Concept explainers
If he leans slightly farther back (increasing the angle between his body and the vertical) but remains stationary in this new position, which of the following statements is true? Assume that the rope remains horizontal, (a) The difference between T1 and T2 will increase, balancing the increased torque about his feet that his weight produces when he leans farther back; (b) the difference between T1 and T2 will decrease, balancing the increased torque about his feet that his weight produces when he leans farther back; (c) neither T1 nor T2 will change, because no other forces are changing; (d) both T1 and T2 will change, but the difference between them will remain the same.
Want to see the full answer?
Check out a sample textbook solutionChapter 11 Solutions
UNIVERSITY PHYSICS UCI PKG
Additional Science Textbook Solutions
The Cosmic Perspective
College Physics
College Physics: A Strategic Approach (3rd Edition)
University Physics Volume 2
Essential University Physics: Volume 1 (3rd Edition)
Physics (5th Edition)
- BIO When a gymnast performing on the rings executes the iron cross, he maintains the position at rest shown in Figure P10.85a. In this maneuver, the gymnasts feet (not shown) are off the floor. The primary muscles involved in supporting this position are the latissimus dorsi (lats) and the pectoralis major (pecs). One of the rings exerts an upward fore Fh on a hand as shown in Figure P10.85b. The force Fs is exerted by the shoulder joint on the arm. The latissimus dorsi and pectoralis major muscles exert a total force Fm on the arm. (a) Using the information in the figure, find the magnitude of the force Fm. (b) Suppose an athlete in training cannot perform the iron cross but can hold a position similar to the figure in which the arms make a 45 angle with the horizontal rather than being horizontal. Why is this position easier for the athlete? Figure P10.85arrow_forward(a) Give an example in which the net force acting on an object is zero, yet the net torque is nonzero. (b) Give an example in which the net torque acting on an object is zero, yet the net force is nonzero.arrow_forwardA standard clothes hanger makes a pretty good equal arm balance. With nothing on it, the hanger hangs free with the bottom side horizontal. (A) while hanging normally, where is the axis of rotation for this equal arm balance located? With respect to the axis, where is the center mass located? (B) if you tip the hanger with your finger then release it, it swings back and forth until friction stops it in a horizontal position. Use the concept of torque to explain why the hanger starts to swing when you release it.arrow_forward
- Assume a person bends forward to lift a load "with his back" as shown in Figure (a). The spine pivots mainly at the fifth lumbar vertebra, with the principal supporting force provided by the erector spinalis muscle in the back. To see the magnitude of the forces involved, consider the model shown in Figure (b) for a person bending forward to lift a W, = 205-N object. The spine and upper body are represented as a uniform horizontal rod of weight W, = 320 N, pivoted at the base of the spine. The erector spinalis muscle, attached at a point two-thirds of the way up the spine, maintains the position of the back. The angle between the spine and this muscle is 0 = 10.5°. Back muscle R, Pivot R W2 a (a) Find the tension T in the back muscle. N (b) Find the compressional force in the spine. (c) Is this method a good way to lift a load? O Yes No Explain your answer, using the results of parts, using the results of parts (a) and (b). This answer has not been graded yet. (d) Can you suggest a…arrow_forwardThe arm in the figure below weighs 37.7 N. The force of gravity acting on the arm acts through point A. Determine the magnitudes of the tension force in the deltoid muscle and the force F S exerted by the shoulder on the humerus (upper-arm bone) to hold the arm in the position shown. (Enter your answers to at least the nearest newton.) N Ft Fs N √12⁰ 0 F 0.080 m -0.290 m TEarrow_forwardThree sailboats are shown below. Each sailboat experiences the same amount of force, yet has different sail orientations. In which case (A, B or C) is the sailboat most likely to tip over sideways? Explainarrow_forward
- A person bending forward to lift a load "with his back" (Figure a) rather than "with his knees" can be injured by large forces exerted on the muscles and vertebrae. The spine pivots mainly at the fifth lumbar vertebra, with the principal supporting why back problems are common among humans, consider the model shown in Figure b, of a person bending forward to lift = 400 N pivoted force provided by the erector spinalis muscle in the back. To see the magnitude of the forces involved, and to understand a W, = 215-N object. The spine and upper body are represented as a uniform horizontal rod of weight W. at the base of the spine. The erector spinalis muscle, attached at a point two-thirds of the way up the spine, maintains the position of the back. The angle between the spine and this muscle is 12.0°. Back muscle R, † 12.0° Pivot Wo W, b (a) Find the tension in the back muscle. kN (b) Find the compressional force in the spine. (Enter the magnitude.) kNarrow_forwardWhat does it mean when we say "an object is in equilibrium? Choose all that apply A there is no friction acting on the object B the object has no inertia there is no net force acting on the object there are no torques acting on the object there is no net torque acting on the object Fthe object has no momentum G there are no forces acting on the object H the object has no energy?arrow_forwardWhen tightening a bolt, you push perpendicularly on a wrench with a force of 150 N at a distance of 0.125 m from the center of the bolt. Part (a) How much torque are you exerting on the wrench, in newton meters, relative to the center of the bolt? Part (b) What is this torque, in pound-foot?arrow_forward
- Stand with your heels and back against a wall and try to bend over and touch your toes. You’ll find that you have to stand away from the wall to do so without toppling over. Compare the minimum distance of your heels from the wall with that of a friend of the opposite sex. Who can touch their toes with their heels nearer to the wall males or females? On the average and in proportion to height, which sex has the lower center of gravity?arrow_forwardAn individual leans forwards to pick up a box of 100 N. The weight of his upper body has a magnitude of 450 N. The back is pivoting around the base of the vertebral column. Consider the back of the individual as a rigid bar that is controlled by a muscle with an angle of 12° (See picture, d = trunk-head distance = 1 m).a) Calculate the magnitude of muscle force required to lift the box.b) Calculate the magnitude of the force at the base of the vertebral column. Hints: For (a) solve the equilibrium of moments, i.e. what force is required in the muscle to balance out the moments acting around the base of the spine.For (b), solve the equilibrium of forces acting on the spine, including the muscle force you’ve just calculated, in x and y separately. There are two extra forces not shown in the diagram: x and y contact forces acting at the base of the spine. These are whatever is needed to keep the total forces acting on the spine = 0 (so the spine isn’t accelerating off in some…arrow_forwardThe amusement-park ride consists of a fixed support near 0, the 6-m arm OA, which rotates about the pivot at 0, and the compartment which remains horizontal by means of a mechanism at A. At a certain instant, 6 = 45, =1.0 rad/s, and B=0.5 rad/s, all clockwise. Determine the horizontal and vertical forces (F and ) exerted by the bench on the 50-kg rider at P.arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice UniversityPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
- Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill