ST4D.3 - The vapor pressure of a substance at various mole fractions in a mixture were found to be as follows. Estimate the Henry's law constant [in MPa] for the substance for the particular solvent of this mixture. USE ALGEBRA instead of a graphical approach. Don't forget there's one more data point that isn't listed in the table (the origin). 0.0023 0.01020.0182| P/kPa 27.7 48.8 99.7

ST4D.3 - The vapor pressure of a substance at various mole fractions in a mixture were found to be as follows. Estimate the Henry's law constant [in MPa] for the substance for the particular solvent of this mixture. USE ALGEBRA instead of a graphical approach. Don't forget there's one more data point that isn't listed in the table (the origin). 0.0023 0.01020.0182| P/kPa 27.7 48.8 99.7

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

5) The volume of several aqueous copper sulfate (CuSO4) solutions was precisely measured at SATP. All of the solutions were made by adding copper sulfate to 100.00 g of water. ncopper sulfate (mol) Vsolution (mL) 0 100.18 0.0330 100.16 0.0696 100.36 0.111 100.81 0.156 101.62 First, estimate the concentration-dependent partial molar volume of copper sulfate in water by taking finite differences. Second, fit the data to a hyperbola and take a derivative of the hyperbola to accurately calculate the partial molar volume of copper sulfate in water at each concentration. Interpret the partial molar volume at infinite dilution - what must copper sulfate be doing to the nearby water molecules?
Two volatile liquids A and B form an ideal solution. The vapor pressures for the pure liquids (at T = 50.0 °C) are pA° = 418. torr and pB° = 226. torr. For a solution at T = 50.0 °C, it is found that pA = pB. Based on this information, find XA, the mole fraction of A in the liquid phase for the solution.
10.The diagram below is an example of Liquid-Solid-Temperature Composition Phase Diagram of Completely Immiscible Solids. The left vertical line is B rich while the right vertical line is A-rich.Define the phases present in the region from A to E. |LS – TZ Phase Diagram: Completely Immiscible Solids This LS- TZ phase diagram is for completely immiscible solids. XA = 0 X = 1 XA = 1 X = 0 T =T?, At the solid phase, the system consists of 2 distinct solids A and B. T= T At the liquid phase, the system is called a melt. At the 2- phase regions, the system consists of either pure solid A or B and the melt. The composition of A in the melt can be traced along the liquidous curve. T T= Teu E At the solidous line, the system consists of solids A, B, and melt in which the composition of A, or y =1 Z, can be determined. Ya = 0 Zeut,a Za YA =1 Yn = 0 At the eutectic composition, minimum temperature is required to melt the mixture.
The vapor pressure of pure "Freon 11" and pure "Freon 12" at 25°C. Are 15 lb/in2 and 85 lb/in² respectively. In the preparation of a pharmaceutical aerosol these 2 propellants were mixed together in the mole ratio of 0.6 to 0.4. what is the partial VP of freon 11 and freon 12. What is the total VP of this mixture at 25 deg cel
Explain how a solution of two volatile components with strong solute-solvent attractions deviates from Raoult's law.
A CHM 126 student performed the "Determination of Molar Mass by Freezing Point Depression" experiment. He started the experiment by measuring the mass and freezing point of the pure solvent with minimal error. Instead of quickly finishing the experiment, he took a lunch break. After returning from lunch, he noted that the solvent had absorbed some impurities from the atmosphere. He went ahead and performed the rest of the experiment anyway. Assuming a negligible (very minor) change in the mass of the solvent after absorbing impurities, which of the following choices contains only correct statements: because of the experimental error, the measured ATwill increase, the measured molality will increase, and the measured molar mass will contain no additional error because of the experimental error, the measured ATwill decrease, the measured molality will decrease, and the measured molar mass will decrease because of the experimental error, the measured ATwill decrease, the measured molality…
Estimate the molality (mol/kg) of oxygen in water at 25 °C and given that the partial pressure of O2 is 21 kPa near sea level (1 atm). (b) What would the solubility of oxygen be in water [O2] in (mmol/L)? (c) What is the solubility of [O2] in (mg/L) at that temperature? Henry’s constant for oxygen gas KO2 = 7.9 x 104 kPa kg mol-1.
Please don't provide handwritten solution .....
Give detailed Solution with explanation needed (no need Handwritten answer
The vapor pressure of pure ethanol is 48 torr at 20°C, while that of pure diethyl ether is 450 torr. The vapor pressure of diethyl ether is 260 torr in the diethyl ether-ethanol mixture when the mole fraction of ethanol is 0.6 in the mixture. Is this an ideal mixture? If not, what is it?
Quinine is a natural product extracted from the bark of the cinchona tree, which is native to South America. Quinine is used as an antimalarial agent. When 1.90 g of quinine is dissolved in 25.0 g of cyclohexane, the freezing point of the solution is lowered by 4.88 °C. Look up the freezing point and Kf constant for cyclohexane in the Colligative Constants table. Calculate the molar mass of quinine. molar mass: g/mol
An experiment was conducted to determine the effect of glucose on the freezing point of water. Experimental data showed thatthe freezing point depression of water in solution was –2.6°C when 1.0 g of glucose was dissolved in 10g of solvent. Calculatethe expected freezing point for such solution and compare the expected freezing point to the value found experimentally. Give aplausible explanation for any discrepancies. (M.W. of glucose= 180.16g/mol; i=1). Show all your work.