The given figure(all dimension are in mm) shows an thin T section of beam. 100 mm . P • 10 <--20 num The shear stress at point P(very close to the bottom of the flange) is 10 MPa.The stress at the point Q in the web very close to the flange in MPa is

Q: The couple M acts in a vertical plane and is applied to a beam oriented as shown. Determine (a) the…

A: Moment of Inertia: IZZ=2+1+11.6+0.4+0.4312 - 22×0.4312+ 2×0.4×12IZZ=2.987 in4IYY=1.6+0.4+0.42+1+1312…

Q: The wooden strut is subjected to the loading shown. Draw the state of stress at point C on an…

A:

Q: A state of stress at a point is the result of two separate actions; one produces the pure shear of…

A:

Q: The rigid bar AB is hinged at A and supported by a steel plate hanger. The hanger is fixed at C and…

A:

Q: . The beam weighs 3600N. Draw the V and M diagram. b. Assume we do not now the weight of the beam…

A: 1-If Beam weighs 3600 N then drawing of SFD and BMD 2- if Beam Weighs is not know then finding of…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.