Calculate the PM-10 emission (in µg/m3) from the following data Average particle size = 1 x 10^ -5 m Particle density = 2300 kg/m^3 Inlet loading = 1.87x106 particles per cubic meter of air Efficiency of removal = 0.959

Calculate the PM-10 emission (in µg/m3) from the following data Average particle size = 1 x 10^ -5 m Particle density = 2300 kg/m^3 Inlet loading = 1.87x106 particles per cubic meter of air Efficiency of removal = 0.959

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A pollutant entered into a confined aquifer of 5 m thick and porosity 25%. If the seepage discharge…

Q: In a titration of dilute sulfuric acid, H2SO4, with sodium hydroxide, NaOH, how many milliliters…

A: The chemical reaction is given as H2SO4 (aq) + 2NaOH(aq) --> Na2SO4(aq) + 2H2O(l)

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Given, particle cut diameter,dpc=5 μmParticle size % mass in that size range 3µm 10.0% 5 µm 20.0%…

Q: A dust with a density of 2 g/cm3 is being released from a stack in an urban area with an effective…

A: According to the Pasquill-Gifford equation, the deposition rate is related to the stability class,…

Q: Following data are given for water sample taken from irrigation water: [Na+] = 250 mg/ml [Ca2+] =…

Q: Problem 6.1 A small stream was found to be contaminated with Lindane, a pesticide known to cause…

A: Given data - Qi = 100 cm3/sec Ci = 50 mg/L For station (1) ,Cdye = 10ug/l CL2 = 0.5 ug/l For station…

Q: Determine the ultimate 1st stage BOD. Calculate the 1-day BOD. What would be the 5 day B0 if the…

A: 5 day BOD5 at 20°C = 150 mg/lk=0.20day-1Let BOD ultimate = L0 thenBOD5=L0(1-e-kt)

Q: 2. A suspension of particles with a particle density of 2796 kg/m³ is settling in water with a…

A: Given Specific gravity G = 2796/1000 = 2.796 Kinematic viscosity of water at 20 ° C = 1.004 × 10 -6…

Q: A river is traveling at a velocity of 0.06 m/s. At x = 0 km, the river has a dissolved oxygen…

A: Introduction : Biochemical oxygen demand (BOD) : BOD is a measurement of the quantity of oxygen…

Q: During an analysis to determine the fractions of solids in 100 ml of a sample, the weights were…

A: INTRODUCTION: Total solid is the sum of dissolved and suspended solid present in sample. The…

Q: A container of Atrazine (500 g) is dumped into a river 2.3 km upstream of a municipal water intake…

A: Given, M = 500 gm or 0.5 kg L = 2.3 km or 2300 m A = 5.7 m2 Q = 8.25 m3/s D = 0.1 m2/s

Q: Assume the efficiency of the cyclone of attached Problem is 90%, and calculate the new efficiency if…

A: Given; μg=0.06 kg/m.hrμg=1.67×10-5 kg/m-sAnd,W=0.25D=0.250.5=0.125m

Q: A two-story home with infiltration rate of 0.5 ach has 100 m2 of floor space per floor and a total…

Q: A pollutant entered into a confined aquifer of 5 m thick and porosity 25%. If the seepage discharge…

Q: calculate daily dose of benzo(a)pyrene of adult via ingestion, whereC = Contaminant concentration…

A: Answer We are given Where C = Contaminant concentration = 1.5 mg/kg IR = Intake rate = 20 kg/day RAF…

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Given data:- The given cyclone has of particle cut diameter which means, dpc=5 μm The given particle…

Q: At what advection velocity does a pulse of dissolved benzene move through organic-rich wetland soil…

Q: The data below by Hermanowicz et al. (1999) slow the decay of ozone residual in treated water from…

A: Data given Contact time, Concentration of ozone residual in treated water Find : Ct that can be…

Q: Calculate the total amount of time required to reduce the number of particles by 60% for macroscale…

A: Answer To calculate the total amount time required for reduction of number of particle by 60% for…

Q: A river, flowing at 1.5 m3/s, is polluted with the pesticide permethrin and flows into a lake (100 m…

A: Given, Q = 1.5 m3/s or 5400 m3/hr V = 100m x 100 m x 2.5m = 250000 m3 A = 2.7 m2 t1/2 = 19 hrs

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Given, a cyclone with dpc of 5 µm Particle size (dj) % mass in that size range 3 μm 10 5 μm…

Q: BOD Suspended solids chemical oxygen demand 270.7778 mg/l 312.3143 mg/l 585.8571 mg/l

A: Given Data:

Q: Solve the question in the image.

A: Over all efficiency for the control device can be given asηo=∑mass ratio×efficency %

Q: A land is contaminated by bisphenol A (10℃ in the subsurface). At the spilling location, the…

A: Solution Given Data The concentration of bisphenol A= 200 ppm

Q: Domestic wastewater has a reaction rate coefficient of 0.3 1/d at 20° C. The ultimate BOD of the…

Q: Given following data, calculate a. Average specific gravity b. Average absorption value

Q: (a) What is the maximum contaminant concentration that is expected at a location 2 km downstream of…

A: a) - Discharge(Q) = 2m3/s B= 5m D= 1m Velocity = QB*D V= 25*1 = 0.4m/s Time taken to travel…

Q: particulate sample in an air stream is represented by the following weight percent distribution:…

Q: 8.7. Plot an adsorption envelope with error bars using the data in the table presented here, which…

A: Given data for the following nNO3 (mmol/kg) pH nNO3 (mmol/kg) pH 6.6 ± 0.3 2.5 3.5 ± 0.3 3.9…

Q: True or False: When comparing two samples of equal mass, the number of particles in each sample is…

A: Answer:- 1. The given statement is true. The number of particles and number of moles are directly…

Q: The flow of a river is 1.5 m3/s, the river is polluted with the pesticide permethrin and flows into…

A: The given data for the problem is: The flow rate of a river is 1.5 m^3/s The river is polluted with…

Q: The specifications of an electrostatic precipitator system used for collection of particles 150 μm…

A: The specifications of an electrostatic precipitator system used for collection of particles150 μm…

Q: Families in a community in a developing country use large, 200.0 L drums to un-treated surface…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: An engineer is attempting to estimate a) the hydraulic retention time (HRT), and b) the volume of a…

A: Given the information:1. The initial Br- concentration is 100 mg/L.2. After 60 days, the Br-…

Q: The secondary NAAQS for SO2 is 0.5 ppm (for a 3-hour averaging time). Calculate the equivalent…

A: Given:- The secondary NAAQS for SO2 is 0.5 ppm To find:- The equivalent concentration in pg/m3

Q: Chemistry The experimental test shows that for the whole particle size range, the average effective…

A: ESP is an apparatus used to remove pollutants from the smoke generated by industries. An…

Q: A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the…

A: Answer We know that overall removal efficiency for air stream is given by ηo=∑ηj*mjM ηj =…

Q: Fifteen kilograms of contaminant is spilled into a stream 5 m wide and 1 m deep. The flow in the…

A: Given, Width (b) = 5m Depth (d) = 1 m Flow rate (Q) = 2 m3/s KL = 3 m2/s k = 50/day

Q: If the saturation concentration of O2 in water is 9.2 mg and the initial concentration is 2.1 mg/L.…

Concept explainers

Total Energy Consumption

The term energy consumption signifies the consumption of electricity. Energy consumption as electricity is a primary demand for households, factories, industries, complexes, and commercial places. According to a report, the total U.S. energy consumption for 2018 was 101 BTU (British Thermal Units). It accounted for 17% of the total energy consumption of the world. The total energy demand for the U.S. as oil equivalent was estimated to be about 6804 kg of oil equivalent.

Question

Calculate the PM-10 emission (in µg/m³) from the following data

Average particle size = 1 x 10^ -5 m

Particle density = 2300 kg/m^3

Inlet loading = 1.87x10⁶ particles per cubic meter of air

Efficiency of removal = 0.959

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

6
A cyclone has a dpc of 5 µm, what is the overall removal efficiency for air stream that has the following particle size distribution: Particle size % mass in that size range 3µm 10.0% 5 µm 20.0% 15 µm 30.0% 20µm 40.0%
A seawater sample has a chlorinity of 2.8 percent. Calculate its salinity in parts-per-thousand (ppt) using Forchhammer’s principle. Show your calculations.
Find out after how much time only 2% chlorine will remain in the water sample if its half-life is 6 days.
An unseeded BOD test is conducted on a polluted surface water sample by adding 100 ml to a 300-ml BOD bottle and filling with dilution water. The initial dissolved oxygen measured 8.2- mg/l, and the final concentration after five days of incubation at 20 Celsius measured 2.9 mg/l. Calculate the BOD.
Concentrations of Pb, Cu, and Mn in rainwater collected in Minneapolis were found to be 9.5, 2.0, and 8.6 ug/L, respectively. Express these concentrations as nmale/L.
A single-story home with infiltration rate of 0.5 ach has 200 m2 of floor space and a total volume of 500m3. If 0.6 pCi/m2-s of radon is emitted from the soil and enters the house, estimate the steady-state indoor radon concentration. Picocurie is a common unit for radon measurement, use Table 7.14 as necessary. Report answers in pCi/L.
What diameter would a circular clarifier have to be to remove 50 μm particles with 75% efficiency from a 4 MGD (million gallon per day) flow? Assume the particle specific gravity is 1.5 and the temperature is 10°C. Answer: 18 m
(a) Sketch a typical Streeter-Phelps oxygen-sag curve and state its limitations. dD (b) The rate of change of the dissolved oxygen deficit, ", is the net effect of the rate of dt re-aeration, given as – k D, and the rate of oxygen utilization, given as k,Le , where ko, ka and Lo are the re-aeration rate constant, the decay constant, and the ultimate BOD, respectively. Write the expression for the rate of change of the dissolved oxygen deficit. Then argue why the maximum deficit, De, occurring at the critical time, to, is given by: ka Le D. k.
(₁ ) A PM10 sampler was operated for a period of 24 hours at a flow rate of 0.7 m³/min. The filter tare weight was 1.7911 g, and the dried filter weight after sampling was 1.8521 g. Calculate the PM10 concentration in µg/m³.
The following data was obtained from a field study to determine how a toxic pollutant reacts. Determine the order reaction and the rate constant, with proper units. day time (d) 0.25 0.5 1 2 2.5 3.5 concentration (mg/L) Ct (mg/L) 15 12 10 8. 3 1 0.5 0.02 3.
The base of a river in in contact with the top of an aquifer. A truck carrying bags of powdered cyanide is on a bridge crossing the river when a large bump causes one of the bags to fall into the river. The water in the river suddenly becomes polluted by the cyanide with a concentrations of 6.78 mg/L. The aquifer has an average linear ground water velocity of 0.256 m/day. Laboratory analyses data indicates that longitudinal dispersivity can be found through the equation: a = 0.86(log Ls)² where Ls is the length of the straight line path between two points along the path of transport. Find the longitudinal dispersion 108 m downstream from the bridge. Assume that the cyanide solute has a diffusion coefficient of 3.6 x 10 -5 m²/s and the aquifer has a coefficient related to tortuosity (o) equal to 0.8. Find the coefficient of hydrodynamic dispersion.