Sketch the topology of the network if the network has one router with the following routing table? Mask Next hop Address Network Interface Address /26 203.15.17.224 m1 /18 140.23.193.0 mo Default Default 120.55.11.4 m2 5.

Q: Refer to this exhibit they are connected to each router with OSPF routing protocol, and they both…

A: The fundamental benefit of a link state routing protocol like OSPF is that routers can generate…

Q: . Explain how nmap tool can be used by both network administrator and hackers.

A: Nmap(Network mapper) Nmap is a free, open-source tool for vulnerability scanning and network…

Q: (c) Assume a router has the following entries in its routing table (cf. Table 1). Table 1: Router…

A: Given:   Assume a router has the following entries in its routing table (cf. Table 1).   What route…

Q: Given an address of 200.10.10.0 with a needed usable host of 16, What is the 7th subnet range?

A: The question is given an address of 200.10.10.0 with a needed usable host of 16, What is the 7th…

Q: Static NAT configuration commands for the Gateway Router with respect to the given noose appropriate…

A: Static net is used for translating one private IP Address to single public address. In static net…

Q: we obtain the following information from one router. What kind of routing protocol does it use?…

A: Here use ony Routing information protocol. we can use it wiht local area network for small ranges.…

Q: subnet range

A: Given :- In the above question, a network address is mention in the above given question   Need to…

Q: Where is a packet to each of the tollowing destinations forwarded? a. 128.96.39.10 b. 128.96.40.12…

A: ANS:  it is very simple to check  the packet is forwarded to which interface by simply bitwise "AND"…

Q: What Routing Protocol would be used to send traffic between AS5 and AS6? Explain briefly how this…

A: Given that What Routing Protocol would be used to send traffic between AS5 and AS6? Explain briefly…

Q: switch 3 192.168.3.0/24 1 2 3 4 5 6 000000 192.168.3.8 255.255.255.0 192.168.3.1 AAA3 Router 2…

A: The objective of the question is to determine which router interface will first receive an IP packet…

Q: a. Where will a packet destined to address 142.14.1.5 be forwarded? b. Where will a packet destined…

A: A)  When we compare the address 142.14.1.5 with the first destination address 142.14.1.4 , the…

Q: uestion

A: The answer is

Q: Block Address: 192.168.16.0/24 Pont to Point Lank WANI Usable of Hosts: 2 Users X LANG: Usable #of…

A: ANSWER:

Q: There is a route entry R* 0.0.0.0/0 [120/1] via 172.30.2.2, 00:00:16 serial 0/0/0 in R1 routing…

A: There is a route entry R* 0.0.0.0/0 [120/1] via 172.30.2.2, 00:00:16 serial 0/0/0 in R1 routing…

Q: If delays are recorded as 10 bit numbers in a 50 router network, and delay vectors are exchanged…

A: Given that: If delays are recorded as 10 bit numbers in a 50 router network, and delay vectors are…

Q: Network Address 129.123.0.0 /27 14.0.0.0 /14 198.1.19.0 126 157.12.0.0 /21 *CIDR-Classless…

A: Given table contains four entries that for the four networks. CIDR stands for Classless Inter Domain…

Q: The following is a routing table of a router using CIDR. Prefix Next Hop 160.135.52.0/22 Interface 0…

A: We are provided with a Routing table here: 160.135.52.0/22 --> Interface 0 150.135.64.0/22…

Q: of a router using CIDE Interface 22 A

A:

Q: Using the following topology, write the three routers R1, R2 and R3 routing table based on dynamic…

A: By using the following topology ,the three routers R1,R2 and R3 routing table based on dynamic…

Q: Task 3: Implement OSPF on the given topology. | 11.0.0.0 Router-PT Routero Router-PT Roureri…

A: Answer: I have implement OSPF on the given topology

Q: Given a network 100.20.128.0/18, design 4 subnets of 100 computers and 4 subnets of two usable IP…

A: Given network is: 100.20.128.0/18 IP Address/Subnetting: NETWORK: 100.20.128.0/25 SUBNET MASK:…

Q: A packet arrives at the router in Figure 2 with destination address 135.11.80.21. Show how it is…

A: Given, Destination address 135.11.80.21. Binary Representation of destination address:…

Q: Q3: If a routing table of a router is depicted by the following table, what is the next hop for a…

A: A routing table is provided for the information.

Q: A router uses the following routing table- Destination Mask Interface 144.16.0.0 255.255.0.0 etho…

A: the interface on which the destination address with 144.16.68.117 is forwarded is detailed in step…

Q: ARP restricts address resolution to a single network. Could ARP send an IP datagram to a faraway…

A: Yes, that is achievable.

Q: Choose a set of class C, /24 addresses that could be successfully combined into a supernet that…

A: Super netting: It is a process of combining small networks into big networks. It is also called as…

Q: Copy running-config to startup-config Set name for routers in the network. Change the clock rate as…

A: Instructions: 1. Enter into privileged mode 2. Show the active configuration in memory 3. View the…

Q: rk address of 198.125.50.0 with a needed usable host of 45, What is the custom subnet mask for this…

A: the solution is an given below :

Q: Use the Wireshark packet list display window, shown below, to answer the following question. Source…

A: The fundamental occupation of a web server is to show site content through putting away, handling…

Q: Block Address: 192.168.16.0/24 Pont to Point Lank WANI Usable #of Hosts: 2 Users 08 LANG: Usable #of…

A: The answer is written in step 2

Q: Write the classless routing table for R3 192.16.7.0/24 145.80.0.0/18 R1 m2, 192.16.7.5 145.80.7.11…

A: CIDR stands for Class less Inter Domain Routing, in this Classless inter domain the main advantage…

Q: LSM Review Exercise ou are tasked with designing the VLSM IP Addressing Major Network…

A: To design a VLSM ip addressing. It comes under Computer networks. VLSM ->Variable Length Subnet…

Q: There is a routing table in the figure on a router.  If packets with the following destination IP…

A: The routing table given is:- Address  Next hop 198.52.60.0/23 Ethernet 0 198.52.62.0/23…