(a) Interpretation: The final water temperature should be calculated. Concept introduction: First law of Thermodynamics for a closed system. Δ u + Δ E k + Δ E p = Q − W The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Question

Want to see the full answer?

Answer 1

Question

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Problem 1) A fractional factorial design has been used to study on the effect of 3 parameters including adsorbent concentration (300 and 500 ppm), pH value (4 and 10) and reaction time (6 and 12 hours) on the adsorption capacity of a composite for removing of methylene blue from a wastewater. If the results obtained for two repetitions of the tests are according to the following table, it is desirable: A) Design Resolution Y₁ Y₂ Run (mg/g) (mg/g) B) Drawing graphs of the effect of each parameter on the adsorption capacity 1 28 26 2 36 34 C) Analysis of interactions 3 18 20 D) Calculate the effects percentage of each parameter and error 4 32 30 E) Determining the optimum conditions to achieve the highest adsorption capacity

Thermophysical Properties of Petroleum Fractions and Crude Ofls 67 3.4. A gas oil has the following TBP distillation data Volume % TBP (°C) 0 216 10 243 30 268 50 284 70 304 90 318 95 327 100 334 It also has an average boiling point of 280 °C and an average density of 0.850 g/cm³. (a) Split this gas oil fraction into five pseudo-components. Calculate T., Pc and w for each pseudo-component. (b) Calculate T, Pc and w for the whole gas oil fraction. (c) Calculate the enthalpy of this gas oil fraction at 400 °C using the Lee- Kessler correlation with a reference state of ideal gas at 273.15 K.

3.3. Use the following crude assay data with crude API of 36 to estimate cut vol%, critical properties and molecular weight for Light Naphtha (90- 190 °F) and Kerosene (380-520 °F). In addition, calculate the fractions of paraffins, naphthenes and aromatics in the two cuts. ASTM D86 (°F) Volume % Cum vol% SG 86 0.0 0.0 122 0.5 0.5 0.6700 167 1.2 1.7 0.6750 212 1.6 3.3 0.7220 257 2.7 6.0 0.7480 302 3.1 9.1 0.7650 347 3.9 13.0 0.7780 392 4.7 17.7 0.7890 437 5.7 23.4 0.8010 482 8.0 31.4 0.8140 527 10.7 42.1 0.8250 584 5.0 47.1 0.8450 636 10.0 57.1 0.8540 689 7.8 64.9 0.8630 742 7.0 71.9 0.8640 794 6.5 78.4 0.8890 20.8 99.2 0.9310

Answer 2

Question

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 3

Question

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 4

Question

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 5

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Answer 6

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Answer 7

Chapter 7, Problem 7.35P

Interpretation Introduction

(a)

Interpretation:

The final water temperature should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Answer 8

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Answer 9

Interpretation Introduction

(b)

Interpretation:

The specific internal energy, the final temperature of the mixture and the percentage difference in two answers should be calculated.

Concept introduction:

First law of Thermodynamics for a closed system.

Δ u + Δ Ek+Δ Ep = Q−W

The right hand side of the equation gives the total energy transferred to the system and the left hand side gives gain in total energy of the system.

Answer 10

Expert Solution & Answer

Answer 11

Expert Solution & Answer

Answer 12

Want to see the full answer?

Check out a sample textbook solution

See solution

Answer 13

Ch. 7 - A certain gasoline engine has an efficiency of...Ch. 7 - Prob. 7.2P Ch. 7 - Prob. 7.3P Ch. 7 - Prob. 7.4P Ch. 7 - Liquid ethanol is pumped from a large storage tank...Ch. 7 - Air at 300°C and 130 kPa flows through a...Ch. 7 - Prob. 7.7P Ch. 7 - Prob. 7.8P Ch. 7 - Prob. 7.9P Ch. 7 - Prob. 7.10P

Solution Summary: The author explains the first law of Thermodynamics for a closed system.

Concept explainers

Want to see the full answer?

Chapter 7 Solutions