8.8, Problem 15P

Students have asked these similar questions

A device collects energy from the sun's rays and produces a high temperature of 95 °C. A small heat engine then uses this as a high temperature reservoir and operates at an ambient temperature of 15 °C. What is the maximum possible thermal efficiency of this heat engine? After some improvements are made to the solar energy collector, the high temperature it produces is now Tnew. If it is given that the new maximum possible thermal efficiency of the heat engine is double the previous one, what is Tnew? (Assume that the ambient temperature stays the same)

A pump-turbine is a piece of equipment that can operate either as a pump or as a turbine, depending on the direction of the water flow. The picture on the right shows a pump-turbine system.When it is daytime, this system is used as a turbine, taking water from the upper reservoir and discharging it into the lower reservoir, producing electricity. When it is nighttime, electricity is cheaper, and this system is used as a pump, taking water from the lower reservoir and discharging it into the higher reservoir, so that it can produce electricity again the next day when it is used as a turbine. Consider that, using the system as a turbine or pump, the water flow is 1m3/s and the pressure drop is 5 m, determine:(a) The power extracted from the fluid by the turbine (points 1 and 2 are as shown in the figure: z1=35 m and z2=0 m).(b) The useful power delivered to the fluid by the pump (points 1 and 2 in the figure should be reversed: z1=0 m and z2=35 m).

A central power plant, rated at 500,000 kW, generates steam at 500 K and discards heat to a river at 300 K. If the thermal efficiency of the plant is 80% of the maximum possible value, how much heat is discarded to the river at rated power?

Chapter 8 Solutions

THERMODYNAMICS(SI UNITS,INTL.ED)EBOOK>I

Ch. 8.8 - What final state will maximize the work output of...Ch. 8.8 - Is the exergy of a system different in different...Ch. 8.8 - How does useful work differ from actual work? For...Ch. 8.8 - Prob. 4P Ch. 8.8 - Consider two geothermal wells whose energy...Ch. 8.8 - Consider two systems that are at the same pressure...Ch. 8.8 - Prob. 7P Ch. 8.8 - Does a power plant that has a higher thermal...Ch. 8.8 - Prob. 9P Ch. 8.8 - 8–10C Can a process for which the reversible work...

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Solution Summary: The author explains the minimum amount of water that needs to be stored at an average elevation.

Concept explainers

Videos

Want to see the full answer?

Chapter 8 Solutions