Question 10 Consider the network shown below. The IP and MAC addresses are shown for hosts A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node B to node D. 77-34-F1 EF 14-72 128,119,97,18 (1) 68-01-BC-58-AF-24 128,119,50,107 B (3) 49-FA-B0-3C-E2-XC 128,119,50.00 72-9E-4A-31-9C-42 128.119.240.15 CC-A5-81-08-AE-33 128,119,97,194 40-00-00-74-06-1F 128,119,240,52 (6) (5) C D5-A0-EE-99-73-05 128,119,240.116 A. What is the source/destination network- or link-layer address at the location (3)? B. What is the source/destination network- or link-layer address at the location (4)? C. What is the source/destination network- or link-layer address at the location (5)?

Question 10 Consider the network shown below. The IP and MAC addresses are shown for hosts A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node B to node D. 77-34-F1 EF 14-72 128,119,97,18 (1) 68-01-BC-58-AF-24 128,119,50,107 B (3) 49-FA-B0-3C-E2-XC 128,119,50.00 72-9E-4A-31-9C-42 128.119.240.15 CC-A5-81-08-AE-33 128,119,97,194 40-00-00-74-06-1F 128,119,240,52 (6) (5) C D5-A0-EE-99-73-05 128,119,240.116 A. What is the source/destination network- or link-layer address at the location (3)? B. What is the source/destination network- or link-layer address at the location (4)? C. What is the source/destination network- or link-layer address at the location (5)?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, answer the following question 1-5. The devices in each subnet are connected locally to each other through layer two intermediate devices such as Ethernet switch and ethernet hub. For each device in the subnets, both its Internet Protocol (IP )address and its MAC address (also called the Physical address or the Ethernet address are shown. The subnet mask used by all devices is 255.255.255.240 (which is the same as the prefix length “/28”). 1. If Client #1 wants to send a broadcast packet to all the devices on the left subnet (containing client #1, client #2, client #3) what destination IP address should be used? (Mention in both binary and decimal format.) 2. What is the first and last assignable IP address for the left subnet above (containing client #1 and #3)? (Mention in both binary and decimal format.)
Consider the situation of an employee who is using their computer to send and receive email at their place of employment. However, the mail server is situated on a distinct network from the physical connectivity networks, which are all Ethernet networks. Each of the two networks—the employee's network and the mail server's network—is linked by a single router, which also has a connection to the Internet via the workplace's Internet service provider. Include any protocols that are used and any encapsulation/decapsulation that takes place when data moves between the employee's email client, local mail server, and distant mail servers in your explanation of how the email client communicates with the email server.
Consider the network shown below. The IP and MAC addresses are shown for hosts A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node B to node D. 77-34-F1 EF-14-72 128,119,97,18 A (1) 68-01-BC-58-AF-24 128,119,50,107 B 49-FA-B0-3C-E2-7C 128,119,50,60 72-9E-40-31-9C-42 128.119.240.15 CC-A5-81-08-AF-33 128,119.97.194 40-00-A0-74-06-1F 128,119,240,52 (5) C D5-AO-EE-9A-73-06 128.119.240.116 A. What is the source/destination network- or link-layer address at the location (3)? B. What is the source/destination network- or link-layer address at the location (4)? C. What is the source/destination network- or link-layer address at the location (5)? Consider an IP datagram being sent from node A to node C. D. What is the source/destination network- or link-layer address at the location (2)? E. What is the source/destination network- or link-layer address at the location (4)? F. What is the source/destination network- or link-layer address at the…
Use this figure as a reference, if the values are A, B, C and D (3rd octet) with the following conditions:• Value A = 37• Value B = 38• Value C = 39• Value D = 40X1, y1, z1 are the interfaces for the router gateway, while x2, x3, y2, y3, z2, z3 are for the router interface a. Find the Routing Table R1, R2, and R3 using the following table! Destination Next hop Interface
The first thing needed is a IP-addressing range to use in our network. Since this assignment is done in a laboratory setting, we don't have to comply to the RFC1918[2] standards of private IP-addressing. An IP address is written in the form shown in equation (2.1.1). X grpl grp2 grp3 grp4 X grpl grp2 grp3 grp4 We need however to take into consideration that the address range of 224.0.0.0/3 have been reserved, for amongst other thing multicast. Because of this, we will need to use another modulus-value on the first octet when we are generating a usable ip-address range. Start by creating your groups unique IP-address range using equation (2.1.2) where {x,y EZ | 0≤x≤ 223,0 ≤ y ≤ 255} (2.1.2) where {x EZ | 0≤x≤ 255} Where each octet will be based on each group members birthday. Value X is calculated according to equation (2.1.3), and value Y is calculated according to equation (2.1.4). YY * MM + DD mod 223 YY MM + DD X mod 255 grpl (2.1.1) The fourth group in the IP-address should be set…
Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as for the router's interfaces. Consider an IP datagram being sent from node D to node A. Give the source and destination Ethernet addresses, as well as the source and destination addresses of the IP datagram encapsulated within the Ethernet frame at points (5), (4), (2), and (1) in the figure above.
NAT translation table LAN side addr WAN side addr 135.122.200.215 10.0.1.15 10,0.1.13 address 135.122.200.215 S: 10,0,1.27 2 D: 1 D: S: S: D: S: 10,0.1.15 D: 135.122,200,215 10.०.1.22
4. The original HTTP protocol used TCP/IP as the underlying protocol. For each page, graphic, or applet, a separate TCP connection was constructed, used, and terminated. This caused several problems: one referred to as the elephant and mice problem and two aspects of connection overhead. Describe both problems. Why were separate connections used? Would UDP rather than TCP be a good alternative? What solution would you propose to these problems to improve HTTP performance?
(b) The Internet Protocol (IP) can sometimes surprise with its flexibility. Since the overall design is close enough to the principles of the OSI Protocol Model, IP is independent of the Data Link and Physical network layers. And some Norwegians indeed showed successful IP network transmission is possible with carrier pigeons. If we would want to attempt to use carrier pigeons to establish a TCP connection between Canterbury and London, how long would it take to successfully establish the transmission under perfect conditions? (Assume the pigeons are perfectly reliable.) Explain how you come to your result. (1)
Consider an employee using their computer to send and retrieve email at their workplace. Only Ethernet networks are used for physical connectivity, but the mail server is located on a separate network. The employee’s network and the mail server’s network are connected by a single router which also has a connection to the Internet via the workplace’s ISP. Explain how the employees email client sends and receives emails using the email server, indicating any protocols involved and where any encapsulation/decapsulation occurs as data travels between the client, local mail server, and remote mail servers.
A Propagation Queuing processing (waiting for transmission) Nodal Transmission Assume the two hosts on the left of the figure start transmitting packets of 1500 bytes at the same time (at time=D0) towards Router B. Suppose the link rates between the hosts and Router A are 4Mbps and the link rate between router A and router B is 4Mbps. One host link has a 2ms propagation delay and the other has a 3ms propagation delay. Router A has a nodal processing delay of 0.3ms. A. Calculate the time router A receives the last bit of the first packet: ms
Assignment 5: Both TCP and UDP are widely used IP transfer layer protocols. For applications requiring reliable transfers, TCP is generally preferred, while applications that value throughput more than reliability are best served using UDP. Most TCP/IP stacks provide both protocols, so the application can use whichever transfer protocol is more appropriate, even changing from one to the other as desired. Rather than rely solely on TCP, the network system developer might want to investigate the trade-offs related to use of UDP. Based upon the analysis list out why Some TCP/IP Applications Use UDP?