State Charles's Law. A receiver contains 20 kg of air at 3200 kN/m sq. gauge and 16 degrees C . Calculate the new pressure and heat energy transfer if air is heated to 35 degrees C . Neglect any expansion of the reservoir. Take R for air = 0.287 kJ / kg / ° K ,Specific heat at constant volume Cv = 0.718 kJ / kg / ° K ,Atmospheric pressure = 100 kN/m²

State Charles's Law. A receiver contains 20 kg of air at 3200 kN/m sq. gauge and 16 degrees C . Calculate the new pressure and heat energy transfer if air is heated to 35 degrees C . Neglect any expansion of the reservoir. Take R for air = 0.287 kJ / kg / ° K ,Specific heat at constant volume Cv = 0.718 kJ / kg / ° K ,Atmospheric pressure = 100 kN/m²

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A piston and cylinder device contains 0.15 kg of water at 25◦C (state 1). As shown in the figure, the piston weighs 500 N and has a cross-sectional area of 0.01 m2. Atmospheric pressure is 100 kPa. Heat is transferred to the cylinder from a reservoir at 200◦C, raising the piston. When the piston touches the stops, the volume inside the cylinder is Vmax= 0.165 m^3 (state 2). Heat continues to be transferred until the control mass reaches the boundary temperature (state 3). Determine: a) The initial pressure of the water (kPa) b) The temperature (Celsius) when the piston hits the stops c) The total work (kJ) d) The total heat transfer (kJ) e) The total entropy production for the entire process (kJ/K)
You live in a remote cabin at ground level. You have a broken thermometer, but you know your barometer works. When you arrive at the cabin you knew the temperature was 10 C. When you arrived you measured the pressure to be 101 kPa at ground level, and 90.9 kPa at an altitude of 1km off the ground (both at 10 C). Today you measured the pressure to be 101 kPa at the ground, and 89.9 kPa at an altitude of 1km off the ground. What is the temperature today (it was the same at both altitudes)? 9.0 C 11.0 8.0 C 12.0 C
thermodynamics
1. Consider the following diagram. The fluid flowing in the pipe is oil (SG = 0.830). The fluid in the manometer is water (SG = 1.00). Water, pw = 1000 kg/m³ 7 cm Oil, p = 830 kg/m³ a. Determine P₂ - P₁ in kPa. b. Determine the direction of flow. (Left to right, or right to left). Explain why this is the case. c. The height of oil between the manometer and the pipe is unknown. Explain how you can still solve the problem without knowing this height. Would this height ever matter? Hint: consider practical issues of design. Could the height be 0 cm? Could it be 1000 cm?
a thermodynamics system contains 10 m^3 of air at 300 kPa and 127 degrees celsius. the weight of this system in newton is?
5 kg of steam occupies a volume of 10 m^3. Find the quality if the temperature is measured at 75 C.
ft-lb 7. One pound of air R = 53.3 is compressed isothermally in a closed system from ib-R 15 psia and 80°F to 90 psia. Compute the heat transfer.
A special tyre was inflated at 2 bar gage pressure on Earth, where the atmospheric pressurewas 1013 hPa and the acceleration of gravity 9.81 m/s2.The tyre was then transported without pressure leakage on Mars, where the atmosphericpressure was 6 mbar and the acceleration of gravity 3.7 m/s 2.Questions:(a) Measuring on Earth the tyre pressure with a mercury manometer, what was themanometer reading in mm?(b) Measuring on Mars the tyre pressure with a mercury manometer, what was themanometer reading in mm?
A cylindrical tank is fully filled with water . In order to increase the flow from the tank, an additional pressure is applied to the water surface by a compressor. For P0 = 0, P0 = 5 bar, and P0 = 10 bar, calculate the hydrostatic force on the surface A exerted by water.
For the cylinder below, the final volume inside cylinder (V3) in (Liter) ;is A frictionless piston-cylinder device initially contains 0.2 kg of steam at 400 kPa, 300 °C. Now the steam loses heat to the surroundings and the piston moves down, hitting a set of stops at which point the cylinder contains saturated liquid water. The cooling continues until the cylinder contains water at 135 °C. |frictionless Piston /// / Steam ,m=8-2 kg Pi= 400 kPa Ti= 300°C (sat. lig.)2 T3 = 135 C stops Below 0.1 O Between 0.1 and 0.2 O Between 0.2 and 0.3 Above 0.3 O
the specific heat capacity of the system during a certain process is given by Cn(0.4+0.004T) kJ/kg deg. celcius. if the mass of the gas is 6kg and its temperature changes from 25 def. celcius to 125 def. celcius find the mean specific heat of the gas
The subject is thermodynamics 2