Primary sludge with a flow (Q) of 160 m³/d will be digested in a mesophilic anaerobic digester. The TS content and VS/TS ratio of the sludge is %4 and 0.75, respectively. VS destruction efficiency is %40. If the biogas is utilized in a CHP unit with an electric conversion efficiency of %38, calculate how much electricity can be generated daily? Assumptions: Density of sludge = 1000 kg/m³, cOD:VS = 1.65, Methane yield = 0.35 m³/kg CODremoved, 1 m³ methane (STP) = 10 kWh Uploading your work is mandatory for this question!

Primary sludge with a flow (Q) of 160 m³/d will be digested in a mesophilic anaerobic digester. The TS content and VS/TS ratio of the sludge is %4 and 0.75, respectively. VS destruction efficiency is %40. If the biogas is utilized in a CHP unit with an electric conversion efficiency of %38, calculate how much electricity can be generated daily? Assumptions: Density of sludge = 1000 kg/m³, cOD:VS = 1.65, Methane yield = 0.35 m³/kg CODremoved, 1 m³ methane (STP) = 10 kWh Uploading your work is mandatory for this question!

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A treatment plant treats water at an average daily flowrate of 2.7 m3/s. The water is chlorinated before it flows into a 15000 m3 reservoir. The water flowing into the reservoir has a chlorine concentration of 3 mg/L. Chlorine decays at a rate of 0.24 h-1. Assume the reservoir is well-mixed and the system is at steady-state condition. (a) Determine the chlorine concentration at the discharge point of the reservoir. (b) The treated water flows from the reservoir into a transmission main. The pipe carrying the water has a diameter of 2 m and flows full. In the transmission main, chlorine decays at a rate of 0.19 h-1. Determine the concentration of chlorine 2 km from the treatment plant.
A wastewater treatment plant is operated at a steady state DO concentration of 1.5 mg/L. If the temperature of the wastewater is measured at 10 °C, a= 0.8 and B = 0.95 and the KLa reported by the aerator manufacturer at 20°C in tap water is 5 hrt, estimate the oxygen uptake rate (in mg/L-min) in the aeration basin. You can assume 0=1.024. If the aerator's oxygen transfer efficiency is 24%, what would be the mass of air (kg) required per hour in a 8500 m³ tank? What volumetric flow rate would you have to supply (m³/hr)? 3.
A waste sludge flow of 40 m³/day is gravity thickened in a circular tank with a diameter of 6.8 m. The solids concentration is increased from 4.5% to 7.5% with 85% suspended- solids capture. Calculate the solids loading in kg/m² d and the quantity of thickened sludge in m³/d.
A continuous flow through the activated sludge process treats 1500 m3/day flowwith a BOD of 250 g/m3. Given parameters are Y=0.6, Maximum sp. substrate utilizationrate=2.0 g BOD/g cells-day, decay = 0.1/day and Ks= 4. Make typical assumptions ofactivated sludge as needed.a) Calculate the mean cell residence time and reactor volume for 99 % BOD removal.b) Repeat these calculations for a system that recycles 50 % of cells in 10 % of theinfluent flow
Please give me both a and b solutions A settling tank with (L=6m, W=4 m , H= 4 m) treats a waste stream (60,000 l/min) and removes suspended solids with 200 micrometer diameter that have a settling velocity of 0.04 m/s. a. What is the removal efficiency of his tank? b. If a 100% removal efficiency is to be achieved, How long should the settling tank be?
An activated-sludge system is to be used for secondary treatment of 15,000 m3/d of municipal wastewater. After primary clarification, the BOD is 130 mg/L, and it is desired to have not more than 5 mg/L of soluble BOD in the effluent. A completely mixed reactor is to be used, and pilot-plant analysis has established the following kinetic values: Y = 0.6 kg/kg, kd = 0.07 d-1. Assuming an MLSS concentration of 2,750 mg/L and an underflow concentration of 11,000 mg/L from the secondary clarifier, determine the followings. [Use θc (MCRT or SRT) = 10 day.] 5.1. The volume of the reactor. 5.2. The mass and volume of solids that must be wasted each day. 5.3. The recycle ratio. Hint: θc = VX/QwXu : MCRT (mean cell-residence time) [or SRT (solids retention time)]; average time microbes spend in reactor = ratio of total biomass in reactor to biomass wasted per given time; currently most commonly used design parameter F/Mv: inversely proportional to SRT; ≈U (cell's specific substrate…
A rapidly mixed tank consists of a treatment unit used to disinfect a solution. The solution enters the 2000 m tank at a rate of 0.4 m/s. The pollutant contains 7.94 CFU per liter and has no 0 mg/l of chlorine. The treatment unit uses a stock solution containing 750 mg/L which is released a rate that will cause the chlorine concentration in the tank to be 2 mg/L. The chlorine reacts with the water in such a way that it is depleted at a rate (in mg/L-h) given by ra = ( -0.45/ h) Ca. When exposed to chlorine, the bacteria die off at a rate (in cells/L-s) given by: Cet Cbact Tbact Img + Ca a) Calculate the required flow rate in L/s of the stock solution when the system is operating at steady state, including a schematic of the system. b) Determine the bacterial concentration (in CFU/L) thar should be expected in the effluent from the tank?
. A water plant with a flow of 20,000 m³/day uses 25 mg/L alum as Al,SO, 18H₂O. The sludge produced consists of the alum precipitates plus 20 mg/L of other material removed by the process. Determine the dry mass of sludge produced per day.
The 750-bed Associated Center of Medical Excellence (ACME) Hospital has a small activated sludge plant to treat its wastewater. The average daily Medical Center discharge is 1,250 L per day per bed, and the average soluble BOD5 after primary settling is 450 mg/L. The aeration tank has effective liquid dimensions of 10.0 m wide by 25.0 m long by 3.5 m deep. The plant operating parameters are as follows: MLVSS = 2,750 mg/L MLSS = 1.25 (MLVSS) Settled sludge volume after 30 min = 250 mL/LDetermine the following: aeration period, F/M ratio, SVI, solids concentration in return sludge.
1. Draw control volume diagram of reactors for each of the following conditions and write down the mass balance equations using different notations shown in figure: C, Qout Cin Qin V, C Reaction rate constant =k Figure: Sample CMFR/CFSTR showing influent and effluent flows, volume, reaction rate components. a) Steady state CMFR/CFSTR with conservative pollutant b) Steady state CMFR/CFSTR with non-conservative pollutant having first order growth rate c) Non-steady state CMFR/CFSTR with non-conservative pollutants having second order decay rate
The treated waste water is being discharged into a river that has a temperature of 15°C. The BOD rate constant determined in the laboratory for this mixed water is 0.12 per day (base e) at 20°C (Temperature coefficient, 1.047). What fraction of maximum oxygen consumption will occur in first four days?
Determine the pollutant removal efficiency (%) in an ideal plug flow reactor having hydraulic detention time τ=5hr for a hazardous chemical having a first-order decay rate constant of k=0.40hr−1. Hydraulic detention time = 5 hours.