Liquid Partitioning with Separatory FunnelA student carried out the following procedures in a laboratory work. 1) Water was shakenwith ether in a separatory funnel, the two liquids separated into two phases. 2) Thestudent shook water and methylene chloride (dichloromethane) in another separatoryfunnel, again the mixture separated into two phases. In the space provided below:a) Sketch the separatory funnels showing the two phases of the mixtures in procedures 1and 2. (b) Label each funnel with the experimental process (i.e. ether-water or methylenechloride-water).c) Label the two phases in each funnel with the identity of the liquid.d) Explain the reason for differences in phases of the two experiments.flask)

Answered: Image /qna-images/answer/965fccdc-c82f-4e91-81d7-da830a161a17.jpg

Answered: Liquid Partitioning with Separatory…

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter5: Distillation

Section: Chapter Questions

Problem 4Q

See similar textbooks

Similar questions

Is there any example of liquid liquid phase separation of homogeneous mixture in our daily life?
Pure potassium hydrogen phthalate is used for the standardization of the sodium hydroxide solution. Suppose that the potassium hydrogen phthalate is not completely dry. Will the reported molar concentration of the sodium hydroxide solution be too high, too low, or unaffected because of the moistness of the potassium hydrogen phthalate? Explain.
Window Help of Liquids Solids.pdf 10 Date Section Name Post-Laboratory Questions (Use the spaces provided for the answers and additional paper if necessary.) 1. The density of ice at 0°C is 0.9168 g mL, and that of liquid water at 0°C is 0.9999 g mL-. (1) What are the volumes of 1.000 g of ice and of 1.000 g of water at 0°C? SEP étv 21 DII DD F10 F9 F7 F8 F5 F6 F3 F4 0/ &
For a successful crystallization the following conditions are desired? Agitated vessel O Cold solvent O Stationary (still) vessel O Slow crystal growth Warm solvent Fast solid formation (precipitation)
PAPER CROMATOGRAPHY • Define chromatography • Demonstrate an understanding of the process of chromatography • Describe the steps involved in a chromatography investigation Explanation Coloured inks are often made up of several different inks. Each colour of ink will get carried a different distance by the water, allowing you to see all of the different inks. Try this with different colours to see what actually goes into a colour. This technique is called chromatography and can be used in chemistry to find out what is in an unknown mixture. II. Materials .Felt tip pens (non-washable) . Kitchen roll .A bowl or cup . Water • Scissors III. Health and safety • Make sure that you thoroughly clean any equipment after the experiment before using for food IV. Procedure Method 1 1. Take a sheet of kitchen roll and draw a simple picture with a non-washable felt tip pen. 2. Place the sheet over an empty bowl. This is to keep the paper from getting too wet. 3. Carefully add a few drops of water…
1:44 PM 169% Constant No relationship Describing the relationship between the melting time for an ice cube and amount of salt sprinkled on the cube by writing about it or by constructing a graph, is an example of Communicating Inferring Hypothesizing Observing After observing the melting rates of an ice cube sprinkled with salt and one without salt, concluding that salt reduces the freezing point of water, is an example of Inferring Hypothesizing Observing Predicting
To prepare 5 ml of an eyedrop solution to 10 cps by mixing glycine and water,,................ml of glycerin is needed.(pure glycerin viscosity 500 cps, water viscosity 1cps).
A student obtained a solid product in laboratory synthesis. To verify the identity of the solid, she measured the milting point and found that the material melted over a 12°C range. After it had cooled, she measured the melting point of the same sample again and found that this time the solid HUD a sharp melting point at the temperature that is characteristic of the desired product Why were the two melting points different? What was responsible for the change in the melting point?
A 1.59g sample containning KI was analyzed gravimetrically and .0538g of barium iodate was recovered. Express the results of this analysis as percent potassium iodide.
What limitations are encountered in the apolication of sublimation as a general method of purification?
A 1.59 g sample containing KI was analyzed gravimetrically and 0.0538g of Barium Iodate was recovered... express the results of this analysis as percent posassium iodide.
Hi! This is a set of three multiple choice questions. Hope you can answer them all. Thank u~

SEE MORE QUESTIONS

Recommended textbooks for you

Macroscale and Microscale Organic Experiments

Chemistry

ISBN:

9781305577190

Author:

Kenneth L. Williamson, Katherine M. Masters

Publisher:

Brooks Cole

Physical Chemistry

Chemistry

ISBN:

9781133958437

Author:

Ball, David W. (david Warren), BAER, Tomas

Publisher:

Wadsworth Cengage Learning,

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

Macroscale and Microscale Organic Experiments

Chemistry

ISBN:

9781305577190

Author:

Kenneth L. Williamson, Katherine M. Masters

Publisher:

Brooks Cole

Physical Chemistry

Chemistry

ISBN:

9781133958437

Author:

Ball, David W. (david Warren), BAER, Tomas

Publisher:

Wadsworth Cengage Learning,

Fundamentals Of Analytical Chemistry

Chemistry

ISBN:

9781285640686

Author:

Skoog

Publisher:

Cengage

EBK A SMALL SCALE APPROACH TO ORGANIC L

Chemistry

ISBN:

9781305446021

Author:

Lampman

Publisher:

CENGAGE LEARNING - CONSIGNMENT

Chemistry

ISBN:

9781305957404

Author:

Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:

Cengage Learning

Chemistry: An Atoms First Approach

Chemistry

ISBN:

9781305079243

Author:

Steven S. Zumdahl, Susan A. Zumdahl

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS