The mean indoor airborne chloroform (CHCI,) conc. in a room was detemined to be 0.4 ug/m3. Use the following data, T = 293 K, P = 1 atm, R = 82.05 x 10-6 atm- m3 /mol- K. Atomic weights: C = 12, H = 1, CI = 35.5. %3D This concentration expressed in parts per billion (volume basis, ppbv) is equal to

The mean indoor airborne chloroform (CHCI,) conc. in a room was detemined to be 0.4 ug/m3. Use the following data, T = 293 K, P = 1 atm, R = 82.05 x 10-6 atm- m3 /mol- K. Atomic weights: C = 12, H = 1, CI = 35.5. %3D This concentration expressed in parts per billion (volume basis, ppbv) is equal to

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A beaker is filled with a liquid up to the mark of one litre and weighed. The weight of the liquid…

A: Given :- weight of liquid = 6.5 N Volume of liquid = 1L To find :- specific gravity of…

Q: The specific gravities of solids and carrier fluids of a slurry are usually known, but the specific…

A: Specific gravity is defined as the ratio of the density of solids in the slurry and the density of…

Q: In a titration of dilute sulfuric acid, H2SO4, with sodium hydroxide, NaOH, how many milliliters…

A: The chemical reaction is given as H2SO4 (aq) + 2NaOH(aq) --> Na2SO4(aq) + 2H2O(l)

Q: For the particles in problem 3, determine the percent removal in a sedimentation basin with a depth…

A: Answer We are given Before flocculation Average diameter = 20 μm Specific gravity S = 2 After…

Q: 7.15. Determine the mass-transfer coefficient for benzene using the follow- ing data. State any…

Q: You need to soften water at a 20 MGD potable water treatment facility using lime (Ca(OH)2) and soda…

A: Data Given: Concentration Molecular Weight CO2 6 mg/L 44 g/mol Ca2+ 20…

Q: Y-Y 2) Dr = (x100%) Y -Y, max

A: Solution Relative density for cohesionless soil Dr=emax-eemax-eminWheree→emin ( Densest state)…

Q: EA two-stage distiller system is used to remove TDS from sea water as shown in the figure. The…

A: Given:- two stage distiller To find:- concentration

Q: www (pH=7). What is the total hardness (TH) of water that contains the following ion concentrations…

A: Given:Required:Total hardness of water

Q: The amount of chlorine residual remaining when gases start evolving during disinfection and when…

A: The amount of chlorine residual remaining when gases start evolving during disinfectionand when they…

Q: 4. Calculate the Reynolds Number for 6-inch (diameter) production tubing assuming West Texas Crude…

A: Since; Q1 = 500 STB / day = 5005.434 * 105=9.20*10-4 m3 /s

Q: 3. A liquid boils when its vapor pressure is equal to a. One atmosphere of pressure b. The gage…

A: As per guidelines we need to answer only first question so please repost rest questions separately.

Q: (c) An analysis of a water sample has produced the following concentrations, as shown in Table 1(c).…

Q: For a solution with a pH equal to 9.5, express the concentrations of H+ and OH- in units of meq/L…

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

The mean indoor airborne chloroform (CHCI)
conc. in a room was detemined to be 0.4 ug/m3.
Use the following data,
T = 293 K, P = 1 atm, R = 82.05 x 10-6 atm-
m3 /mol- K.
Atomic weights:
C = 12, H = 1, CI = 35.5.
%3D
%3D
This concentration expressed in parts per billion
(volume basis, ppbv) is equal to

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

True or False: When comparing two samples of equal mass, the number of particles in each sample is inversely proportional to the size of the particles cubed. Select one: O True O False True or False: PM 10 measurements only account for particulate matter exactly 10 microns in diameter large. Select one: O True O False
2. Families in a community in a developing country use large, 200.0 L drums to un-treated surface water. You are designing a device that is designed to dose the volume with a coagulant, stir to allow flocculation, then add chlorine tablets to disinfect the water. The water is 25 °C and initially contains 1.0E+09 particles per L. The initial particles can be assumed to be spherical, 15.0 micrometers in diameter, and with a density of 1.675 g/mL. a. If the drums have a diameter of 572 mm, how long will it take for the particles to completely settle without any coagulation or flocculation? (answer in seconds) You have determined that you can achieve complete destabilization of particles by achieving an ionic strength of 0.01 M or higher. If you use alum (Al2(SO4)3) as a coagulating agent, what mass of alum must be added per batch of 200 L? (answer in grams) How many joules of energy would be required to stir the drum at a mixing intensity of 150 s-' for 20 minutes? If the drum is stirred…
The one-hour standard for CO is 35 ppm, Calculate the equivalent concentration in mg/m3.
Water quality indicates that the water contains Na* at 50 mg/L, K* at 30 mg/L, Ca2+ at 80 mg/L, and Mg²+ at 65 mg/L (all concentrations are already in mg/L as CACO3). What is the hardness of the water (in mg/L as CaCO3)?
A student weighs out 0.3333 g Na2CO3, dissolves it completely in 30 mL of deionized water, and titrates the resulting solution with 0.100 M HCl. Calculate the equivalence point volume expected for the complete titration of the Na2CO3. (Formula weights: Na2CO3 = 105.99 g/mole; HCl = 36.46 g/mole) A) 15.7 mL B) 31.4 mL C) 62.9 mL D) 114 mL E) 229 mL
mat assessment 8 number 8
A water sample contains the following dissolved ions: [Na+] = 75 mg/l [HCO]=250 mg/1 [CH] = 100 mg/l [Ca²+] = 45 mg/l [Mg²+] = 48 mg/1 [A1³+] = 5 mg/1 Atomic weight: H = 1; C = 12; O=16; Na = 23, Ca = 40, Mg = 24; Al = 27; CI = 35.5 The total hardness of the sample in mg// as CaCO3 is
An Analysis of water from a surface stream yields the following results Ca+2=60mg/L HCO3-=115mg/L Mg+2=10mg/L SO4-2=96mg/L Na+=7mg/L NO3-=10mg/L K+=20mg/L CI-=11 mg/L If an error of 10 percent is acceptable, should the analysis be considered complete?
What is the molar concentration of 196 mg/L sulfate acid (H2SO4)? Use mol/L or mmol/L as the unit in your final result.
Concentrations of Pb, Cu, and Mn in rainwater collected in Minneapolis were found to be 9.5, 2.0, and 8.6 ug/L, respectively. Express these concentrations as nmale/L.
Provide solution and correct options
5. Determine the effective size and uniformity coefficient of the filter media of which grain size distribution curve is given below. Do you prefer using this media? Why? % passing by weight 100% 90% 80% 70% 60% 50% 40% 30% 20% 10% 0% 0.01 0.1 1 Grain diameter (mm) 10