Answered: The current amplitude I versus driving… | bartleby

Related questions

Question

The current amplitude I versus driving angular frequency wa for a driven RLC circuit is given in the figure, where the vertical axis
scale is set by Is = 4.00 A. The inductance is 216 µH, and the emf amplitude is 11 V. What are (a)C and (b)R?
0.
10
30
50
wz (1000 rad/s)
(a)
Number
i
Units
(b) Number
i
Units
I (A)

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 8.76 Volts and is running at a frequency of f = 143000 Hz. The resistor has a resistance of R = 3460 , the capacitor has a capacitance of C = 4.53e-10 Farads, and the inductor has an inductance of L = 5.24e-03 Henries. Vps Write the FORMULA for the total impedance of the circuit Ztot = R ww Write the FORMULA for the phase of the total impedance of the circuit ztot Determine the numerical value of Ztot = Determine the numerical value of OZ tot = Determine the current through the circuit: I(PEAK) = I(RMS) = . Amps Amps Determine the voltage across the inductor: VL (PEAK) = VL(RMS) = Volts Volts Determine the voltage across the capacitor: Vc(PEAK) = Vc(RMS) = Volts Volts 22 degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a flux capacitor O a phase conjugate deflector O a low-pass filter O a…
4.30 2 In the circuit the emf ɛ = 188 volts and the inductance L= 38.4 mH. What will be the magnitude of the voltage difference across the inductor at a time 14.6 ms after the switch is closed? (State answer with 1 digit right of decimal: Do not enter unit.)
An alternating source drives a series RLC circuit with an emf amplitude of 6.32 V, at a phase angle of +33.4°. When the potential difference across the capacitor reaches its maximum positive value of +5.21 V, what is the potential difference across the inductor (sign included)? Number i Units
The current in an Series RL circuit is described by the following differential equation:R i(t) + L di(t)/(dt) = V0where R is the resistance, L is the inductance, and V0 is the voltage of the source. a) Show that this is a separable differential equation, and then solve it. (Find i(t) in terms of R, L, V0). b) For a Series RL circuit with R = 50 (Ohm) and L = 10 (Henry) and the constant voltage V0 = 100 (Volt) applied at t = 0 by closing of a switch, find the current at t = 0.5 second.
Please give a detailed solution Thank-you
The charge on the capacitor of an LC circuit with capacitance C and inductance L obeys the following equation. Find the maximum current in the circuit. q= Q cos [t/(LC)0.5] Q Q/(LC) 0.5 zero QQ²/(LC) 0.5 imax 1/(LC) 0.5