Using kinetic equation, estimate effluent soluble BOD concentration based on the following conditions: saturation constant (Ks) = 60 mg/L, microbial decay coefficient (kd) = 0.15/d, maximum specific growth rate (um) = 5/d, yield (Y) = 0.45, sludge age = 1.5 days. O 7.5 mg/L O 5.2 mg/L O 6.8 mg/L O 11.7 mg/L

Using kinetic equation, estimate effluent soluble BOD concentration based on the following conditions: saturation constant (Ks) = 60 mg/L, microbial decay coefficient (kd) = 0.15/d, maximum specific growth rate (um) = 5/d, yield (Y) = 0.45, sludge age = 1.5 days. O 7.5 mg/L O 5.2 mg/L O 6.8 mg/L O 11.7 mg/L

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Z=0 Water Table Steady State Recharge 4.1 m Ground Surface 0 z (meters) 11 K (meters/day) 0.5 K(z) =…

A: Given data:Hydraulic conductivity, k(z)=0.5+0.03zPorosity, n=0.23Depth of unconfined aquifer=-11mWe…

Q: 1 The lower the water turbidity, the higher the allowable scour velocity in sedimentation tank.( ) 2…

A: 1 True - Lower water turbidity allows for higher allowable scour velocity as the particles in the…

Q: A sealed 1L reactor contains 500 mL of water, 200 mL of soil (density 2.1 g/cm3) and 300 mL of air.…

A: Calculate the mass of TCE in each phase:Air: 100 μg * 0.3 L / 1 L * 1000 g / 1 kg = 30 μgWater: 100…

Q: Problem 2 Assume a clay liner with the following properties: thickness is 0.9 m, hydraulic…

Q: A truck carrying gasoline overturns during an ice storm. The gasoline tank is ruptured and the…

A: The objective of the problem described is likely related to assessing the spread and impact of a…

Q: A sample of 1 litre is drawn from the aeration tank and is then allowed to settle for 30 min. The…

Q: otal hardness (TH) of the raw water is ________ mg/L as CaCO3. a) 55.0 b) 226.3 c) 426.3 d) 80.0…

A: Given Data:Caco3=50Ca2+=20Mg2+=12.2HCO3=61

Q: A completely mixed activated sludge plant treats wastewater at a rate of 2,565 m³/d. The influent…

Q: Plot Xa and S/Sº vs Theta for So= 2000, 200, 20, and 2.

A: Given that :-Required that :-

Q: Question 3. A DNAPLS substance was generated and released in a tire fire accident. A consulting firm…

A: The given data is shown below: Aquifer depth=1300 mSoil porosity=34%Hydraulic conductivity=41…

Q: A two litre graduated cylinder was used to determine the Sludge Volume Index (SVI) of an activated…

A: Volume of cylinder: 2 litersSettled volume: 800 mlMLSS concentration =2800 mg/ltTo find SVI of…

Q: In order to clarify water containing particles with a diameter of 120 µm, what is used is a settling…

Q: Estimate sludge production (Px) based on the following conditions: microbial decay coefficient (kd)…

A: Given Influent fow= 1m3/s Q=1000 liter/s Q=10001×24×60×60 liter/day=86.4×106 liter/dayQ=86.4 MLD…

Q: Using Rihet equation, estimate aeration tank Volume (V) based on the following conditions:…

A: GIVEN- Saturation constant (Ks) = 80 mg/L microbial decay coefficient (kd) =0.15/d maximum specific…

Q: (d) Ca(HCO3)2 = 150 mg/L; Mg(HCO3)2 = 200 mg/L; CaSO4 = 180 mg/L; MgCl2 = 95 mg/L; CaCl2 = 137…

Q: Microbial growth in an activated sludge system can be described by the Monod model. If the maximum…

A: µ=specific growth rate = .6 day-1 µmax=maximum value of μ = 1.2 day-1 KS=saturation constant =…

Q: For an industrial activated sludge treatment process, the biomass concentration (X) is 2,200 mg…

A: The formula to calculate the microbial growth is given by, rg=k×S×Y×XKs+S Here, k is Max substrate…

Q: 1. The lab placed a sample in an evaporation dish and evaporated it at 105°C finding that the dish…

A: Given, Design flow, Q = 20 mgd or 20 x 106 gallons Volume of sample, V = 90 ml or 0.09 Liter NOTE…

Q: A given sludge with 98% moisture content is X times more bulky than with 95% moisture content. The…

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

Using kinetic equation, estimate effluent soluble BOD
concentration based on the following conditions:
saturation constant (Ks) = 60 mg/L, microbial decay
coefficient (kd) = 0.15/d, maximum specific growth rate
(um) = 5/d, yield (Y) = 0.45, sludge age = 1.5 days.
O 7.5 mg/L
O 5.2 mg/L
O 6.8 mg/L
O 11.7 mg/L

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

An anaerobic digester is operated with a hydraulic retention time (HRT) of 25 d and a flow rate of 0.85 m³/d. The influent substrate concentration is 18 g/L and the digestion process is assumed to follow first order kinetics with a Ko value of 0.09 d'¹. Calculate: (a) the liquid volume of the anaerobic digester, V (m³) (b) the effluent substrate concentration, So (g/L)
An anaerobic digester (AD) is designed with the following data. Organic loading rate 1.0 kg VSS/m³.day VSS load 120 kg/day (i). (ii). Estimate the volume of the AD. If the VSS is 12 kg/m³, estimate the retention time.
The following data on the substrate removal rate and the substrate concentration is available for wastewater treatment (S) mol Rate, r (mol/min) 0.04 0.57 0.06 1.05 0.8 2.32 0.10 3.00 0.12 4.68 0.14 5.42 2.0 5.78 Estimate the value of substrate removal constant Km and the value of Vmax
solve question 10 please
A sorption study of Cd2+ on a sandy loam gave the following results: Equilibrium Concentration (mg/L) Cd2+ Sorbed (mg/gm) 0.045 7 0.10 15 0.14 21 0.20 30 0.24 37 What is Kd
9-2 (15 pts) Determine the alkalinity, total hardness, carbonate hardness, and non-carbonate hardness (in mg/L CaCO3) for the water (pH 7.4) with the following chemical concentrations. Calculate the doses of lime and soda ash to soften this water. Constituent Concentration, mg/L Ca2+ 95 Mg2+ 13.5 Na 25.8 HCO3 244 SO 2- 73 CI 67.8 H2CO3 7.7
V3. An aerated BOD bottle is filled with substrate and microbial cells. You have determined the following parameters for this mixture: - Substrate yield, Y=0.60mg/L biomass /mg/L substrate - Specific growth rate, μ=2.0 day −1 - Rate of substrate utilization =15,000mg/L−hr - Substrate concentration =275mg/L - Half-saturation constant =25mg/L Determine: a. The microbial growth rate/biomass utilization rate. 9000mg/L−hr b. The maximum specific growth rate. 2.18 / day c. The biomass concentration. 4500mg/L