Q5. Assume that the following permanent outage data has been given for the system shown below:SystemComponentOutage Rate Average138kV(outages/yr) Repair69kVTime(h)66138Kv breakers138KV Line138/69KV transformer69KV breakers69KV bus0.0058to0.6270.01190.004510360440.011Assuming that 132Kv bus is 100% reliable and determine the following:a. Total failure rate for one parallel line.b. Total mean time to repair for one parallei iine.c. Total failure rate of the system.d. Total mean time to repair of the system.

(a) In the given figure each parallel line consists of 138kV breaker, 138 kV line, Transformer and…

Q5. Assume that the following permanent outage data has been given for the system shown below: System Component Outage Rate Average (outages/yr) Repair Time(h) 138KV 69kV 138KV breakers 138KV Line 138/69Kv transformer 69Kv breakers 69Kv bus 0.0058 66 0.627 10 0.0119 0.0045 0.011 360 44 Assuming that 132Kv bus is 100% reliable and determine the following: a. Total failure rate for one parallel line. b. Total mean time to repair for one parallel iine. c. Total failure rate of the system. d. Total mean time to repair of the system.

Q5. Assume that the following permanent outage data has been given for the system shown below: System Component Outage Rate Average (outages/yr) Repair Time(h) 138KV 69kV 138KV breakers 138KV Line 138/69Kv transformer 69Kv breakers 69Kv bus 0.0058 66 0.627 10 0.0119 0.0045 0.011 360 44 Assuming that 132Kv bus is 100% reliable and determine the following: a. Total failure rate for one parallel line. b. Total mean time to repair for one parallel iine. c. Total failure rate of the system. d. Total mean time to repair of the system.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Power flow analysis is used for __________________ in power system. a. Stability Analysis b. Future Expansion c. Fault Analysis d. Symmetrical fault analysis
The fault current level of a circuit breaker used in a transmission line with phase voltage 2.2 kV and breaking capacity 60 MVA is ......................kA. Complete the answer.
machine The per unit impedance of a synchronous is 0.242. If the base voltage is increased by 1.1 times, the per unit value will be a) 0.266 c) 0.220 b) 0.242 d) 0.200
(Q.2) For the following network, calculate the fault currents (IF1, IF2, IF3 and IF.) in pu and in kA, and fault MVA (ie. short-circuit level) at the indicated locations. Internal reactance of generators are j0.9 pu. Base quantities: 11 kV, 400 MVA on the generator side. 113.3 kV 4 MVA, 7% j0.5 2 j0.4 2 300 A 200 A 11 KV 250 MVA
-The symmetrical fault occurs in the terminals of the synchronous generator. Find the direct axis transient reactance of the synchronous generator under the transient period for the data given below, Leakage reactance(Xl)= 1.3 ohm, Armature reactance (Xad)= 1.6 ohm and field reactance (Xf)=5.4 ohm. 2.10 2.53 1.23 4.00 -The existing condition of the power system can be determined by _____________ analysis. Short Circuit Stability Power Flow Transient
please solve it before 10 min
Most buses in a typical power-flow program are a.voltage controlled bus b.PQ bus c.PV bus d.Slack bus 2-The power-flow problem is the computation of voltage magnitude and phase angle at each bus in a power system under balanced three-phase steady-state conditions. False True 3-The following sequence currents were recorded in a power system under a fault condition Ipositive=j1.5pu, Inegative=–j0pu, Izero=– j0pu. The fault is a.Three-phase b.Double Line to ground c.Line to ground d.Line to line 4- he following sequence currents were recorded in a power system under a fault condition Ipositive=j1.5pu, Inegative=j0pu, Izero=j0pu. The fault is a.Three-phase b.Double Line to ground c.Line to ground d.Line to line i uploded the houndots (book )here :https://seomidea.com/hct/nu.pdf
Line to line to line fault is an asymmetrical type of fault in power system which occurs very frequently true false
In the shown below power system, both generators G1 and G2 emf’s are equal.All the system data are shown on the system diagram.a) Draw the system diagram in per unit using (MVA)base = 75 and (KV)base =20 KV in the generators side.b) Calculate the three-phase balanced short circuit current (If) at busbar 3 inAmpere and the fault level (MVA)sc in MVA.c) If the fault at busbar 3 is a line-to-line fault, calculate the fault current inAmpere and the fault level (MVA)sc in MVA.
(1.) b) E/(Z° +Z' +Zu² +3Z,) d) E/(Zu² +Z,) In short circuit studies, the positive sequence current for symmetrical fault is ) E/(Z' +Z,) µ' +Zm² +z,) kk kk kk kk A7 2 |c) E/(z, 1 kk kk kk
The figure shows the single line diagram of a single machine infinite bus system. O Infinite bus The inertia constant of the synchronous generator H = 5 MW-s / MVA. Frequency is 50 Hz. Mechanical power is 1 pu. The system is operating at the stable equilibrium point with rotor angle ō equal to 30°. A three phase short circuit fault occurs at a certain location on one of the circuits of the double circuit transmission line. During fault, electrical power in pu is Pmax sin ō. If the values of ō and do / dt at the instant of fault clearing are 45° and 3.762 radian/s respectively, then Pmax (in pu) is_