Problem 3: An AC voltage source is connected to an inductor with inductance 0.059 H. The voltage source provides a time- dependent voltage V across the inductor as described by Vt) - Vo sin(ot), where vo- 257 V and co - 992 rad/s. Part (a) Find the current through the inductor, in amperes with its sign, at time t 2.4 s Part (b) Calculate the instantaneous power, in watts with its sign, that the inductor is absorbing at time t = 2.4 s. P(t)

Problem 3: An AC voltage source is connected to an inductor with inductance 0.059 H. The voltage source provides a time- dependent voltage V across the inductor as described by Vt) - Vo sin(ot), where vo- 257 V and co - 992 rad/s. Part (a) Find the current through the inductor, in amperes with its sign, at time t 2.4 s Part (b) Calculate the instantaneous power, in watts with its sign, that the inductor is absorbing at time t = 2.4 s. P(t)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

An AC voltage of the form Av = 100 sin 1 000t, where Av is in volts and t is in seconds, is applied to a series RLC circuit. Assume the resistance is 460 , the capacitance is 4.70 µF, and the inductance is 0.500 H. Find the average power delivered to the circuit. W Need Help? Read It Watch It
a) What driving frequency is required from a source powering a 71 microFarad capacitor, a 429 Ohm resistor, and a 209 milliHenry inductor in series so that the current is maximized? (give your answer in Hertz to 1 decimal place of precision) b) What is the phase difference between the current and voltage in a RLC series circuit with a 466 Ohm resistor, 114 microFarad capacitor, and a 234 milliHenry inductor, if the voltage source is oscillating with a frequency of 57 Hertz? (give your answer in degrees to 1 decimal place of precision)
A series RLC AC Circuit is connected to a 110 volt generator line with A frequency of 60Hz. If the R = 1000 Ohms , L =3 H and C =2 μF, Find a)The XL, Xc , and total Z b) line current I c) Voltage drops VR , VL , and Vc ,
Solve it asap
Given a RC circuit, R= 1.5 Ohms, C = 1.6 uF, C was charged to 6 Coulombs and then the battery was replaced by an inductor L = 12 milli-henry. Find the time in milli-sec for the charge Q(t) to fall to 2 Coulombs in the RLC series circuit
A series LCR circuit is connected to an ac voltage source. When L is removed from the circuit, the phase difference between current and voltage is . If instead C is removed from the circuit, the phase difference is again between current and voltage. The power factor of the circuit is:
An RLC circuit is driven by an AC generator of frequency w. The generator voltage can be represented by Et) - Emax cos(ur) and the current by t) - max cos(wr-p). The peak generator voltage Emax, the peak current /max- and the phase angle p by which the generator EMF leads the current are given in the figure. R E- 20 V Ina = 2.3 A = +30 The average power dissipated by the resistor is:
An inductor is connected across an AC source. show the graph of the instantaneous current through the inductor and the instantaneous voltage across the inductor?
An AC power supply with a maximum po- tential of 74 V is across a series RLC circuit, where the inductance is 18 mH, the capaci- tance is 52 nF, the resistance is 14 N. Find the resonant frequency. Answer in units of kHz. Find the amplitude of the current at the res- onant frequency. Answer in units of A. Find the amplitude of the voltage across the inductor at resonance. Answer in units of V.
A 120AC voltage (rms) is connected with an ideal inductor (0.5H) what will be the Mrs current when the frequency of the AC voltage is 60Hz.
There is an 2 H inductor, 4 F Capacitor and 500 ohm resistor in series in circuit with AC volt source max voltage 300 V and angular frequency 1300 rad/s. What is max current? Is the voltage lagging the current?
In a series RLC circuit, the AC source voltage is 70V. The voltage amplitude for the capacitor is 150V and voltage amplitude for the inductor is 90V. What is the voltage amplitude for the resistor?