The number of monosaccharide units present in tetrasaccharide has to be stated. Concept introduction: Monosaccharides are those type of sugars which cannot be further hydrolysed. If two monosaccharides combine, then it is called disaccharide and if three monosaccharides combine, then it is called trisaccharide. The polymer which is formed by the combination of several monosaccharides is called a polysaccharide. These monosaccharides can be same, called as homopolysaccharide or different called as heteropolysaccharides.

Question

Want to see the full answer?

Answer 1

Question

Chapter 18, Problem 18.8EP

(a)

Interpretation Introduction

Interpretation: The number of monosaccharide units present in tetrasaccharide has to be stated.

Concept introduction: Monosaccharides are those type of sugars which cannot be further hydrolysed. If two monosaccharides combine, then it is called disaccharide and if three monosaccharides combine, then it is called trisaccharide. The polymer which is formed by the combination of several monosaccharides is called a polysaccharide. These monosaccharides can be same, called as homopolysaccharide or different called as heteropolysaccharides.

(b)

Interpretation Introduction

Interpretation: The number of monosaccharide units present in polysaccharide has to be stated.

Concept introduction: Monosaccharides are those type of sugars which cannot be further hydrolysed. If two monosaccharides combine, then it is called disaccharide and if three monosaccharides combine, then it is called trisaccharide. The polymer which is formed by the combination of several monosaccharides is called a polysaccharide. These monosaccharides can be same, called as homopolysaccharide or different called as heteropolysaccharides.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

b) Certain cyclic compounds are known to be conformationally similar to carbohydrates, although they are not themselves carbohydrates. One example is Compound C shown below, which could be imagined as adopting four possible conformations. In reality, however, only one of these is particularly stable. Circle the conformation you expect to be the most stable, and provide an explanation to justify your choice. For your explanation to be both convincing and correct, it must contain not only words, but also "cartoon" orbital drawings contrasting the four structures. Compound C Possible conformations (circle one): Дет

Lab Data The distance entered is out of the expected range. Check your calculations and conversion factors. Verify your distance. Will the gas cloud be closer to the cotton ball with HCI or NH3? Did you report your data to the correct number of significant figures? - X Experimental Set-up HCI-NH3 NH3-HCI Longer Tube Time elapsed (min) 5 (exact) 5 (exact) Distance between cotton balls (cm) 24.30 24.40 Distance to cloud (cm) 9.70 14.16 Distance traveled by HCI (cm) 9.70 9.80 Distance traveled by NH3 (cm) 14.60 14.50 Diffusion rate of HCI (cm/hr) 116 118 Diffusion rate of NH3 (cm/hr) 175.2 175.2 How to measure distance and calculate rate

For the titration of a divalent metal ion (M2+) with EDTA, the stoichiometry of the reaction is typically: 1:1 (one mole of EDTA per mole of metal ion) 2:1 (two moles of EDTA per mole of metal ion) 1:2 (one mole of EDTA per two moles of metal ion) None of the above