Subcooled water at 5°C is pressurised to 350 kPa with no increase in temperature, and then passed through a heat exchanger where it is heated until it reaches saturated liquid-vapour state at a quality of 0.63. If the water absorbs 499 kW of heat from the heat exchanger to reach this state, calculate how many kilogrammes of water flow through the pipe in an hour. Give your answer to one decimal place. Please provide correct solution Don't copypaste in chegg

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A: Given                        Mass, m = 5 kg Initial temperature, T1 = 427oC       Initial pressure,…

Q: It is a hot day in Atlanta and you and your friends bought an ice cream maker. The unit consists of…

A: To obtain the solution of the above question, we will apply the 1st law of thermodynamics and is…

Q: Q6/ Your company produces small power plants that generate electricity by expanding waste process…

A:

Q: The specific volume of nitrogen is 1.9 m3/kg at 200°C. After supplying it with energy in the form of…

A:

Q: A gas inside of a balloon is heated. As a result, its volume increases from 0.15 m3 to 0.4 m3. At…

A: GIVEN DATA INITIAL VOLUME V1=0.15m3 FINAL VOLUME V2=0.4 m3 INITIAL PRESSURE P1=300KPa RELATION GIVEN…

Q: In a process, a closed system receives electric power of 25W, does work at the rate of 40W, receives…

A:

Q: A dividing wall divides an insulated container into two compartments as shown in the figure.…

A:

Q: A 0.1 kg of ice at 0 degrees Celsius is heated until half of it becomes water at 100 degrees Celsius…

A: To find: The total amount of heat required to accomplish this Given: The mass of ice is m=0.1 kg.…

Q: Refrigerant 134a is stored inside an uninsulated rigid tank (see figure below) and heated by an…

A:

Q: A 5-hp pump compressor delivers oxygen at a rate of 30 cubic feet per minute. The pressure and…

A: Given data: Power consumed by compressor = 5 hp = 3.73 KW                     Discharge rate = 30…

Q: Two kilograms of water is contained in a piston-cylinder device where a linear spring is attached to…

A:

Q: The temperature of 1.9 kg of water is 100.0°C, but the water is not boiling, because the external…

A:

Q: The instruction booklet for your pressure cooker indicates that its highest setting is 11.3 psipsi .…

A:

Q: Question #4 A rigid tank with a volume of 2-m³ initially contains air at 100 kPa and 30 °C. The tank…

A: To Find : The entropy generation Given : The volume of the tank is The initial pressure of the air…

Q: How much work is done when 10 cubic meter of an air is initially at a pressure of 1 atm and a…

A: Given data: V=10 m3P1=1 atmT1=0°FP2=6 atm Need to determine the work is done.

Q: A tank of air is expanded via heat transfer at a constant pressure such that its volume is 2.5 times…

A:

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.