NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. A piston-cylinder device initially contains 2 kg of refrigerant-134a at 100 kPa and 20°C. Heat is now transferred to the refrigerant from a source at 150°C, and the piston, which is resting on a set of stops, starts moving when the pressure inside reaches 120 kPa. Heat transfer continues until the temperature reaches 80°C. Assume the surroundings to be at 25°C and 100 kPa. R-134a 100 kPa 20°C 150°C

NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. A piston-cylinder device initially contains 2 kg of refrigerant-134a at 100 kPa and 20°C. Heat is now transferred to the refrigerant from a source at 150°C, and the piston, which is resting on a set of stops, starts moving when the pressure inside reaches 120 kPa. Heat transfer continues until the temperature reaches 80°C. Assume the surroundings to be at 25°C and 100 kPa. R-134a 100 kPa 20°C 150°C

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A piston-cylinder device initially contains CO2 at 200 kPa and 400°C and the total enclosed volume is 300 litres. Due to heat loss, the piston moves downwards to a position where it sits on a pair of stoppers and its final enclosed volume is 150 litres. Further heat loss leads to the pressure being reduced to 160kPa. Workout 1) the final temperature, 2) the total work done by CO2 and 3) the total heat transferred to CO2. Also make some comments on the result of heat and create a schematic p-v diagram of the process. The following assumptions are to be made: CO2 is a perfect gas and its molecular mass is 44kg/kmol. The ratio of specific heat capacities, γ (gamma) is 1.3 The volume occupied by the stoppers is to be ignored. There is no leakage in the system There is no friction between the cylinder and piston walls and the piston moved slowly at the same speed therefore, no acceleration. For the conversion from Celsius to Kelvin, use 273 Use 8314.5 J/kmol.K for the universal gas…
NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. An adiabatic air compressor compresses 10.4 L/s of air at 120 kPa and 20°C to 1000 kPa and 300°C. The constant pressure specific heat of air at the average temperature of 160°C = 433 K is cp= 1.018 kJ/kg.K. The gas constant of air is R = 0.287 kPa.m³/kg-K. 1 MPa 300°C Compressor 120 kPa 20°C Vus Determine the work required by the compressor. (You must provide an answer before moving on to the next part.) The work required by the compressor is -4.578 kJ/kg.
Define the work (boundary) done on an adiabatic system is equal to the increase in the energy of the system.
a) A gas is trapped in a piston-cylinder device. The initial pressure and temperature of the gas are 500 kPa and 300 K, respectively. The system undergoes an isothermal expansion process, in which 15KJ of boundary work is done by the gas and 3KJ of paddle-wheel work is done on the gas. Determine the amount heat transfer during this process. Explain the direction of the heat transfer.