you have been given the following out put answer the 3 questions below RI show ip interface is up, line protocol is up Internet address is 10.0.0.1/8, Process ID 100, Router ID 192.168.10.1, Network Type BROADCAST, Cost: Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 192.168.10.1, Interface address 10.0.0.1 No backup designated router on this network Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:00 Index 2/2, flood queue length 0 Next 0x0 (0)/0x0 (0) Last flood scan length in 1, maximum is i Last flood acan time is 0 msec, maximum is 0 msec Neighbor Count is 0, Adjacent neighbor count is 0 Suppress hello for 0 neighbor (3) 1-the output shown is for which type of interface 2 the protocol running in the interface is 3- the Bandwidth in MB for the interface above is

you have been given the following out put answer the 3 questions below RI show ip interface is up, line protocol is up Internet address is 10.0.0.1/8, Process ID 100, Router ID 192.168.10.1, Network Type BROADCAST, Cost: Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 192.168.10.1, Interface address 10.0.0.1 No backup designated router on this network Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5 Hello due in 00:00:00 Index 2/2, flood queue length 0 Next 0x0 (0)/0x0 (0) Last flood scan length in 1, maximum is i Last flood acan time is 0 msec, maximum is 0 msec Neighbor Count is 0, Adjacent neighbor count is 0 Suppress hello for 0 neighbor (3) 1-the output shown is for which type of interface 2 the protocol running in the interface is 3- the Bandwidth in MB for the interface above is

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

1.The Intra-Site Automatic Tunnel Addressing Protocol is used to transmit IPv6 packets between dual IP layer hosts across an IPv4 network.True or false 2. ICMP is a Network-layer protocol the ping program uses to test whether a computer can communicate with another computer.true or false 3.Addresses starting with fe80 are called link-local IPv6 addresses.true or false 4Routing packets is the key responsibility of the TCP protocol.true or false 5.A zone id is used to distinguish which interface an IPv6 unique local IPv6 address is bound to.true or false
Question 10 Consider the network shown below. The IP and MAC addresses are shown for hosts A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node B to node D. 77-34-F1-EF-14-72 128,119,97,18 (1) 68-01-BC-58-AF-24 128,119,50,107 B (3) 49-FA-B0-3C-E2-7C 128,119,50.00 72-9E-4A-31-9C-42 128.119.240.15 CC-A5-81-08-AE-33 128,119,97,194 40-00-00-74-06-1F 128,119,240,52 (6) C D5-A0-EE-90-73-05 128,119,240.116 A. What is the source/destination network- or link-layer address at the location (3)? B. What is the source/destination network- or link-layer address at the location (4)? C. What is the source/destination network- or link-layer address at the location (5)? Consider an IP datagram being sent from node A to node C. D. What is the source/destination network- or link-layer address at the location (2)? E. What is the source/destination network- or link-layer address at the location (4)? F. What is the source/destination network- or link-layer…
A simple CIDR routing table is shown in Figure 1. For each of the destination IP addresses below, indicate which entry in the table it matches. Indicating none if no routing entry can be matched (hint: given an IP packet, the router will check whether there is a routing entry which can be used to route this packet, by checking the destination IP address in the packet with each routing entry: based on the subnet mask of each routing entry, it can extract the network ID and compare it with each routing entry; if there are a few routing entries which can match, the entry with the longest subnet mask wins). Address Mask Output Port 10.19.0.0/16 1 10.19.128/17 2 10.19.192/18 3 10.19.192/19 4 0.0.0.0/1 5 141.219.2.10 10.10.10.10 10.19.86.141 10.19.193.6 10.19.255.86 10.19.192.18
Computer Science IP is a Routed Protocol, just like ICMP and IGMP: whereas RIP, OSPF, BGP are all Routing Protocols, Could you please ustrato the respective roles, interactions and co-working of P4 and TOP 4 v6) with the OSPF and BGP in case of a Router that separates and interconnects Intranet of a large campus to the Internet? You may assume that this Router is one of the multiple Layer-3 devices that the campus has and that this router has three connected LAN interfaces and three connected WAN interfaces. Does this kind of interaction require any specific protocol that is NOT explicitly listed above? If so, which one(s) and why?
Let's say you're checking your inbox first thing on a Monday morning at BMCC and your messages get there. Assuming the website at BMCC does not know the MAC address of the machine where these emails are being read. Specifically, walk me through the steps used by the ARP protocol to determine which machine on the local area network will be receiving the incoming Internet data. After 22 years, IPv6 Addressing change for around 30% of Internet traffic is complete. If you look carefully at the TCP and IP headers for IPv4 to IPv6 addressing, you'll see that the Ethernet frames' Maximum Transmission Unit (MTU) presents a problem for the transition.
a) Refer to Figure 2-1, answer the following questions. State is Active 1 state change, last state change 00:02 :34 Virtual IP address is 192.168.2.100 Hello time 3 sec, hold time 10 sec Next hello sent in 0.288 secs Redirect time 600 sec, forwarder timeout 14400 sec Preemption disabled Active is local Standby is 192.168.2.2, priority 100 (expires in 8.640 sec) Priority 100 (default) Weighting 100 (default 100), thresholds: lower 1, upper 100 Load balancing: round-robin Group members: 001e. 7aa3.5e71 (192.168.2.1) local 001e.7aa3.5f31 (192.168.2.2) There are 2 forwarders (1 active) Forwarder 1 State is Active 1 state change, last state change 00:02 :23 MAC address is 0007.b400.0101 (default) Figure 2-1: Partial output of switch S1 Which type of protocol is being configured based on the partial output shown in Figure 2-1? (i) (ii) Ms. Carolyn, one of the network engineers is troubleshooting host connectivity on a LAN based on the configuration settings on switch S1 as shown in Figure…
b. Problem 2: Host IP Address: Original Subnet Mask New Subnet Mask: Given: Find: Number of Subnet Bits Number of Subnets Created Number of Host Bits per Subnet Number of Hosts per Subnet Network Address of this Subnet IPv4 Address of First Host on this Subnet IPv4 Address of Last Host on this Subnet IPv4 Broadcast Address on this Subnet 10.101.99.228 255.0.0.0 255.255.128.0
Scenario two: If you have been given only the IP 200.75.64.0/25. Use subnetting technique distribute the IP's in a table showing the Subnet/Branch IP, usable host range (excluding the gateway address), the gateway address, the broadcast address and the subnet mask for each subnet/branch. Show all you calculation/design steps.
For each ping attempt (ping by IP address), circle whether the ping succeeds or fails. The stated subnet mask is the subnet mask which A applies to the source and destination IP addresses in the ping packet. For this problem, assume that the router is NOT able to send a ping request packet out via the same port upon which it arrived. Pay close attention to the network connectivity devices. 13 IP 200 10.3.3 MAC 63 Succeeds Fails A pings Z Succeeds Fails Subnet Mask = 255.255.255.0 A pings C IP 200.10.3.3 MAC 63 . IP 200.10.2.2 MAC 62 A pings Z IP 200.10.4.4 MAC 64 Succeeds Fails IP 200 10.2.2 MAC 62 Subnet Mask 255.255.255.0 A pings C Succeeds Fails IP 200.10.4.4 MAC 64 Subnet Mask 255.255.0.0 A pings C Succeeds Fails A pings Z Succeeds Fails Subnet Mask 255.255.0.0 A pings C Succeeds Fails A pings 2 Succeeds Fails IP 200.50.2.2 MAC 82 IP 200.504.4 MAC 84 Subnet Mask 255.0.0.0 A pings C Succeeds Fails A pings Z IP 200.50.2.2 MAC 82 opol IP 200.50 4.4 MAC 84 IP 200.50.3.3 MAC 83 Succeeds…
Q: Consider the following network, using RIP protocol 1- Write the initial state for router (R1) routing table. 2- Write the final state for router (R1) routing table after receiving the updates from the neighbor routers./ " 130.10.0.0 130.11.0.0 195.2.4.0 205.5.5.0 195.2.4.1 R2 R4 205.5.5.1 130.10.0.1 130.11.0.1 195.2.5.1 205.5.6.1 풀세트 195.2.5.0 205.5.6.0 195.2.5.2 R3 195.2.6.1 195.2.6.0