The absolute configuration (R or S) at the α-carbon atom in each of the given L-amino acids is to be determined. Concept Introduction: The absolute configuration of a chirality center is its three dimensional spatial arrangement of substituents attached to it. When determining the configuration of a chiral center, the atoms or groups attached to it are first assigned priorities on the basis of their atomic numbers . If two atoms attached to the chiral center have the same atomic number, then they are compared on the basis of the atomic numbers of the atoms attached to them. The molecule is oriented such that the lowest ranked group points away from the observer. If the remaining three groups in order of the decreasing priority trace a clockwise path, the configuration is R. If the remaining three groups in order of the decreasing priority trace a counter clockwise path, the configuration is S.

Question

Want to see the full answer?

Answer 1

Question

Chapter 26.2, Problem 2P

Interpretation Introduction

Interpretation:

The absolute configuration (R or S) at the α-carbon atom in each of the given L-amino acids is to be determined.

Concept Introduction:

The absolute configuration of a chirality center is its three dimensional spatial arrangement of substituents attached to it.

When determining the configuration of a chiral center, the atoms or groups attached to it are first assigned priorities on the basis of their atomic numbers.

If two atoms attached to the chiral center have the same atomic number, then they are compared on the basis of the atomic numbers of the atoms attached to them.

The molecule is oriented such that the lowest ranked group points away from the observer.

If the remaining three groups in order of the decreasing priority trace a clockwise path, the configuration is R.

If the remaining three groups in order of the decreasing priority trace a counter clockwise path, the configuration is S.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Commercial bleach contains either chlorine or oxygen as an active ingredient. A commercial oxygenated bleach is much safer to handle and less likely to ruin your clothes. It is possible to determine the amount of active ingredient in an oxygenated bleach product by performing a redox titration. The balance reaction for such a titration is: 6H+ +5H2O2 +2MnO4- à 5O2 + 2Mn2+ + 8H2O If you performed the following procedure: “First, dilute the Seventh Generation Non-Chlorine Bleach by pipetting 10 mL of bleach in a 100 mL volumetric flask and filling the flask to the mark with distilled water. Next, pipet 10 mL of the diluted bleach solution into a 250 mL Erlenmeyer flask and add 20 mL of 1.0 M H2SO4 to the flask. This solution should be titrated with 0.0100 M KMnO4 solution.” It took 18.47mL of the KMnO4 to reach the endpoint on average. What was the concentration of H2O2 in the original bleach solution in weight % assuming the density of bleach is 1g/mL?

10.

Proper care of pH electrodes: Why can you not store a pH electrode in distilled water? What must you instead store it in? Why?