Two compartments in a cylinder with uniform cross section and total length 102 cm are separated by a sliding partition which can move but does not allow heat to pass across it. No molecules are present in either of the compartments. The radiation inside each compartment is in thermal equilibrium with its walls. The walls at the two ends of the cylinder are maintained at temperatures 2000 K and 4000 K , respectively. The sides are perfectly insulated. Find the location of the partition, measured from the left end of the container

Two compartments in a cylinder with uniform cross section and total length 102 cm are separated by a sliding partition which can move but does not allow heat to pass across it. No molecules are present in either of the compartments. The radiation inside each compartment is in thermal equilibrium with its walls. The walls at the two ends of the cylinder are maintained at temperatures 2000 K and 4000 K , respectively. The sides are perfectly insulated. Find the location of the partition, measured from the left end of the container

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Earth absorbs solar energy and radiates infrared energy. The intensity of the solar radiation incident on earth is J = 1350 Wm-2, also known as the solar constant. Assume earth’s surface (ground) temperature to be uniform at Ts, and that the ground and atmosphere are black (emissivity = 1) for infrared radiation. The radius of the earth is 6.378 x 106 m. The diagram shows the ground at the surface temperature Ts and the atmosphere, represented as a thin black layer, at temperature Ta . Suppose the atmosphere absorbs 100% of the infrared radiation emitted by the ground. Assume that the ground absorbs 47.5% of the incident solar energy, and that the atmosphere absorbs 17.5% of the incident solar energy (for a total of 65% absorbed by the planet). Calculate the "steady state” numerical values of the earth’s ground temperature Ts and the atmospheric temperature Ta taking into account the “greenhouse effect” of atmospheric infrared absorption and emission described above.
The door of an oven in the kitchen of a house is 0.5 m high and 0.7 m wide. When the oven is operating, the outside temperature of the door reaches 32°C. Calculate the heat transfer from the oven door towards the room at 22°C, taking into account the effects of radiation. The emissivity of the oven door is 1 and the walls of the kitchen are at 22°C. (σ = 5.67 x 10-8 W/m 2K4 , g = 9.81 m/s2 ) NOTE: More precise values for weather characteristics can be obtained from resources on the internet. Also indicate the source you received.
Consider steady heat transfer between two large parallel plates at constant temperatures of T1 = 500 K and T2 = 300 K that are L = 2.5 cm apart. The emissivity of the surfaces, ɛ = 0.95. Calculate the total rate of heat transfer and the percentage by thermal radiation between the plates per unit surface area assuming the gap between the plates is (a) filled with atmospheric air (k = 0.02 W/m.°C), (b) evacuated. %3D %3D %3D O = 5.67 x 10-8 W/m².K4
A 30-m-long hot rod (Diameter = 100-mm) is placed inside a room whose walls and air are at 25 C. The surface temperature of the rod is 150 C. h=10 W/m K. The surface emissivity is: your student number/10. What is the rate of heat loss from the rod? student number =201810372 %3D
2. Consider steady heat transfer between two large parallel plates at constant temperatures of T1 = 295 K and T2 = 155 K that are L = 2 cm apart. Assuming the surfaces to be black, determine the rate of heat transfer between the plates per unit surface area assuming the gap between the plates is (a) filled with atmospheric air,(k = 0.01979 W/m- o C) (b) evacuated,(c) filled with superinsulation having an apparent thermal conductivity of 0.00015 W/m · °C.
Consider steady heat transfer between two large parallel plates at constant temperatures T1 = 300 K and T2 = 200 K that are L = 1 cm apart, as shown below. Assuming the surface to be black, determine the rate of heat transfer between the plates per unit surface area assuming the gap between the plates is a) filled with still air with k = 0.0219 W/m°C, b) free flowing air with h = 7.5 W/m2°C, c) evacuated, d) filled with urethane insulation with k = 0.026 W/m°C, and e) filled with superinsulation that has an apparent thermal conductivity k = 0.00002 W/m°C PLEASE ANSWER LETTER D AND E, THANK YOU
PROBLEM 4: A black thermocouple is inside a chamber with black walls. If the air around the thermocouple is at 20°C, the walls are at 100-C, and the heat transfer coefficient between the thermocouple and the air is 75 W/m²K, what temperature will the thermocouple read?
Consider a silicon wafer positioned in a furnace that is zone-heated on the top section and cooled on the lower section. The wafer is placed such that the top and bottom surfaces of the wafer exchange radiation with the hot and cold zones respectively of the furnace. The zone temperatures are Tsur,h = 1050 K and Tsur.e = 330 K. The emissivity and thickness of the wafer are e = 0.65 and d = 0.78 mm, respectively. With the ambient gas at T. = 700 K, convection heat transfer coefficients at the upper and lower surfaces of the wafer are 8 and 4 W/m²-K. Find the steady-state temperature of the wafer, in K. Tw i K
1) Draw the thermal resistance network representing heat transfer through the shell. 2) Determine the heat rate transfer under steady state conditions (W) 3) Determine the emissive power being emitted from the outside of the cylindrical tank (W). You can ignore emission from the top and bottom surfaces.
Determine the heat loss by radiation from an oven wall to the wall of a room to which the oven wall is directly facing. Assume that no heat flows through the adjacent walls, which are coated with a reradiating material. The oven wall is square, 4 ft on one side, and is 2 ft from the room wall and parallel to it. The oven wall is steel sheet and is at 400°F, and the wall is at 80°F and is of asbestos board.
A long electrical conductor of 10 mm diameter is concentric with a refrigerated cylindrical tube of 50 mm diameter whose surface has an emissivity of 0.9 and temperature of 27 °C. The electrical conductor has a surface emissivity of 0.6 and dissipates 6.0 W per meter length. Assuming that the space between the two surfaces is empty, calculate the surface temperature of the conductor.
A hexagonal cylinder of solid copper has a flat ceiling and a flat floor. Assume the ceiling is at temperature T₁ and the floor is at T₂ < T₁. The other four sides of the hexagon are perfectly insulated with organic, free-range, grass-fed goose down. Sketch and label several isotherms and adiabats within the copper.