System 1 System 2 The images above depict two systems with different vapor pressures. Select all of the true statements below. If both systems are at the same temperature, then they must have different chemical compositions. If both systems have the same chemical compositions, then the System 2 must have a higher temperature. If System 1 and System 2 have different chemical compositions but are at the same temperature, then System 2 has stronger IMF.

System 1 System 2 The images above depict two systems with different vapor pressures. Select all of the true statements below. If both systems are at the same temperature, then they must have different chemical compositions. If both systems have the same chemical compositions, then the System 2 must have a higher temperature. If System 1 and System 2 have different chemical compositions but are at the same temperature, then System 2 has stronger IMF.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Solutions of hydrogen in palladium may be formed by exposing Pd metal to H2 gas. The concentration of hydrogen in the palladium depends on the pressure of H2 gas applied, but a more complex fashion that can be described by Henry's law. Under certain conditions, 0.97g of hydrogen gas is dissolved in 225g of palladium metal. (The density of the resulting solution is 11.7 g/cm^3 ) a) Determine the molarity of this solution M -- - b) Determine the molality of this solution m - - - - - - - - c) Determine the percent by mass of hydrogen in this solution
A certain liquid X has a normal freezing point of 7.00°C and a freezing point depression constant =Kf 7.41·°C·kgmol−1. A solution is prepared by dissolving some iron(III) chloride (FeCl3) in 700.g of X. This solution freezes at 3.5°C. Calculate the mass of FeCl3 that was dissolved. Be sure your answer is rounded to the correct number of significiant digits.
State why oils from plant sources remain liquid at 25°C, but that of animal source is solid at the same temperature
7. Assume that the data in the table below stems from a liquid mixture that obeys Raoult's law. mole fraction p(MBenzene)/Torr p(Benzene)/Torr Total x(Methylbenzene pressure/Torr 0 0.30 0.45 0.61 0.84 1 0 7.19 (ii) 14.90 (iv) 25.02 80.00 (i) 43.57 (iii) 11.90 a) Estimate the missing values. b) Estimate the total pressure for each composition. c) Determine which component is more volatile
A solution made up of a non-volatile solute in water at 60 °C has a pressure of 130.0 torr. The partial pressure of water is 149.4 torr at 60 °C. What is the mole fraction of the solute? Xsolute = [?] Remember: Psolution = Xsolvent · P solvent X, solute Enter
The boiling point of diethyl ether, CH3 CH₂ OCH2 CH3, is 34.50 °C at 1 atmosphere. A nonvolatile, nonelectrolyte that dissolves in diethyl ether is chlorophyll. A student dissolves 11.24 grams of chlorophyll, C55 H72 MgN4O5 (893.5 g/mol), in 249.4 grams of diethyl ether. Use the table of boiling and freezing point constants to answer the questions below. Solvent Water Ethanol Chloroform Benzene Formula H₂O CH3 CH₂OH CHC13 C6H6 Diethyl ether CH3 CH₂ OCH₂ CH3 The molality of the solution is The boiling point of the solution is Kb (°C/m) Kf (°C/m) 1.86 1.99 0.512 1.22 3.67 2.53 2.02 m. °C. 5.12
5.The diagram below is an example of Two Partially Miscible Liquids (T vs Mole Fraction).Fill out the question marks with correct number of degrees of freedom. Material Equilibrium: 2 Partially Miscible Liquids At constant P: T= T • 2 components ( Liquids A and B) • p phases (liquid, gas) • No reactions • No ions / electrolytes Concentration is not specified T Number of independent components, Cing = c -r-a = 2 F=? F=? Fm? F=? T = T F=? Thus, T = Tuc F = Cind -p+ 2 F= 2-p+1 F=? F= 3-p ZA
A dilute solution of acetic acid produced by fermentation and oxidation of natural carbohydrates is called vinegar. If 48.6 g of acetic acid, CH3COOH , are dissolved in 65.3 g of water, what is the mole fraction of acetic acid? Atomic Mass: C=12.01 ; H=1.008 ; O = 16.0
If 1000 L of gasoline has spilled into the street (MW=117 g/mol, density=0.7 g/mL which is true for octane) then firefighters add a lot of a material that dissolves into it that reduces the vapor pressure (liquid octane doesn’t burn, only the vapors). The firefighters put 500 kg of a material into the gasoline and reduced its vapor pressure from the pure partial pressure of 10.0 kPa down to 8.0 kPa. What is the molecular weight of the material that was added? (hint: use Raoult’s Law, which relates changes in pressure to the mol fractions.
During the solution process, there are four different interacting forces involved: Hydrogen Bonding, Dipole-Dipole Forces, Van Der Waals forces, and London Dispersion Forces. Briefly explain each.
Water is not the only chemical contaminant that can be removed from liquids and gasses using molecular sieves. Ammonia, for example, can be removed from gaseous samples using the same 3Å molecular sieves that we used to remove water from ether. Other common contaminant gasses like sulfur dioxide, dihydrogen sulfide and ethylene, however, cannot be removed using 3Å sieves. They can only be removed using 4Å molecular sieves. Explain why this is so.
Consider the following reaction: 2HCl(aq)+Sr(OH)2(aq) → 2H2O(l)+SrCl2(aq) Enter the complete ionic equation for this reaction. Express your answer as a complete ionic equation. Identify all of the phases in your answer.