The HPLC chromatogram below was collected using a reverse-phase column with a length of 10 cm. Estimat peak widths and heights from the graph to answer the questions below. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Time (min) Signal

The HPLC chromatogram below was collected using a reverse-phase column with a length of 10 cm. Estimat peak widths and heights from the graph to answer the questions below. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Time (min) Signal

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: What is the tR of peak A? What is the tR of peak B?

Q: 4. You analyze a mixture of cyclopentane, pyrrolidine, and tetrahydrofuran by gas chromatography and…

A: Gas chromatogram of a mixture of three compounds cyclopentane, pyrrolidine and tetrahydrofuran

Q: Calculate the resolution between peaks A and B and between peaks D peak E. Make sure your answers…

A: a. To calculate the resolution of 2 peaks from one another. This is given by the formula:…

Q: Compare and contrast a column chromatography, TLC, and GC according to stationary phase, moving…

Q: A spot of black ink was placed on a strip of filter paper. The chromatogram was developed using an…

A: The fastest moving spot has the highest Rf value. here we see C covered a long distance so it has…

Q: The retention factor for analytes in a sample lie between 1 and 5 why?

A: The analyte is the substance to be separated during chromatography. It is also normally what is…

Q: You are analyzing a forensic sample for the presence of controlled substances using HPLC. Which of…

A: Detector is given.

Q: What is the capacity factor of peak A and peak B?

A: Capacity factor is the rate of migration of a solute in a column or the relative indication of time…

Q: Test tube 1 contain hexane, test tube 2 contains fluorene, test tube 3 contains Fluorenone On the…

A: The Rf (retention factor) value in chromatography is related to the polarity of the compound. The Rf…

Q: The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds…

A: To find out the selectivity factor for the separation of A and B for the following chromatogram.

Q: If you spike the sample you collected with a known amount of the analyte of interest, you are…

A: The objective of the question is to identify the calibration method used when a known amount of the…

Q: What is the %composition of the Vitamin A peak in the sample? O 7.867% 77.73% O 78.43% O 72.74%

A: To calculate % composition of vitamin A in the sample.

Q: A GC detector that ionizes each components of the sample and the mass is repeatedly scanned during…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: The following chromatogram is obtained for a mixture of substances X and Y. Calculate the separation…

Q: spot of black ink was placed on a strip of filter paper. The chromatogram was developed using an…

Q: A chromatogram gives an ideal Gaussian peak with tR = 9.40 min and win = 0.19 min. How many…

A: Chromatography is a techniques where separation of components takes places depending on various…

Q: Which of the ff. changes is carried out when sample is completely opaque? Prepare 1/10 dilution of…

A: The main aim of this question is to show the sample becomes completely opaque, it means that light…

Q: Question 2 Retention time is the time spent by analyte in both mobile and stationary phases. True…

A: Kindly get the answer given below.

Q: How does the wavelength in chromatogram affect the signal intensity in an HPLC

A: wavelength in chromatogram affect the signal intensity in an HPLC explanation is given below.

Q: Would peaks B and C in the chromatographic data table below be considered BASELIN RESOLVED? A…

A: Chromatographic data table given,Retention time (min)Width of the base…

Q: In a thin layer chromatography experiment, a plate of length 8.67 cm was used and a horizontal line…

A: Retention factor (Rf) is defined as the ratio of the distance travelled by the compound (dc) to the…

Q: Analysis of an unknown plant extract yield two peaks X and Y in a chromatogram, 15.65 and 17.03 min…

Q: Y 10 11 12 13 14 Tim e (min) O A. 1234 O B. 2116 O C. 1102 O D. 1936 O E. 1488 Instrument response…

Q: The following chromatogram is obtained for a mixture of substances X and Y. The retention factor for…

A: Retention factor: The ratio of distance traveled by the substance to the solvent is known as the…

Q: 24 45 11 4 16 19 21 12 15 3 6 8 9 10 23 13 14 17 18 20 22 1 2 6. 8. 10 12 14 16 18 20 22 24 26 Time…

Q: This is a Biochemistry lab question. For the lab we are spectrophotometrically determining the pka…

A: The Beer-Lambert Law states that the log of the ratio of the intensities is equal to the product of…

Q: Describe the following properties of chromatogram (including formula if applicable): Bandwidth…

A: 1.Bandwidth sets the frequency around the wavelength provided by the detector to view and report…

Q: ii) What are the adjusted retention times for components A and B? iv) What is the relative retention…

A: 3 . For component A = 8-1.2=6.8 For component B = 10-1.2 = 8.8 4. Separation factor = 1.29

Q: Consider the following gas chromatography data. Calibration Analysis area of standard 23849 area of…

A: The formula used to find response factor is: Signalanalyte[Analyte] = F * Signalstandard[Standard]

Q: Reagent Blank Absorbance Concentration of Stock Solution: 10 ppm Volume of Stock Solution (mL) Total…

Q: HPLC VFA analysis - why do I get so different peaks for very similar samples?

A: Volatile fatty acids are formed during microbial fermentation of organic matter and are present in a…

Q: A mixture of A and B is injected into a liquid chromatographic column with length of 24.8 cm. The…

A: Given : Separation resolution between A and B can be calculated using formula: Rs = 2RtB-RtAw1 +…

Q: In the Thermo Fisher application note about wine analysis (Lesson 3), the following chromatogram was…

A: Resolution factor shows accuracy of quantitative analysis

Q: If two peaks were overlapping in the gas chromatogram of a sample, how might you increase the…

A: • Given problem of Gas Chromatography is that, " If the two peaks were overlapping in the gas…

Q: Mw = 102.1 100 MS-NU-0527 80 40 20 10 20 30 40 50 60 70 80 90 100 Relative Intensity

A: Mass spectrometry is used to determine the unknown compounds from their m/z ratios.

Q: 100 MASS SPECTRUM 80 60 40 20 0.0 10 20 30 40 50 60 m/z NIST Chemistry WebBook…

A: The mass spectrum of the compound is given, it shows different peaks at different values of mz.

Q: One definition of analytical method limit of quantitation, LOD, in a GLP laboratory is a signal that…

Q: Retention volume in a chromatographic experiment 1) increases with decreasing length of the column…

A: Retention volume VR is the volum of eluent carrier gas admitted to the column between the injection…

Q: 24) The method of internal standard was used to analyze and measure the concentration of chemical X…

A: Volume of unknown X =3.0 mL Concentration of Y in the mixture = 1.6 x 10-5 M Volume of Y in the…

Q: 13. Electrospray time-of-flight mass spectrometry was used to analyze the eluate from a…

Q: Given the mass chromatography, identify the peaks of 200, 144, and 115 for 2-Naphthyl-Butylether.

A: Mass spectroscopy is an analytical technique in which the samples are analyzed based on the…

Q: 18000 10000 14000- 12000 10000 8 8000. 6000- 4000- 2000- 0 0 0.5 Component Acetone 0.82 Isoborneol…

A: Retention time is defined as the time that a solute spends in a column or the time spent in the…

Q: In a chromatographic experiment, a mix of 3 compounds are separated. The following data are…

A: The mass percentage of compound C is needed to be calculated from the given chromatographic data.

Question

The HPLC chromatogram below was collected using a reverse-phase column with a length of 10 cm. Estimat
peak widths and heights from the graph to answer the questions below.
B
A
0 1 2 3
7 8 9 10 11 12 13 14 15 16 17 18 19 20
Time (min)
a. Calculate the resolution of the peaks.
Signal

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

QUESTION T5 Why were the areas underneath the peaks in the gan chromatographs you eobtained mutiplied by a weight tactor? DA the corrction factor compensates for user error OB Rame lonization detectors (FID) respond slightly dfferent to compounds with diferent molecular weights OCnone of the answers OD. the GC (GOW MAC 350) used contains a quadrapole mass spec detector whose response must be corrected for the miz ratio of the diferent ions obtainen for diferert moleculestune OE not all molecules have the same themmal conductivity QUESTION 16 Which list of functional groups is present in the anti-viral drug Arbidol HO Br O A Thioether, alkene, ester, amide, amine O 8. Thioether alcohol, ester, amine OC Alcohol, ether, amide, epoxide, thioester OD. Ether, ketone olefin, amine, alcohol O E Thioalcohol, alkene, ether, amine, nitro
How do I answer this question?
What would happen to the retention time of a given compound if the carrier gas flow rate of the gas chromatograph is increased? The retention time would increase. The retention time would decrease. The retention time would not change.
The aspirin we made in lab gad 125-133 melting point and I attached the IR. Base on this information, does it mean we made aspirin? The percent yield was also less than 50. Is that acceptable? Is this aspirin pure or not? please explain your answer.
What are the retention times and areas of all the attached peaks?
Does CI aroms have an isotopic pattern of 1:1 relative intensity of M and M+2. True or False?
Explain why the dye spots are elongated and not round on your chromatogram.
What is the plate height if the length of the column is 10cm?
If peak A has a width of 10 min and peak B has a width of 16 mins, what is the column resolution?
Provide a structure of the fragment in the mass spec producing the peak at 139 m/z and a structure for the fragment that was lost.
The ppm concentration of Pb2+ in a blood sample were measured with Spectrophotometry. 5.00 mL of a blood sample were taken and this sample gave a signal of 0.301 a.u.. Another 5.00 mL of a blood sample were mixed with 0.50 mL og 1.75 ppm Pb2+. Then, this mixture was diluted to 25.00 mL and this diluted mixture gave a signal of 0.406 a.u.. What is the ppm concentration of a blood sample?
With a resolution of 500 a peak will an m/z value of 297.000 from which of the following peaks? 297.439 297.603 297.356 298.000 297.232