College Physics: A Strategic Approach (3rd Edition)
3rd Edition
ISBN: 9780321879721
Author: Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field
Publisher: PEARSON
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 8, Problem 12P
a.
To determine
To find: The force required to provide the deltoid muscle to keep the arm in the given position.
b.
To determine
To find: The factor that the force exceeds the weight of the arm.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
If you hold your arm outstretched with palm upward, as shown, the force to keep your arm from falling comes from your deltoid muscle. The arm of a typical person has mass 4.0 kg and the distances and angles shown in the figure.a. What force must the deltoid muscle provide to keep the arm in this position?b. By what factor does this force exceed the weight of the arm?
A cook holds a 2.00-kg carton of milk at arm's length
must be exerted by the biceps
(Fig. P8.19). What force F
muscle? (Ignore the weight of the forearm.)
Milk
75.0°
25.0 cm
8.00 cm
Figure P8.19
What is the student’s weight?
Chapter 8 Solutions
College Physics: A Strategic Approach (3rd Edition)
Ch. 8 - An object is acted upon by two (and only two)...Ch. 8 - Prob. 2CQCh. 8 - Could a ladder on a level floor lean against a...Ch. 8 - If you are using a rope to raise a tall mast,...Ch. 8 - Prob. 5CQCh. 8 - Prob. 6CQCh. 8 - Prob. 7CQCh. 8 - A spring exerts a 10 N force after being stretched...Ch. 8 - The left end of a spring is attached to a wall....Ch. 8 - A spring is attached to the floor and pulled...
Ch. 8 - A typical mattress has a network of springs that...Ch. 8 - Take a spring and cut it in half to make two...Ch. 8 - A wire is stretched right to its breaking point by...Ch. 8 - Steel nails are rigid and unbending. Steel wool is...Ch. 8 - The rod in Figure Q8.15 pivots around an axle at...Ch. 8 - Two children hold opposite ends of a lightweight,...Ch. 8 - Prob. 17MCQCh. 8 - Prob. 18MCQCh. 8 - Prob. 19MCQCh. 8 - Prob. 20MCQCh. 8 - Prob. 21MCQCh. 8 - Prob. 22MCQCh. 8 - You have a heavy piece of equipment hanging from a...Ch. 8 - Prob. 24MCQCh. 8 - Prob. 1PCh. 8 - Prob. 2PCh. 8 - Prob. 3PCh. 8 - Prob. 4PCh. 8 - Youre carrying a 3.6-m-long, 25 kg pole to a...Ch. 8 - Prob. 6PCh. 8 - How much torque must the pin exert to keep the rod...Ch. 8 - Prob. 8PCh. 8 - Prob. 9PCh. 8 - Consider the procedure for measuring a womans...Ch. 8 - Prob. 11PCh. 8 - Prob. 12PCh. 8 - Prob. 13PCh. 8 - Prob. 14PCh. 8 - Prob. 15PCh. 8 - Prob. 16PCh. 8 - Prob. 17PCh. 8 - The stability of a vehicle is often rated by the...Ch. 8 - You want to slowly push a stiff board across a 20...Ch. 8 - Prob. 20PCh. 8 - A car manufacturer claims that you can drive its...Ch. 8 - Prob. 22PCh. 8 - One end of a spring is attached to a wall. A 25 N...Ch. 8 - An orthodontic spring, connected between the upper...Ch. 8 - Experiments using optical tweezers measure the...Ch. 8 - A spring has an unstretched length of 10 cm. It...Ch. 8 - One end of a 10-cm-long spring is attached to the...Ch. 8 - A spring stretches 5.0 cm when a 0.20 kg block is...Ch. 8 - A 1.2 kg block is hung from a vertical spring,...Ch. 8 - You need to make a spring scale to measure the...Ch. 8 - A force stretches a wire by 1.0 mm. a. A second...Ch. 8 - What hanging mass will stretch a 2.0-m-long,...Ch. 8 - How much force does it take to stretch a...Ch. 8 - An 80-cm-long, 1.0-mm-diameter steel guitar string...Ch. 8 - A student is testing a 1.0 m length of...Ch. 8 - A 1.2-m-long steel rod with a diameter of 0.50 cm...Ch. 8 - A mineshaft has an ore elevator hung from a single...Ch. 8 - The normal force of the ground on the foot can...Ch. 8 - A three-legged wooden bar stool made out of solid...Ch. 8 - Prob. 40PCh. 8 - A glass optical fiber in a communications system...Ch. 8 - The Achilles tendon connects the muscles in your...Ch. 8 - Prob. 43GPCh. 8 - Prob. 44GPCh. 8 - Using the information in Figure 8.2, calculate the...Ch. 8 - A woman weighing 580 N does a pushup from her...Ch. 8 - Prob. 47GPCh. 8 - Prob. 48GPCh. 8 - Prob. 49GPCh. 8 - The wheel of mass m in Figure P8.50 is pulled on...Ch. 8 - A 5.0 kg mass hanging from a spring scale is...Ch. 8 - Two identical, side-by-side springs with spring...Ch. 8 - Two springs have the same equilibrium length but...Ch. 8 - Figure P8.54 shows two springs attached to a block...Ch. 8 - A 60 kg student is standing atop a spring in an...Ch. 8 - A 25 kg child bounces on a pogo stick. The pogo...Ch. 8 - Figure P8.57 shows a lightweight plank supported...Ch. 8 - In the hammer throw, an athlete spins a heavy mass...Ch. 8 - There is a disk of cartilage between each pair of...Ch. 8 - In Example 8.1, the tension in the biceps tendon...Ch. 8 - Larger animals have sturdier bones than smaller...Ch. 8 - Orb spiders make silk with a typical diameter of...Ch. 8 - Prob. 63MSPPCh. 8 - Prob. 64MSPPCh. 8 - Prob. 65MSPP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A 215-kg robotic arm at an assembly plant is extended horizontally (Fig. P14.32). The massless support rope attached at point B makes an angle of 15.0 with the horizontal, and the center of mass of the arm is at point C. a. What is the tension in the support rope? b. What are the magnitude and direction of the force exerted by the hinge A on the robotic arm to keep the arm in the horizontal position? FIGURE P14.32arrow_forwardA massless, horizontal beam of length L and a massless rope support a sign of mass m (Fig. P14.78). a. What is the tension in the rope? b. In terms of m, g, d, L, and , what are the components of the force exerted by the beam on the wall? FIGURE P14.78arrow_forwardChildren playing pirates have suspended a uniform wooden plank with mass 15.0 kg and length 2.50 m as shown in Figure P14.27. What is the tension in each of the three ropes when Sophia, with a mass of 23.0 kg, is made to walk the plank and is 1.50 m from reaching the end of the plank? FIGURE P14.27arrow_forward
- When you bend over, a series of large muscles, the erector spinae, pull on your spine to hold you up. Figure shows a simplified model of the spine as a rod of length L that pivots at its lower end. In this model, the center of gravity of the 320 N weight of the upper torso is at the center of the spine. The 160 N weight of the head and arms acts at the top of the spine. The erector spinae muscles are modeled as a single muscle that acts at an 12° angle to the spine. Suppose the person shown bends over to an angle of 30° from the horizontal. a. What is the tension in the erector muscle? Hint: Align your x-axis with the axis of the spine.b. A force from the pelvic girdle acts on the base of the spine. What is the component of this force in the direction of the spine? (This large force is the cause of many back injuries).arrow_forwardA person places his hand palm downward on a scale and pushes down on the scale until it reads 96.0 N. The triceps muscle is responsible for this arm extension force. Find the force exerted by the triceps muscle. The bottom of the triceps muscle is 2.50 cm to the left of the elbow joint, and the palm is pushing at approximately 29.0 cm to the right of the elbow joint. P 96.0 N 2.50 cm and Q = 29.0 cm. where P =arrow_forwardA. Who should sit farther from the center of a uniform seesaw, a 93-kg man or his 33-kg son, for the seesaw to remain in a horizontal position? Explain. B. Illustrate the figure and solve the problem by showing complete solution. Ella weighing 225 N sits at one end of a see-saw 4 m long. If Omar sits opposite her 150 cm away from the center, they balance each other. What is the weight of Omar? ( Disregard the weight of the seesaw)arrow_forward
- When you bend over, a series of large muscles, the erector spinae, pull on your spine to hold you up. The following figure shows a simplified model of the spine as a rod of length L that pivots at its lower end. In this model, the center of gravity of the 270 N270 N weight of the upper torso is at the center of the spine. The 140 N140 N weight of the head and arms acts at the top of the spine. The erector spinae muscles are modeled as a single muscle that acts at a 1212-degree angle to the spine. Suppose the person in the figure bends over to an angle of 3030 degrees from horizontal. The center of gravity is half the length, and the center of gravity for the upper torso is 2/32/3 of the length A. What is the tension in the erector muscle? B. A force from the pelvic girdle acts on the base of the spine. What is the component of this force in the direction parallel to the spine? This large force is the cause of many back injuries.arrow_forwardA uniform beam is 5.0 m long and is supported as shown in the figure. At the center of the beam, a baby mobile is attached. a. If m1 = 12 g and m2 = 10 g, find the value of m3 in order for this mobile to sit in equilibrium. b. If the torque exerted by the tension on the cable is 1300 Nm, what must be the mass of the beam?arrow_forwardT3.8 Please help me answer this physics question.arrow_forward
- A pitcher holds a baseball as shown below. The biceps muscle is attached to the radial bone 3.6 centimeters from the elbow joint, the forearm and hand have a combined mass of 2.4 kilograms and a combined length of 41 centimeters, and the ball has a mass of 0.146 kilograms. a. What force is exerted by the biceps muscle? Include units in your answer. More information. b. What force must be exerted by the humerus at the elbow joint to keep the arm in translational equilibrium? Include units in your answer.(Write your answer as positive if directed up, negative if directed down)(positive if directed up, negative if directed down)arrow_forwardThe large quadriceps muscle in the upper leg ter- Quadriceps - Tendon minates at its lower end in a - Tibia tendon attached to the upper end of the tibia (Fig. P8.35a). The forces on the lower leg when the leg is extended are modeled as in Figure P8.35b, where T is the force of ten- a sion in the tendon, w is the force of gravity acting on the lower leg, and F is the force of gravity acting on the foot. Find T when the ten- 25.0° T don is at an angle of 25.0° with the tibia, assuming that w = 30.0 N, F = 12.5 N, and the leg is extended at an angle 0 of 40.0° with the ver- Figure P8.35 tical. Assume that the center of gravity of the lower leg is at its center and that the tendon attaches to the lower leg at a point one-fifth of the way down the leg. 13arrow_forwarda. What are the conditions for static equilibrium? b. A 30.0 kg post is supported by two wires as shown. The post is 2.00 m long and a 5.00 kg wreath hangs 1.50 m from one end. Use the conditions for static equilibrium from part (a) to find the tension in each wire. Include a free body diagram as part of your answer.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
College PhysicsPhysicsISBN:9781285737027Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning
University Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781285737027
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
University Physics Volume 1
Physics
ISBN:9781938168277
Author:William Moebs, Samuel J. Ling, Jeff Sanny
Publisher:OpenStax - Rice University