An infrared camera is used to measure a temperature at a tissue location. The infrared camera uses the same equation as that in the lecture notes. When the total hemispherical emissivity is selected as =1.0, the temperature reading on the camera is 45°C. (a) Based on the equation given in the notes, please calculate the radiation heat flux received by the camera qck. The Stefan-Boltzmann's constant ois 5.67* 108 W/(m² K¹). (b) However, you notice that the actual emissivity of the tissue surface should be 0.95. The room temperature is 20°C. Use the equation again to calculate the temperature of the tissue location, note that 9ck should be the same as in (a). What is the absolute error of the measurement if both the room temperature and deviation from a perfect blackbody surface are not considered?

An infrared camera is used to measure a temperature at a tissue location. The infrared camera uses the same equation as that in the lecture notes. When the total hemispherical emissivity is selected as =1.0, the temperature reading on the camera is 45°C. (a) Based on the equation given in the notes, please calculate the radiation heat flux received by the camera qck. The Stefan-Boltzmann's constant ois 5.67* 108 W/(m² K¹). (b) However, you notice that the actual emissivity of the tissue surface should be 0.95. The room temperature is 20°C. Use the equation again to calculate the temperature of the tissue location, note that 9ck should be the same as in (a). What is the absolute error of the measurement if both the room temperature and deviation from a perfect blackbody surface are not considered?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

7) Given a window of 20 ft facing east at 40° north latitude, estimate the cooling load due to solar radiation at 4:00 pm for a day in June. Assume the window does not have any interior shading and the shading coefficient is 0.2 (in Btu/hr) (a) 105 (d) 276 (b) 430 (c) 314 (c) 225
MATLAB PROBLEM
PROBLEM 4: A black thermocouple is inside a chamber with black walls. If the air around the thermocouple is at 20°C, the walls are at 100-C, and the heat transfer coefficient between the thermocouple and the air is 75 W/m²K, what temperature will the thermocouple read?
A plate that is exposed to the outside environment at 30 ° C, gets airradiation of 2000 W / m2. The plate, which absorbs 80% of the irradiationand it has an emissivity of 0.5, it is always at a uniform temperature.An external air flow at 20 ° C and 15 W / m2-K go through the plate. Calculatethe temperature of the plate if it is in thermal equilibrium and insteady state conditions.
i need correct explanation my best wishes ton
Please do it on priority
A manufacturing facility located at 32° N latitude has a glazing area of 60 m² facing west that consists of double pane windows made of clear glass (SHGC = 0.766). To reduce the solar heat gain in summer, a reflective film that will reduce the SHGC to 0.35 is considered. The cooling season consists of June, July, August, and September, and the heating season, October through April. The average daily solar heat fluxes incident on the west side at this latitude are 2.35, 3.03, 3.62, 4.00, 4.20, 4.24, 4.16, 3.93, 3.48, 2.94, 2.33, and 2.07 kWh/day · m² for January through December, respectively. Also, the unit costs of electricity and natural gas are $0.09/kWh and $0.45/therm., respectively. If the coefficient of performance of the cooling system is 3.2 and the efficiency of the furnace is 0.90, determine the net annual cost savings due to installing reflective coating on the windows. Also, determine the simple payback period if the installation cost of reflective film is $20/m². Answers:…
1
A long, thin-walled horizontal tube 10.0cm in diameter with an emissivity of 0.80 is maintained at 120.0°C by the passage of pressurized steam inside the tube. To reduce radiation heat transfer losses, a round, tubular radiation shield with an emissivity of 0.10 is installed surrounding the heated tube, with a gap of 1.00cm between the outside of the tube and the radiation shield. At steady-state operating conditions, the temperature of the radiation shield is measured to be 35.0°C. Calculate the total heat transfer rate per meter length assuming that the gap between the pipe and heat shield is now filled with air at a pressure of 1.00 atm.
A composite wall is comprised of two large plates separated by sheets of refractory insulation. In the installation process, the sheets of thickness L = 50 mm and thermal conductivity k = 0.05 W/mK are separated at 1-m intervals by gaps of width w = 10 mm. The hot and cold plates have temperatures and emissivities of T1 = 400 deg C, emissivity1 = 0.85 and T2 = 35 deg C, emissivity2 = 0.5, respectively. Assume that the plates and insulation are diffuse-gray surfaces. %3D Determine the heat loss by radiation through the gap per unit length of the composite wall (normal to the page). Recognizing that the gaps are located on a 1-m spacing, determine what fraction of the total heat loss through the composite wall is due to transfer by radiation through the insulation gap. Hot side Gap w = 10 mm A. 47 W/m, 9.2% T1 = 400°C B. 47 W/m, 10.2% L = 50 mm C. 37 W/m, 10.2% D. 37 W/m, 9.2% T2 = 35°C Cold side 1 m Insulation, k = 0.05 W/m-K
4. The surface temperature of a planet is T, and the measured temperature is Tm (i.e. the temper- ature measured at the top-of-atmosphere based on the upwards flux Ft there). Assume radiative equilibrium. (a) Show that the infrared optical depth of the planet's surface 7 is related to the surface temperature T, and the measured temperature Tm by Calculate the infrared optical depth at the surfaces of (a) Earth, where T, = 300 K and Tm = 250 K. (b) Venus, where T, = 750 K and Tm = 230 K. (c) Mars, where T, = 240 K and T, = 220 K.
An opaque surface which is insulated at the back side has a total, hemispherical absorptivity a=0.8 for solar radiation and a total, hemispherical emissivity of e=0.2. A solar radiation flux of 800 W/m2 is incident on this surface. The surface is exposed to the ambient air at T 300 K and convective heat transfer coefficient is h=15 W/m2 K. Neglect the sky radiation. • Sketch the heat fluxes received and dissipated by this surface • Estimate the equilibrium temperature of the surface (assume the surface temperature is higher than the ambient air temperature). 1.= 300 K, h-15 W/m*K 800 W/m? a-0.8 , e-0.2