Concept explainers
(a)
Interpretation:
Partial pressure of hydrogen after reaction has to be determined.
Concept Introduction:
Dolton’s law of partial pressure gives relation between total pressure of mixture of gases and partial pressure of individual gases. The expression of relation can be represented as follows:
Here,
A and B are individual gases.
(b)
Interpretation:
Balance equation of
Concept Introduction:
Refer to part (a).
(c)
Interpretation:
Mass of oxygen produced in electrolysis of water has to be determined.
Concept Introduction:
Here,
Want to see the full answer?
Check out a sample textbook solutionChapter 3 Solutions
CHEM PRINCIPLES LL W/ACHIEVE ONE-SEM
- What possible uses exist for the natural gas liquids that are removed from natural gas during its processing?arrow_forwardHow does hydraulic fracturing differ from previously used techniques for the recovery of natural gas from the earth?arrow_forward5.) What volume of Chlorine gas at a pressure of 1 atm and a temperature of 20 °C is required to completely react with Sodium metal?arrow_forward
- Iodine has an orthorhombic unit cell for which the a, b, and c lattice parameters are 0.479, 0.725, and 0.978 nm, respectively. (a) If the atomic packing factor and atomic radius are 0.547 and 0.177 nm, respectively, determine the number of atoms in each unit cell. (b) The atomic weight of iodine is 126.91 g/mol; compute its theoretical density.arrow_forwardA metal cylinder with a capacity of 6.0 L is filled with compressed propane (C3H8). The pressure and temperature of the cylinder when it was initially filled were 120 atm and 75 ◦C, respectively. The molar mass of carbon is 12 g·mol−1 and the molar mass of hydrogen is 1 g·mol−1. a) How many moles of propane are in the cylinder? b) What is the mass of the propane inside the cylinder? c) After some time, the cylinder and its contents cool to 25 ◦C. What is the pressure in the cylinder after it has cooled?arrow_forwardWrite the balanced chemical equation for conversion of Al(s) to KAl(SO4)2·12H2O(s) in aqueous solution.arrow_forward
- Some Chem 16.1 students were tasked to perform the ideal gas experiment with some modifications. Instead of magnesium ribbon, the students were to use 0.029 g of aluminum foil. They prepared the eudiometer by adding 6M HCI and filling it with water to the brim. Once the setup was complete, they performed the experiment. Note that the aluminum was completely consumed in the reaction. From the experiment, it was found that the external pressure was 1.05 atm at 30.0 °C, and the volume of the air inside the eudiometer was 33.5 mL. The water level inside the eudiometer is 4.15 cm below the surface of the water level outside. Given these measurements and the following constants, answer the proceeding questions. At 30.0°C, Pvapor = 31.8 mmHg • R = 0.08206 L-atm/mol-K = 62.36 L-torr/mol-K • MWAI = 26.98 g/mol A. Find the value of the pressure of dry air (PDA) in torr. B. Give the balanced chemical reaction of the aluminum metal with the acid. C. Find the experimental mass (in grams) of…arrow_forwardNaH crystallizes with the same crystal structure as NaCl. The edge length of the cubic unit cell of NaH is 4.880 Å.(a) Calculate the ionic radius of H−. (The ionic radius of Li+ is 0.0.95 Å.)(b) Calculate the density of NaH.arrow_forwardBefore small batteries were available, carbide lamps were used for bicycle lights. Acetylene gas, C2H2, and solid calcium hydroxide were formed by the reaction of calcium carbide, CaC2, with water. The ignition of the acetylene gas provided the light. Currently, the same lamps are used by some cavers, and calcium carbide is used to produce acetylene for carbide cannons.(a) Outline the steps necessary to answer the following question: What volume of C2H2 at 1.005 atm and 12.2 °C is formed by the reaction of 15.48 g of CaC2 with water?(b) Answer the question.arrow_forward
- Jj.200.arrow_forwardWrite the difference between ferromagnetism and anti-ferromagnetism.arrow_forwardSulfur dioxide reacts with oxygen in the presence of plati- num to give sulfur trioxide: 2 SO2(g) + O2(g) → 2 SO3(g) Suppose that at one stage in the reaction, 26.0 mol SO2, 83.0 mol O2, and 17.0 mol SO3 are present in the reaction vessel at a total pressure of 0.950 atm. Calculate the mole fraction of SO3 and its partial pressure.arrow_forward
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning