The specifications of an electrostatic precipitator system used for collection of particles 150 μm in diameter are given below: Height of plates = 7.5 m Length of plates = 6 m Number of plates = 5 Gas flow rate = 19.5 m³/s Drift velocity = 0.18 m/s The collection efficiency of precipitator (in %) is

Q: (i) Calculate the Molarity, and mg/l as CACO3 for 200 mg/I H3PO4

A:

Q: Water containing 50 mg/L of monodisperse (uniformly sized) spherical particles of diameter 100 μm…

A:

Q: Question #6: In a water sample, the following elements are detected. Calculate the total hardness,…

A:

Q: 4. Calculate the Reynolds Number for 6-inch (diameter) production tubing assuming West Texas Crude…

A: Since; Q1 = 500 STB / day = 5005.434 * 105=9.20*10-4 m3 /s

Q: What are the negative effects of excessive hardness in water? What is the unit of hardness  and why…

A: The excessive hardness in water can interfere with the action of detergents and soaps and it can…

Q: a 12. circular sharp-edged orifice in the A calibration test of a mm vertical side of a large tank…

A: Diameter of orifice =12.7mm Time(t)=81sec

Q: h=1.4, w =3,L= 4.7 alumium block  / brass block h=1.4, w =1.7l=2.4   densities  (p alumiun 2700kg/m3…

A:

Q: The fluid displacement technique is used to find the porosity of a certain core sample. The sample…

A:

Q: In a falling head permeameter test, the head drops by 5 cm in 10 minutes from the initial head of 30…

A:

Q: Three tanks containing brine are shown below. Construct a model for the number of pounds of salt…

A:

Q: The theoretical yield coefficient can be estimated from the observed yield coefficient if the…

A: Cell mass and item arrangement by microorganisms can be portrayed quantitatively by yield…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.