The osmotic pressure of the solution has to be calculated. Concept Introduction: Osmotic pressure: The osmotic pressure of solution is defined as the difference in pressure needed for no net transfer of solvent to occur across a semipermeable membrane that separates the solution from the pure solvent. The osmotic pressure of a solution is proportional to the molar concentration of the solute particles in the solution and the equation is given by, Π=iMRT Here, Π= Osmotic pressure M= Molar concentration of the solute R= Ideal gas constant T= Temperature (in kelvins) i= van’t Hoff factor

Question

6. Choose the compound that will produce the spectrum below and assign the signals as carbonyl, aryl, or alkyl. 100 ō (ppm) 50 0 7. 200 150 Assign all of the protons on the spectrum below. 8. A B 4 E C 3 ō (ppm) 2 1 0 Choose the compound that will produce the spectrum below and assign the signals to the corresponding protons. OH 6 OH 3 2 1 0 4 ō (ppm)

Answer 1

Question

Chapter 12, Problem 12.79QE

Interpretation Introduction

Interpretation:

The osmotic pressure of the solution has to be calculated.

Concept Introduction:

Osmotic pressure: The osmotic pressure of solution is defined as the difference in pressure needed for no net transfer of solvent to occur across a semipermeable membrane that separates the solution from the pure solvent. The osmotic pressure of a solution is proportional to the molar concentration of the solute particles in the solution and the equation is given by,

Π=iMRT

Here, Π= Osmotic pressure

M= Molar concentration of the solute

R= Ideal gas constant

T= Temperature (in kelvins)

i= van’t Hoff factor

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

6. Choose the compound that will produce the spectrum below and assign the signals as carbonyl, aryl, or alkyl. 100 ō (ppm) 50 0 7. 200 150 Assign all of the protons on the spectrum below. 8. A B 4 E C 3 ō (ppm) 2 1 0 Choose the compound that will produce the spectrum below and assign the signals to the corresponding protons. OH 6 OH 3 2 1 0 4 ō (ppm)

In the Thermo Fisher application note about wine analysis (Lesson 3), the following chromatogram was collected of nine components of wine. If peak 3 has a retention time of 3.15 minutes and a peak width of 0.070 minutes, and peak 4 has a retention time of 3.24 minutes and a peak width of 0.075 minutes, what is the resolution factor between the two peaks? [Hint: it will help to review Lesson 2 for this question.] MAU 300 200 T 34 5 100- 1 2 CO 6 7 8 9 0 2.4 2.6 2.8 3.0 3.2 3.4 3.6 3.8 4.0 4.2 4.4 4.6 4.8 5.0 5.2 Minutes 3.22 0.62 1.04 O 1.24

The diagram shows two metals, A and B, which melt at 1000°C and 1400°C. State the weight percentage of the primary constituent (grains of C) that would be obtained by solidifying a 20% alloy of B. 1000°C a+L L+C 900°С 12 α a+C 45 1200 C L+y 140096 C+Y a+ß 800°C 700°C C+B 96 92 a+B 0 10 20 30 40 50 60 70 80 90 100 A % peso B B